New Perspective on Seismic Slope Stability Analysis
This article has a reply.
VIEW THE REPLYPublication: International Journal of Geomechanics
Volume 18, Issue 7
Abstract
This article proposes a graphical method associated with the g line to evaluate seismic slope stability. The g line depicts the combinations of c/γH and tanφ that are necessary to maintain slope stability at the critical limit state. Correlations of c/γH and tanφ are established based on the work-rate balance equation. Under a kinematic analysis, the pseudostatic upper-bound solution of c/γH is sought with an optimization procedure. After having determined the g line, the factor of safety for a specific slope can be easily estimated without the need for iterative calculations. For ease of practical use, a set of stability charts is presented. This approach also permits determination of the critical failure mode, including toe or below the toe.
Get full access to this article
View all available purchase options and get full access to this article.
References
Chen, W. F. (1975). Limit analysis and soil plasticity, Elsevier, Amsterdam, Netherlands.
Chen, W. F., and Liu, X. L. (1990). Limit analysis in soil mechanics, Elsevier, Amsterdam, Netherlands.
Collins, I. F., Gunn, C. I. M., Pender, M. J., and Yan, W. (1988). “Slope stability analyses for materials with a nonlinear failure envelope.” Int. J. Numer. Anal. Methods Geomech., 12(6), 533–550.
Duncan, J. M., and Wright, S. G. (1980). “The accuracy of equilibrium methods of slope stability analysis.” Eng. Geol., 16(1–2), 5–17.
Jiang, J. C., and Yamagami, T. (2006). “Charts for estimating strength parameters from slips in homogeneous slopes.” Comput. Geotech., 33(6–7), 294–304.
Klar, A., Aharonov, E., Kalderon-Asael, B., and Katz, O. (2011). “Analytical and observational relations between landslide volume and surface area.” J. Geophys. Res. Earth Surf., 116(2), 1–10.
Michalowski, R. L. (1995). “Slope stability analysis: A kinematical approach.” Géotechnique, 45(2), 283–293.
Michalowski, R. L. (2002). “Stability charts for uniform slopes.” J. Geotech. Geoenviron. Eng., 128(4), 351–355.
Michalowski, R. L. (2010). “Limit analysis and stability charts for 3D slope failures.” J. Geotech. Geoenviron. Eng., 583–593.
Michalowski, R. L., and Martel, T. (2011). “Stability charts for 3D failures of steep slopes subjected to seismic excitation.” J. Geotech. Geoenviron. Eng., 183–189.
Pan, Q. J., Xu, J. S., and Dias, D. (2017). “Three-dimensional stability of a slope subjected to seepage forces.” Int. J. Geomech., 04017035.
PLAXIS 2D [Computer software]. Plaxis bv, Delft, Netherlands.
Qin, C. B., and Chian, S. C. (2017a). “Kinematic stability of a two-stage slope in layered soils.” Int. J. Geomech., 06017006.
Qin, C. B., and Chian, S. C. (2017b). “Kinematic analysis of seismic slope stability with a discretization technique and pseudo-dynamic approach: A new perspective.” Géotechnique. 10.1680/jgeot.16.P.200.
Qin, C. B., Chian, S. C., and Wang, C. Y. (2017). “Kinematic analysis of pile behavior for improvement of slope stability in fractured and saturated Hoek–Brown rock masses.” Int. J. Numer. Anal. Methods Geomech., 41(6), 803–827.
Sun, J. P., and Zhao, Z. Y. (2013). “Stability charts for homogenous soil slopes.” J. Geotech. Geoenviron. Eng., 2212–2218.
Taylor, D. W. (1948). Fundamentals of soil mechanics, Wiley, New York.
Tsai, C. C., and Chien, Y. C. (2015). “A simple procedure to directly estimate yield acceleration for seismic slope stability assessment.” Jpn. Geotech. Soc. Spec. Publ., 2(25), 915–919.
Xu, X. L., Li, J. L., Gong, J. W., Deng, H. F., and Wan, L. P. (2016). “Copula-based slope reliability analysis using the failure domain defined by the g-line.” Math. Probl. Eng., 1–11.
Yang, X. L., Li, L., and Yin, J. H. (2004a). “Seismic and static stability analysis for rock slopes by a kinematical approach.” Géotechnique, 54(8), 543–549.
Yang, X. L., Li, L., and Yin, J. H. (2004b). “Stability analysis of rock slopes with a modified Hoek–Brown failure criterion.” Int. J. Numer. Anal. Methods Geomech., 28(2), 181–190.
Information & Authors
Information
Published In
Copyright
© 2018 American Society of Civil Engineers.
History
Received: Aug 28, 2017
Accepted: Dec 20, 2017
Published online: Apr 25, 2018
Published in print: Jul 1, 2018
Discussion open until: Sep 25, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.