Physical Derivation of Effective Stress from Balance Law and Experimental Evidence
Publication: International Journal of Geomechanics
Volume 17, Issue 9
Abstract
It has long been discussed whether Terzaghi’s expression for effective stress holds true for all saturated soils. To examine the physical basis of the effective stress expression, a new mechanical model is proposed. According to that model, the fraction of pore pressure depends on the porosity and the proportion of the particle surfaces to which the pore pressure is applied. The new expression is then tested against the experimental evidence for varied soils. For cohesionless soils, values of (the faction of pore pressure) are close to unity, because the real contact area is extremely small. Significant deviation from Terzaghi’s expression occurs only at very high stresses. For cohesive soils, a method is developed to calculate the values based on the data from shear strength tests. A variation of factor with effective stress is obtained for five different clays. Significant reduction in is observed for clays with a high plastic limit. Without consideration of this reduction, effective strength parameters may be overestimated for the consolidated undrained triaxial tests.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research presented here was supported by the National Natural Science Foundation of China (41672264) and by the National Key Technology Support Program of China (2012BAJ01B04-3). Grateful appreciation is expressed for this support.
References
Alias, R., Kasa, A., and Taha, M. R. (2014). “Effective shear strength parameters for remolded granite residual soil in direct shear and triaxial tests.” Electron. J. Geotech. Eng., 19, 4559–4569.
Anantanasakul, P., Yamamuro, J., and Kaliakin, V. (2012). “Stress-strain and strength characteristics of silt-clay transition soils.” J. Geotech. Geoenviron. Eng., 1257–1265.
Biot, M. A. (1955). “Theory of elasticity and consolidation for a porous anisotropic solid.” J. Appl. Phys., 26, 182–185.
Bishop, A. W. (1959). “The principle of effective stress.” Tek. Ukeblad, 106(39), 859–863.
Bishop, A. W. (1973). “The influence of an undrained change in stress on the pore pressure in porous media of low compressibility.” Géotechnique, 23(3), 435–442.
Bhushan, B. (2013). Introduction to tribology, 2nd Ed., John Wiley & Sons, New York, 125.
Byrne, P. M. (1966). “Effective stress paths in a sensitive clay.” M.Sc. dissertation, Univ. of British Columbia, Vancouver, BC, Canada.
Casagrande, A., and Poulos, S. J. (1964). Fourth report on investigation of stress-deformation and strength characteristics of compacted clays, Harvard Univ., Cambridge, MA.
Castellanos, B. A., and Brandon, T. L. (2013). “A comparison between the shear strength measured with direct shear and triaxial devices on undisturbed and remolded soils.” Proc., 18th Conf. on Soil Mechanics and Geotechnical Engineering, Presses des Ponts, Paris, 317–320.
Das, B. M. (2008). Advanced soil mechanics, 3rd Ed., Taylor & Francis, Oxford, U.K., 19.
Desai, C. S., and Wang, Z. (2003). “Disturbed state model for porous saturated materials.” Int. J. Geomech., 260–265.
Evans, H. E., and Lewis, R. W. (1970). “Effective stress principle in saturated clay.” J. Soil Mech. Found. Div., 96(2), 671–683.
Halling, J. (1975). Principles of tribology, Macmillan, London.
Lade, P. V., and de Boer, R. (1997). “The concept of effective stress for soil, concrete, and rock.” Géotechnique, 47(1), 61–78.
Morland, L., Foulser, R., and Garg, S. K. (2004). “Mixture theory for a fluid-saturated isotropic elastic matrix.” Int. J. Geomech., 207–215.
Rendulic, L. (1937). “Ein Grundgesetz der Tonmechanik und sein experimenteller Beweis.” Bauingenieur, 18, 459–467.
Salih, A. G., and Kassim, K. A. (2012). “Effective shear strength parameters of remoulded residual soil.” Electron. J. Geotech. Eng., 17, 243–253.
Schiffman, R. L. (1970). “The stress components of a porous medium.” J. Geophys. Res., 75(20), 4035–4038.
Singh, P. N., and Wallender, W. W. (2007). “Effective stress from force balance on submerged granular particles.” Int. J. Geomech., 186–193.
Skempton, A. W. (1960). “Effective stress in soils, concrete and rock.” Proc., Conf. on Pore Pressure and Suction in Soils, Butterworths, London, 4–16.
Stark, T. D., and Vettel, J. J. (1991). “Effective stress hyperbolic stress-strain parameters for clay.” Geotech. Test. J., 14(2), 146–156.
Surarak, C., Likitlersuang, S., Wanatowski, D., Balasubramaniam, A., Oh, E., and Guan, H. (2012). “Stiffness and strength parameters for hardening soil model of soft and stiff Bangkok clays.” Soils Found., 52(4), 682–697.
Taha, M. R., Hossain, M. K., Chik, Z., and Nayan, K. A. (1998). “Geotechnical behaviour of a Malaysian residual granite soil.” Pertanika J. Sci. Technol., 7(2), 151–169.
Terzaghi, K. (1936). “The shearing resistance of saturated soils and the angle between the planes of shear.” Proc., First Int. Conf. Soil Mechanics and Foundation Engineering, Vol. 1, Harvard University Press, Cambridge, MA, 54–56.
Zhang, L., and O’Kelly, B. C. (2014). “The principle of effective stress and triaxial compression testing of peat.” Proc. Inst. Civ. Eng. Geotech. Eng., 167(1), 40–50.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 17 • Issue 9 • September 2017
Copyright
© 2017 American Society of Civil Engineers.
History
Received: Feb 25, 2016
Accepted: Mar 8, 2017
Published online: Jun 5, 2017
Published in print: Sep 1, 2017
Discussion open until: Nov 5, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.