Three-Dimensional Large Deformation FE Analysis of Square Footings in Two-Layered Clays
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 137, Issue 1
Abstract
In strong over soft two-layered clays, there is a potential for the footing to experience a punch-through failure, where the footing penetrates a large distance at a short time after the initial peak resistance is reached. Three-dimensional (3D) large deformation finite-element analyses using 3D RITSS method were conducted to simulate the penetration responses of square footings in strong over soft clays. The effects of surface soil heave and soil layer interface deformation during footing penetration were studied in weightless soils. Fitted equations were proposed to express the footing capacity response against the penetration depth. Based on the fitted equations, formulas to calculate footing peak bearing factor and the corresponding penetration depth were developed. The peak footing capacity factor and the corresponding penetration depth increases with the increasing of soil layer strength ratio, relative top soil layer thickness and soil weight factor, thus the potential of punch-through failure was reduced accordingly. It was also found that the soil weight effect can be a simple surcharge based on the formula developed in the weightless soil. Design charts for the peak footing capacity factor and the corresponding penetration depth were developed.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers thank Professor D. V. Griffiths and the anonymous reviewers for their insightful suggestions in improving this study. This study is supported by the National Natural Science Foundation of China (Grant Nos. NNSFC50978045 and NNSFC90815024) and the Australian Research Council (ARC) Discovery Projects Proposals (Grant No. UNSPECIFIEDDP1096764). These supports are gratefully acknowledged.
References
Bennett, R. H., et al. (1984). “Geotechnical and geological factors affecting offshore engineering and seabed utilization on a carbonate margin: ST. CROIX, V. I.” ASME J. Energy Resour. Technol., 106(1), 120–129.
Brown, J. D., and Meyerhof, G. G. (1969). “Experimental study of bearing capacity in layered clays.” Proc., 7th Int. Conf. on Soil Mechanics and Foundation Eng.
Burd, H. J., and Frydman, S. (1997). “Bearing capacity of plane-strain footings on layered soils.” Can. Geotech. J., 34(2), 241–253.
Carter, J. P., and Balaam, N. P. (1995). AFENA users’ manual, Geotechnical Research Center, Univ. of Sydney, Sydney, Australia.
Chen, W. F., and Davidson, H. L. (1973). “Bearing capacity determination by limit analysis.” J. Soil Mech. and Found. Div., 99(SM6), 433–449.
Cox, A. D., Eason, G., and Hopkins, H. G. (1961). “Axially symmetric plastic deformation in soils.” Philos. Trans. R. Soc. London, 254, 1–45.
Florkiewicz, A. (1989). “Upper bound to bearing capacity of layered soils.” Can. Geotech. J., 26(4), 730–736.
Georgiadis, M., and Michalopoulos, A. P. (1985). “Bearing capacity of gravity bases on layered soil.” J. Geotech. Eng., 111(6), 712–729.
Goss, C. M. and Griffiths, D. V. (2001). “Discussion on ‘Rigorous plasticity solutions for the bearing capacity of two-layered clays’ by Merifield R. S. et al.” Geotechnique 51(2), 179–183.
Gourvenec, S., Randolph, M., and Kingsnorth, O. (2006). “Undrained bearing capacity of square and rectangular footings.” Int. J. Geomech., 6(3), 147–157.
Herrmann, L. R. (1978). “Finite element analysis of contact problems.” J. Eng. Mech. Div., 104(5), 1043–1057.
Hossain, M. S., Hu, Y., Randolph, M. F., and White, D. J. (2005a). “Limiting cavity depth for spudcan foundations penetrating clay.” Geotechnique, 55(9), 679–690.
Hossain, M. S., Hu, Y., Randolph, M. F., and White, D. J. (2005b). “Punch-through of spudcan foundations in two-layer clay.” Proc., Int. Symp. on Frontiers in Offshore Geotechnics, Balkema, The Netherlands, 535–541.
Hu, Y., and Randolph, M. F. (1998a). “Deep penetration of shallow foundations on non-homogeneous soil.” Soils Found., 38(1), 241–246.
Hu, Y., and Randolph, M. F. (1998b). “H-adaptive FE analysis of elasto-plastic non-homogeneous soil with large deformation.” Comput. Geotech., 23(1–2), 61–83.
Hu, Y., and Randolph, M. F. (1998c). “A practical numerical approach for large deformation problems in soil.” Int. J. Numer. Analyt. Meth. Geomech., 22(5), 327–350.
Liu, J., Hu, Y. X., and Kong, X. J. (2005). “Deep penetration of spudcan foundation into double layered soils.” China Ocean Eng., 19(2), 309–324.
Lu, Q., Randolph, M. F., Hu, Y., and Bugarski, I. C. (2004). “A numerical study of cone penetration in clay.” Geotechnique, 54(4), 257–267.
McClelland, B., Young, A. G., and Remmes, B. D. (1981). “Avoiding jack-up rig foundation failures.” Proc., Symp. Geotechnical Aspects of Coastal and Offshore Structure.
Merifield, R. S., Sloan, S. W., and Yu, H. S. (1999). “Rigorous plasticity solutions for the bearing capacity of two-layered clays.” Geotechnique, 49(4), 471–490.
Meyerhof, G. G. (1974). “Ultimate bearing capacity of footings on sand layer overlying clay.” Can. Geotech. J., 11(2), 223–229.
Meyerhof, G. G., and Hanna, A. M. (1978). “Ultimate bearing capacity of foundations on layered soils under inclined load.” Can. Geotech. J., 15(4), 565–572.
Michalowski, R. L., and Shi, L. (1995). “Bearing capacity of footings over two-layer foundation soils.” J. Geotech. Eng., 121(5), 421–428.
Reddy, A. S., and Srinivasan, R. J. (1967). “Bearing capacity of footings on layered clays.” J. Soil Mech. and Found. Div., 93(2), 83–99.
Salgado, R., Lyamin, A. V., Sloan, S. W., and Yu, H. S. (2004). “Two- and three-dimensional bearing capacity of foundations in clay.” Geotechnique, 54(5), 297–306.
Sloan, S. W., and Booker, J. R. (1986). “Removal of singularities in tresca and mohr-coulomb yield functions.” Commun. Appl. Numer. Methods, 2(2), 173–179.
Thorne, C. P., Wang, C. X., and Carter, J. P. (2004). “Uplift capacity of rapidly loaded strip anchors in uniform strength clay.” Geotechnique, 54(8), 507–517.
Wang, C. X., and Carter, J. P. (2002). “Deep penetration of strip and circular footings into layered clays.” Int. J. Geomech., 2(2), 205–232.
Young, A. G., Remmes, B. D., and Meyer, B. J. (1984). “Foundation performance of offshore jack-up drilling rigs.” J. Geotech. Eng., 110(7), 841–859.
Yu, L., Liu, J., Kong, X. J., and Hu, Y. (2008). “Three-dimensional RITSS large displacement finite element method for penetration of foundations into soil.” Comput. Geotech., 35(3), 372–382.
Zhu, M., and Michalowski, R. L. (2005). “Bearing capacity of rectangular footings on two-layer clay.” Proc., 16th Int. Conf. on Soil Mech. and Geotech. Eng.: Geotechnology in Harmony with the Global Environment, Vols. 1–5, 997–1000.
Information & Authors
Information
Published In
Copyright
© 2011 ASCE.
History
Received: Jun 18, 2009
Accepted: Jun 4, 2010
Published online: Jun 9, 2010
Published in print: Jan 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.