Centrifuge Permeameter for Unsaturated Soils. II: Measurement of the Hydraulic Characteristics of an Unsaturated Clay
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 136, Issue 8
Abstract
This paper presents the hydraulic characteristics of an unsaturated, compacted clay, including its soil-water retention curve (SWRC) and hydraulic conductivity function ( function), determined using a new centrifuge permeameter developed at the University of Texas at Austin. A companion paper describes the apparatus, its instrumentation layout, and data reduction procedures. Three approaches are evaluated in this study to define the SWRC and function of the compacted clay under both drying and wetting paths, by varying the inflow rate, the level, or both. For imposed inflow rates ranging from 20 to 0.1 mL/h and levels ranging from 10 to 100 g, the measured matric suction ranged from 5 to 70 kPa, the average volumetric water content ranged from 23 to 33%, and the hydraulic conductivity ranged from to . The SWRCs and functions obtained using the three different testing approaches were very consistent, and yielded suitable information for direct determination of the hydraulic characteristics. The approaches differed in the time required to complete a testing stage and in the range of measured hydraulic conductivity values. The level had a negligible effect on the measured hydraulic characteristics of the compacted clay. The SWRCs and functions defined using the centrifuge permeameter are consistent with those obtained using pressure chamber and column infiltration tests. The functions defined using the centrifuge permeameter follow the same shape as those obtained from predictive relationships, although the measured and predicted functions differ by two orders of magnitude at the lower end of the volumetric water content range.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
Support received from the National Science Foundation under Grant No. NSFCMS-0401488 is gratefully appreciated.
References
ASTM. (2000). “Standard test method for determining unsaturated and saturated hydraulic conductivity in porous media by steady-state centrifugation.” ASTM D6527, West Conshohoken, Pa.
ASTM. (2001). “Standard test methods for determination of the soil water characteristic curve for desorption using a hanging column, pressure extractor, chilled mirror hygrometer, and/or centrifuge.” ASTM D6836, West Conshohocken, Pa.
Cargill, K. W., and Ko, H. -Y. (1983). “Centrifugal modeling of transient water flow.” J. Geotech. Engrg., 109(4), 536– 555.
Conca, J., and Wright, J. (1992). “Diffusion and flow in gravel, soil, and whole rock.” Applied Hydrogeology, 1, 5– 24.
Dell’Avanzi, E., Zornberg, J. G., and Cabral, A. (2004). “Suction profiles and scale factors for unsaturated flow under increased gravitational field.” Soil Found., 44(3), 1– 11.
Gardner, W. (1958). “Some steady-state solutions of the unsaturated moisture flow equation with applications to evaporation from a water table.” Soil Sci., 85, 228– 232.
Khaleel, R., Relyea, J., and Conca, J. (1995). “Evaluation of van Genuchten-Mualem relationships to estimate unsaturated hydraulic conductivity at low water contents.” Water Resour. Res., 31(11), 2659– 2668.
McCartney, J. S. (2007). “Determination of the hydraulic characteristics of unsaturated soils using a centrifuge permeameter.” Ph.D. dissertation, Univ. of Texas at Austin, Austin, Tex.
McCartney, J. S., Villar, L., and Zornberg, J. G. (2007). “Estimation of the hydraulic conductivity function of an unsaturated clay using an infiltration column test.” Proc., 6th Brazilian Conference on Unsaturated Soils (NSAT), UFBA, Salvador, Bahia, Brazil.
McCartney, J. S. and Zornberg, J. G. (2007). “Effect of wet-dry cycles on capillary break formation in geosynthetic drainage layers.” Geosynthetics 2007, Washington, D.C.
Nimmo, J., Rubin, J., and Hammermeister, D. (1987). “Unsaturated flow in a centrifugal field: Measurement of hydraulic conductivity and testing of Darcy’s law.” Water Resour. Res., 23(1), 124– 134.
Olson, R., and Daniel, D. (1981). “Measurement of the hydraulic conductivity of fine grained soils.” Permeability and groundwater contaminant transport, ASTM STP746, T. F. Zimmie and C. O. Riggs, eds., ASTM, West Conshohoken, Pa., 18– 64.
Topp, G. C., and Miller, E. E. (1966). “Hysteretic moisture characteristics and hydraulic conductivities for glass-bead media.” Soil Sci. Soc. Am. J., 30, 156– 162.
van Genuchten, M. (1980). “A closed-form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. J., 44, 892– 898.
Zornberg, J. G., and McCartney, J. S. (2010). “Centrifuge permeameter for unsaturated soils. I: Theoretical basis and experimental developments.” J. Geotech. Geoenviron. Eng., 136(8), 1051– 1063.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Dec 24, 2008
Accepted: Dec 24, 2009
Published online: Jan 8, 2010
Published in print: Aug 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.