Embankment Design Method Combining Limit-State Approach with Stress-Path Application
Publication: International Journal of Geomechanics
Volume 17, Issue 4
Abstract
A rational design method for embankments on soft soils that takes care of both bearing capacity and stability mechanisms is proposed in this paper. Two types of embankment-construction techniques are used on soft soils: a single-stage construction technique for quickly constructing relatively low-height embankments and a staged-construction technique for constructing high embankments. In this paper, a limit-equilibrium approach is used to estimate the critical slip-surface depth that is assumed to be the bottom line of a possible collapse mechanism under undrained loading conditions corresponding to single-stage construction. In contrast, to design a stage-constructed embankment on soft soils, both undrained and drained conditions must be taken into account. The proposed method can address this behavior and therefore is applicable to embankments constructed in either a single stage or multiple stages. The staged-construction technique, however, necessitates adding the tool of stress-path application to the method to consider both undrained and drained behaviors. This is a property that is not found in limit-state approaches, and it gives the proposed method the capacity to follow and interpret changing stress–strain states and their influence on mobilized strength states.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by Istanbul University Scientific Research Projects Fund (Grants UDP-56243 and UDP-46366).
References
Atkinson, J. H., and Bransby, P. L. (1978). The mechanics of soils: An introduction to critical state soil mechanics, McGraw-Hill, Maidenhead, England.
Atkinson, J. H. (1981). Foundation and slopes: An introduction to applications of critical state soil mechanics, McGraw-Hill, Maidenhead, England.
Chen, W. F. (1975). Limit analysis and soil plasticity, Elsevier Science, Amsterdam, Netherlands.
Cinicioglu, S., and Togrol, E. (1991). “Embankment design on soft clays.” J. Geotech. Eng., 1691–1705.
Cinicioglu, S. F., Unal, G., and Togrol, E. (1999). “A plastic stability solution for embankment design.” Geotechnical engineering for transportation infrastructure, Balkema, Rotterdam, Netherlands, 1263–1268.
Drucker, D. C., Prager, W., and Greenberg, H. J. (1952). “Extended limit design theorems for continuous media.” Q. Appl. Math., 9(4), 381–389.
Duncan, J. M., Navin, M., and Wolff, T. F. (2003). “Discussion of ‘probabilistic slope stability analysis for practice.’” Can. Geotech. J., 40(4), 848–850.
El-Ramly, H., Morgenstern, N. R., and Cruden, D. M. (2003). “Reply to the discussion by J. M. Duncan, M. Navin, and T. F. Wolff, ‘Probabilistic slope stability analysis for practice.’” Can. Geotech. J., 40(4), 851–855.
Han, J. (2015). Principles and practice of ground improvement, John Wiley & Sons, Hoboken, NJ.
Indraratna, B., Balasubramaniam, A. S., and Balachandran, S. (1992). “Performance of test embankment constructed to failure on soft marine clay.” J. Geotech. Eng., 12–33.
Jaky, J. (1944). “The coefficient of earth pressure at rest.” J. Soc. Hung. Archit. Engrs., 78, 355–358.
LimitStateGEO [Computer software]. LimitState Ltd., Sheffield, U.K.
Magnan, J. P., Mieussens, C., and Queyroi, D. (1983). “Etude d’un remblai sur sols compressibles: Le remblai B du site experimental de Cubzac-les-Ponts.” Laboratoire central des ponts et chaussees rapport de recherche LPC No.127, LCPC, Paris.
Milligan, V., and Busbridge, J. R. (1983). “Guidelines for the use of tensar in reinforcement of fills over weak foundations.” Golder Associates Report to the Tensar Corp., Golder Associates, Mississauga, Ontario, Canada.
Oser, C. (2010). “Yumuşak zeminler üzerindeki toprak dolguların limit denge ve performansa dayalı tasarımı.” Ph.D. thesis, Istanbul Univ., Istanbul, Turkey.
Oztoprak, S., and Cinicioglu, S. F. (2005). “Soil behaviour through field instrumentation.” Can. Geotech. J., 42(2), 475–490.
Oztoprak, S., and Cinicioglu, S. F. (2006). “In situ yielding and field stress paths of clayey soils under embankment loading.” Proc., 13th Danube-European Conf. on Geotechnical Engineering, Slovenian Geotechnical Society, Ljubljana, Slovenia.
PLAXIS 2D [Computer software]. Plaxis bv, Delft, Netherlands.
Schofield, A., and Wroth, P. (1986). Critical state soil mechanics, McGraw-Hill, Cambridge, England.
Slope/W [Computer software]. GEO-SLOPE, Calgary, AB, Canada.
Wood, D. M. (1990). Soil behaviour and critical state soil mechanics, Cambridge University Press, New York.
Yılmaz, G. (1994). “Yumuşak temelli toprak dolguların tasarımı.” Ph.D. thesis, Osmangazi Univ., Eskişehir, Turkey.
Zhang, J., Shamoto, Y., and Tokimatsu, K. (1998). “Evaluation of earth pressure under any lateral deformation.” Soils Found., 38(1), 15–33.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Mar 10, 2016
Accepted: Jul 29, 2016
Published online: Sep 13, 2016
Discussion open until: Feb 13, 2017
Published in print: Apr 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.