Impact of Plastic Compression on the Small Strain Shear Modulus of Unsaturated Silts
Publication: International Journal of Geomechanics
Volume 18, Issue 2
Abstract
This article presents an experimental laboratory study on the effect of plastic compression and stress history on the small strain shear modulus, Gmax, of unsaturated soils. In previous studies, most of the experiments for the measurement of the Gmax values of unsaturated soils were performed along the elastic unloading–reloading curve of the compression curve, and the effect of plastic compression on the measured Gmax was ignored. This research aimed to provide a set of high-quality Gmax data along elastoplastic paths of the compression curve that can be used to further investigate this effect. In this study, a bender element system was used to measure Gmax values under different matric suctions and mean net stresses, the axis translation technique was implemented for suction control, and high values of confining pressure were applied using a high-pressure hydraulic pump. A digital image processing (DIP) method was also used to measure changes in the soil specimen’s volume during loading. Experimental results showed an increase in the small strain shear modulus during loading, with trends that follow transitions in the shape of the curve for void ratio versus mean effective stress. During unloading, the values of unsaturated small strain shear modulus were observed to decrease with a mean net stress decrease while being consistently higher than those measured during loading at the same stress levels. This study also highlighted the effects that hydraulic hysteresis and the initial loading conditions might have on the values of Gmax measured during loading and unloading. Finally, the Gmax values measured in this study were used to evaluate the accuracy of an existing model in predicting the small strain shear modulus of unsaturated soils along elastoplastic paths of the compression curve.
Get full access to this article
View all available purchase options and get full access to this article.
References
Alsherif, N. A., and McCartney, J. S. (2014). “Effective stress in unsaturated silt at low degrees of saturation.” Vadose Zone J.,13(5).
ASTM. (2000). “Standard practice for description and identification of soils (visual-manual procedure).” ASTM D2488-00,West Conshohocken, PA.
Bicalho, K. V., Znidarcic, D., and Fleureau, J.-M. (2007). “Determination of water hydraulic conductivity functions of unsaturated soils.” Proc., 3rd Asian Conf. on Unsaturated Soils,Science Press,Beijing.
Cabarkapa, Z., Cuccovillo, T., and Gunn, M. (1999). “Some aspects of the pre-failure behaviour of unsaturated soil.” Proc., 2nd Int. Symp. on Pre-failure Deformation Characteristics of Geomaterials, Vol.1,A. A. Balkema,Rotterdam, Netherlands, 159–165.
Clayton, C. R. I., Theron, M., and Best, A. I. (2004). “The measurement of vertical shear-wave velocity using side-mounted bender elements in the triaxial apparatus.” Géotechnique,54(7), 495–498.
Dean, A. M., and Voss, D. (1999). “Design with one source of variation.” Design and analysis of experiments,Springer,New York, 33–66.
Fereshtehnejad, E., and Shafieezadeh, A. (2017). “A randomized point-based value iteration POMDP enhanced with a counting process technique for optimal management of multi-state multi-element systems.” Struct. Saf.,65, 113–125.
Garakani, A. A., Haeri, S. M., Khosravi, A., and Habibagahi, G. (2015). “Hydro-mechanical behavior of undisturbed collapsible loessial soils under different stress state conditions.” Eng. Geol.,195, 28–41.
Hardin, B. O. (1978). “The nature of stress strain behavior of soils.” Proc., Conf. on Earthquake Engineering and Soil Dynamics,ASCE,Reston, VA, 3–90.
Hilf, J. W. (1956). “An investigation of pore-water pressure in compacted cohesive soils.” Ph.D. thesis,Dept. of Civil Engineering, Univ. of Colorado,Denver, CO.
Hoyos, L. R., Suescun, E. A., and Puppala, A. J. (2011). “Small-strain stiffness of unsaturated soils using a suction-controlled resonant column device with bender elements.” Proc. Geo-Frontiers 2011,ASCE,Reston, VA, 4313–4322.
Hoyos, L. R., Suescún-Florez, E. A., and Puppala, A. J. (2015). “Stiffness of intermediate unsaturated soil from simultaneous suction-controlled resonant column and bender element testing.” Eng. Geol.,188, 10–28.
Khalili, N., and Zargarbashi, S. (2010). “Influence of hydraulic hysteresis on effective stress in unsaturated soils.” Géotechnique,60(9), 729–734.
Khosravi, A., Gheibi, A., Rahimi, M., McCartney, J. S., and Haeri, S. M. (2016a). “Impact of void ratio and state parameters on the small strain shear modulus of unsaturated soils.” Jap. Geotech. Soc. Spec. Publ.,2(4), 241–246.
Khosravi, A., and McCartney, J. S. (2011). “Resonant column test for unsaturated soils with suction–saturation control.” Geotech. Test. J.,34(6), 730–739.
Khosravi, A., and McCartney, J. S. (2012). “Impact of hydraulic hysteresis on the small-strain shear modulus of low plasicity soils.” J. Geotech. Geoenviron. Eng., 1326–1333.
Khosravi, A., Rahimi, M., Shahbazan, P., Pak, A., and Gheibi, A. (2016b). “Characterizing the variation of small strain shear modulus for silt and sand during hydraulic hysteresis.” Proc., 3rd European Conf. on Unsaturated Soils,EDP Sciences,Les Ulis, France, 1–6.
Khosravi, A., Salam, S., McCartney, J. S., and Dadashi, A. (2016c). “Suction-induced hardening effects on the shear modulus of unsaturated silt.” Int. J. Geomech.,16(6), D4016007.
Kumar, J., and Madhusudhan, B. N. (2012). “Dynamic properties of sand from dry to fully saturated states.” Géoechnique,62(1), 45–54.
Ladd, R. S. (1978). “Preparing test specimens using undercompaction.” Geotech. Test. J.,1(1), 16–23.
Lee, J.-S., and Santamarina, J. C. (2005). “Bender elements: Performance and signal interpretation.” J. Geotech. Geoenviron. Eng., 1063–1070.
Lu, N., Godt, J. W., and Wu, D. T. (2010). “A closed-form equation for effective stress in unsaturated soil.” Water Resour. Res.,46(5), 1–14.
Lu, N., and Likos, W. J. (2006). “Suction stress characteristic curve for unsaturated soil.” J. Geotech. Geoenviron. Eng., 131–142.
Macari, E., Parker, J., and Costes, N. (1997). “Measurement of volume changes in triaxial tests using digital imaging techniques.” Geotech. Testing J.,20(1), 103–109.
Mancuso, C., Vassallo, R., and d’Onofrio, A. (2002). “Small strain behavior of a silty sand in controlled-suction resonant column torsional shear tests.” Can. Geotech. J.,39(1), 22–31.
Marinho, F. A. M., Chandler, R. J., and Crilly, M. S. (1995). “Stiffness measurements on an unsaturated high plasticity clay using bender elements.” Proc., 1st Int. Conf. on Unsaturated Soils, Vol.2,A. A. Balkema,Rotterdam, Netherlands, 535–539.
Marinho, F. A. M., Take, W. A., and Tarantino, A. (2008). “Measurement of matric suction using tensiometric and axis translation techniques.” Geotech. Geol. Eng.,26(6), 615–631.
Mendoza, C. E., Colmenares, J. E., and Merchan, V. E. (2005). “Stiffness of an unsaturated compacted clayey soil at very small strains.” Proc., Advanced Experimental Unsaturated Soil Mechanics,A. A. Balkema,Rotterdam, Netherlands, 199–204.
Ng, C. W. W., Xu, J., and Yung, S. Y. (2009). “Effects of wetting-drying and stress ratio on anisotropic stiffness of an unsaturated soil at very small strains.” Can. Geotech. J.,46(9), 1062–1076.
Ng, C. W. W., and Yung, S. Y. (2008). “Determination of the anisotropic shear stiffness of an unsaturated decomposed soil.” Géotechnique,58(1), 23–35.
Ogino, T., Kawaguchi, T., Yamashita, S., and Kawajiri, S. (2015). “Measurement deviations for shear wave velocity of bender element test using time domain, cross-correlation, and frequency domain approaches.” Soils Found.,55(2), 329–342.
Padilla, J. M., Perera, Y. Y., Houston, W. N., Perez, N., and Fredlund, D. G. (2006). “Quantification of air diffusion through high air entry ceramic discs.” Proc., 4th Int. Conf. on Unsaturated Soils,ASCE,Reston, VA, 1852–1863.
Qian, X., Gray, D. H., and Woods, R. D. (1991). “Resonant column tests on partially saturated sands.” Geotech. Testing J.,14(3), 266–275.
Sawangsuriya, A., Edil, T. B., and Bosscher, P. J. (2009). “Modulus-suction-moisture relationship for compacted soils in postcompaction state.” J. Geotech. Geoenviron. Eng., 1390–1403.
Sołowski, W. T., and Sloan, S. W. (2015). “Equivalent stress approach in creation of elastoplastic constitutive models for unsaturated soils.” Int. J. Geomech.,15(2), 04014041.
Stokoe, K. H., Darendeli, M. B., Andrus, R. D., and Brown, L. T. (1999). “Dynamic soil properties: Laboratory, field and correlation studies.” Proc., 2nd Int. Conf. on Earthquake Geotechnical Engineering,A. A. Balkema,Rotterdam, Netherlands, 811–845.
Tamagnini, R. (2004). “An extended Cam-clay model for unsaturated soils with hydraulic hysteresis.” Géotechnique,54(3), 223–228.
Thu, T. M., Rahardjo, H., and Leong, E.-C. (2007). “Elastoplastic model for unsaturated soil with incorporation of the soil-water characteristic curve.” Can. Geotech. J.,44(1), 67–77.
Vassallo, R., Mancuso, C., and Vinale, F. (2007). “Effects of net stress and suction history on the small strain stiffness of a compacted clayey silt.” Can. Geotech. J.,44(4), 447–462.
Wheeler, S. J., Sharma, R. S., and Buisson, M. S. R. (2003). “Coupling of hydraulic hysteresis and stress–strain behaviour in unsaturated soil.” Géotechnique,53(1), 41–54.
Wong, K. S., Mašín, D., and Ng, C. W. W. (2014). “Modelling of shear stiffness of unsaturated fine grained soils at very small strains.” Comput. Geotech.,56, 28–39.
Wu, S., Gray, D. H., and Richart, F. E. Jr. (1984). “Capillary effects on dynamic modulus of sands and silts.” J. Geotech. Eng., 1188–1203.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 18 • Issue 2 • February 2018
Copyright
© 2017 American Society of Civil Engineers.
History
Received: Jun 16, 2016
Accepted: Jul 11, 2017
Published online: Nov 17, 2017
Published in print: Feb 1, 2018
Discussion open until: Apr 17, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.