High-Pressure Isotropic Compression Tests on Fiber-Reinforced Cemented Sand
Publication: Journal of Geotechnical and Geoenvironmental Engineering
Volume 136, Issue 6
Abstract
High-pressure isotropic compression tests were carried out on reconstituted sand samples that were reinforced with cement, randomly distributed fibers, or both, making comparisons with the unreinforced sand and conducting tests from a variety of initial specific volumes. The results indicated changes in the isotropic compression behavior of the sand due to the inclusion of fibers and/or cement. Cementitious bonds are sufficiently strong relative to the particles to allow the cemented samples to reach states outside the normal compression line (NCL) of the uncemented soil, but the effectiveness of cemented fiber-reinforced specimens is even larger due to the control of crack propagation in the cemented sand after the inclusion of fibers. Distinct NCLs were observed for the sand, fiber-reinforced sand, cemented sand, and fiber-reinforced cemented sand. Both fiber breakage and fiber extension were observed in fibers measured after testing indicating that fibers individually have worked under tension, even though in the macroscopic scale, isotropic compressive stresses were applied. Fiber reinforcement was found to reduce the particle breakage of both the uncemented and cemented sands.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The writers wish to express their gratitude to MCT-CNPq (Projects PNPD Grant No. UNSPECIFIED558474/2008-0, Produtividade em Pesquisa Grant No. UNSPECIFIED301869/2007-3, Edital Universal Grant No. UNSPECIFIED472851/2008-0, and INCT) for the financial support to the research group. The writers would like to thank the anonymous reviewers for their insightful comments and suggestions that improved the content of this technical note.
References
Consoli, N. C., Casagrande, M. D. T., and Coop, M. R. (2005). “Effect of fiber reinforcement on the isotropic compression behavior of a sand.” J. Geotech. Geoenviron. Eng., 131(11), 1434–1436.
Consoli, N. C., Casagrande, M. D. T., and Coop, M. R. (2007a). “Performance of fibre-reinforced sand at large shear strains.” Geotechnique, 57(9), 751–756.
Consoli, N. C., Casagrande, M. D. T., Prietto, P. D. M., and Thomé, A. (2003a). “Plate load test on fiber-reinforced soil.” J. Geotech. Geoenviron. Eng., 129(10), 951–955.
Consoli, N. C., Casagrande, M. D. T., Thomé, A., Dalla Rosa, F., and Fahey, M. (2009a). “Effect of relative density on plate loading tests on fibre-reinforced sand.” Geotechnique, 59(5), 471–476.
Consoli, N. C., Festugato, L., and Heineck, K. S. (2009b). “Strain-hardening behaviour of fibre-reinforced sand in view of filament geometry.” Geosynthet. Int., 16(2), 109–115.
Consoli, N. C., Heineck, K. S., Casagrande, M. D. T., and Coop, M. R. (2007b). “Shear strength behavior of fiber-reinforced sand considering triaxial tests under distinct stress paths.” J. Geotech. Geoenviron. Eng., 133(11), 1466–1469.
Consoli, N. C., Rotta, G. V., and Prietto, P. D. M. (2006). “Yielding-compressibility-strength relationship for an artificially cemented soil cured under stress.” Geotechnique, 56(1), 69–72.
Consoli, N. C., Vendruscolo, M. A., Fonini, A., and Dalla Rosa, F. (2009c). “Fiber reinforcement effects on sand considering a wide cementation range.” Geotext. Geomembr., 27(3), 196–203.
Consoli, N. C., Vendruscolo, M. A., and Prietto, P. D. M. (2003b). “Behavior of plate load tests on soil layers improved with cement and fiber.” J. Geotech. Geoenviron. Eng., 129(1), 96–101.
Coop, M. R. (1999). “The influence of in situ state on the behaviour of carbonate sands.” Engineering for Calcareous Sediments (Proc., 2nd Int. Conf. on Calcareous Soils, Bahrain), K. A. Al-Shafei, ed., Balkema, Rotterdam, The Netherlands, 379–400.
Coop, M. R., and Atkinson, J. H. (1993). “The mechanics of cemented carbonate sands.” Geotechnique, 43(1), 53–67.
Coop, M. R., and Lee, I. K. (1993). “The behaviour of granular soils at elevated stresses.” Predictive soil mechanics, Thomas Telford, London, 186–198.
Crockford, W. W., Grogan, W. P., and Chill, D. S. (1993). “Strength and life of stabilized pavement layers containing fibrillated polypropylene.” Transportation Research Record. 1418, Transportation Research Board, Washington, D.C.
Cuccovillo, T., and Coop, M. R. (1997). “The measurement of local axial strains in triaxial tests using LVDTs.” Geotechnique, 47(1), 167–171.
Cuccovillo, T., and Coop, M. R. (1999). “An automated triaxial apparatus for elevated pressures.” Proc., ASTM Symp., STP 1350: Non-Destructive and Automated Testing for Soil and Rock Properties, W. A. Marr and C. E. Fairhurst, eds., ASTM, West Conshohocken, Pa., 231–246.
Gray, D. H., and Al-Refeai, T. (1986). “Behavior of fabric versus fiber-reinforced sand.” J. Geotech. Engrg., 112(8), 804–820.
Gray, D. H., and Ohashi, H. (1983). “Mechanics of fiber reinforcement in sand.” J. Geotech. Engrg., 109(3), 335–353.
Heineck, K. S., Coop, M. R., and Consoli, N. C. (2005). “Effect of micro-reinforcement of soils from very small to large shear strains.” J. Geotech. Geoenviron. Eng., 131(8), 1024–1033.
Ladd, R. S. (1978). “Preparing test specimens using undercompaction.” Geotech. Test. J., 1(1), 16–23.
Lagioia, R., and Nova, R. (1995). “An experimental and theoretical study of the behaviour of a calcarenite in triaxial compression.” Geotechnique, 45(4), 633–648.
Ling, H. I., and Tatsuoka, F. (1994). “Performance of anisotropic geosynthetic reinforced cohesive soil mass.” J. Geotech. Engrg., 120(7), 1166–1184.
Maher, M. H., and Gray, D. H. (1990). “Static response of sands reinforced with randomly distributed fibers.” J. Geotech. Engrg., 116(11), 1661–1677.
McDowell, G. R., and Bolton, M. D. (1998). “On the micro mechanics of crushable aggregates.” Geotechnique, 48(5), 667–679.
Michalowski, R. L., and Cermák, J. (2003). “Triaxial compression of sand reinforced with fibers.” J. Geotech. Geoenviron. Eng., 129(2), 125–136.
Pestana, J. M., and Whittle, A. J. (1995). “A compression model for cohesionless soils.” Geotechnique, 45(4), 611–631.
Rotta, G. V., Consoli, N. C., Prietto, P. D. M., Coop, M. R., and Graham, J. (2003). “Isotropic yielding in an artificially cemented soil cured under stress.” Geotechnique, 53(5), 493–502.
Santoni, R. L., Tingle, J. S., and Webster, S. L. (2001b). “Engineering properties of sand-fiber mixtures for road construction.” J. Geotech. Geoenviron. Eng., 127(3), 258–268.
Santoni, R. L., and Webster, S. L. (2001a). “Engineering properties of sand-fiber mixtures for road construction.” J. Transp. Eng., 127(2), 96–104.
Tingle, J. S., Santoni, R. L., and Webster, S. L. (2002). “Airfields and roads construction using fiber stabilization of sands.” J. Transp. Eng., 128(1), 9–16.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Sep 30, 2008
Accepted: Nov 28, 2009
Published online: Dec 4, 2009
Published in print: Jun 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.