Wedge-Failure Analysis of the Seismic Slope Using the Pseudodynamic Method
Publication: International Journal of Geomechanics
Volume 17, Issue 12
Abstract
In the past, the pseudostatic method was the most common method used to evaluate stability of the slope under seismic loads. Through the method, static forces acting on the center of gravity of a sliding body are used to consider the effects of an earthquake. However, seismic loads have different geomaterials at different times and locations; therefore, it is not reasonable to apply the pseudostatic approach to solve dynamic problems. In this study, a pseudodynamic method was developed to compute the dynamic factor of safety of the seismic slope. A sinusoidal wave was applied to simulate the effects of an earthquake. The effects of physicomechanical behaviors of geomaterials on the seismic stability of slopes were taken into account as were inertia and damping forces. In addition, two classical examples were investigated to verify the robustness and precision of the proposed method. The results from the present method are in good agreement with those from studies published previously.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The work was supported by the National Natural Science Foundation of China (Grants 51325903 and 51679017) and the Natural Science Foundation Project of CQ CSTC (Grants cstc2013kjrcljrccj0001, cstc2013jcyjys0005, cstc2015jcyjys0002, cstc2015jcyjys0009, and cstc2016jcyjys0005).
References
Ahmad, S., and Choudhury, D. (2010). “Seismic rotational stability of waterfront retaining wall using pseudodynamic method.” Int. J. Geomech., 45–52.
Ambraseys, N. N., and Menu, J. M. (1988). “Earthquake-induced ground displacements.” Earthquake Eng. Struct. Dyn., 16(7), 985–1006.
Baker, R. (2003). “Sufficient conditions for existence of physically significant solutions in limiting equilibrium slope stability analysis.” Int. J. Solids Struct., 40, 3717–3735.
Basha, B. M., and Babu, G. L. S. (2009). “Computation of sliding displacements of bridge abutments by pseudo-dynamic method.” Soil. Dyn. Earthquake Eng., 29(1), 103–120.
Bouckovalas, G. B., and Papadimitriou, A. G. (2005). “Numerical evaluation of slope topography effects on seismic ground motion.” Soil. Dyn. Earthquake Eng., 25, 547–558.
Bu, Z. Y. (2005). “Cable-deck coupled vibration and damping characteristic research in the seismic response analysis of cable-stayed bridges.” Ph.D. dissertation, Zhe jiang Univ., Hangzhou, China (in Chinese).
Chen, Q. Z., and Dong, Y. W. (2013). “Graphic template for analysis of rock slope stability by stereographic projection method.” Northwest Hydropower, 4, 13–16.
Choudhury, D., and Katdare, A. (2013). “New approach to determine seismic passive resistance on retaining walls considering seismic waves.” Int. J. Geomech., 852–860.
Cruden, D. M. (1991). “A simple definition of a landslide.” Bull. Eng. Geol. Environ., 43(1), 27–29.
Grelle, G., Revellino, P., and Guadagno, F. M. (2011). “Methodology for seismic and post-seismic stability assessment of natural clay slopes based on a viscoplastic behaviour model in simplified dynamic analysis.” Soil Dyn. Earthquake Eng., 31(9), 1248–1260.
Hoek, E., and Bray, J. M. (1981). Rock slope engineering, CRC, Boca Raton, FL.
Keefer, D. K. (2000). “Statistical analysis of an earthquake-induced landslide distribution—The 1989 Loma Prieta, California Event.” Eng. Geol., 58(Dec), 231–249.
Low, B., and Einstein, H. (1992). “Simplified reliability analysis for wedge mechanisms in rock slopes.” Proc., 6th Int. Symp., Landslides, A. A. Balkema, Rotterdam, Netherlands, 1, 99–507.
Makdisi, F. I., and Seed, H. B. (1978). “Simplified procedure for estimating dam and embankment earthquake induced deformations.” Proc., National Symp., Soil Erosion and Sediment by Water, American Society of Agricultural Engineers, St Joseph, MI, 125–136.
Mohammad, R. A., Faradjollah, A., and Orang, F. (2012). “Seismic behavior of slopes by lower bound dynamic shakedown theory.” Comput. Geotech., 39, 107–115.
Nawari, O., Hartmann, R., and Lackner, R. (1997). “Stability analysis of rock slopes with the direct sliding blocks method.” Int. J. Rock. Mech. Min. Sci.,. 34, 220.e1–220.e8.
Newmark, N. M. (1965). “Effects of earthquakes on dams and embankments.” Géotechnique, 15(2), 139–160.
Richards, R., and Elms, D. G. (1979). “Seismic behavior of gravity retaining walls.” J. Geotech. Engng. Div., 105(4), 449–464.
Robert, H., Dinand, A., and Gerard, A. M. K. (2007). “Influence of earthquakes on the stability of slopes.” Eng. Geol., 91(1), 4–15.
Savoikar, P., and Choudhury, D. (2012). “Translational seismic failure analysis of MSW landfills using pseudo-dynamic approach.” Int. J. Geomech., 136–146.
Seed, H. B. (1979). “Consideration in the earthquake-resistant design of earth and rockfill dams.” Géotechnique, 29(3), 215–263.
Terzaghi, K. (1950). Mechanism of landslides, Dept. of Engineering, Harvard Univ., Cambridge, MA.
Tiwari, R. C. (2015). “Simplified numerical implementation in slope stability modeling.” Int. J. Geomech., 04014051.
Uenishi, K. (2010). “On a possible role of Rayleigh surface waves in dynamic slope failures.” Int. J. Geomech., 153–160.
Zeng, X., and Steedman, R. S. (2000). “Rotating block method for seismic displacement of gravity walls.” J. Geotech. Geoenviron., 709–717.
Zhou, X. P., Qian, Q. H., Cheng, H., and Zhang, H. P. (2015). “Stability analysis of two-dimensional landslides subjected to seismic loads.” Acta Mech. Solida Sin., 28(3), 262–276.
Information & Authors
Information
Published In
Copyright
© 2017 American Society of Civil Engineers.
History
Received: Nov 9, 2016
Accepted: Jun 5, 2017
Published online: Sep 27, 2017
Published in print: Dec 1, 2017
Discussion open until: Feb 27, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.