Analysis of Laterally Loaded Pile Groups in Improved Soft Clay
Publication: International Journal of Geomechanics
Volume 17, Issue 4
Abstract
The use of p-multipliers in the analysis of the lateral loading behavior of pile groups is based on the concept of modifying the single-pile p-y curve to obtain the p-y curve for a pile in a group. The p-multipliers account for the reduced soil resistance mobilized at a given deflection as a result of overlapping of shear zones. Different factors can influence the p-multipliers; however, because of the lack of experimental data, most researchers and design guidelines consider only the normalized pile spacing in the direction of loading in their recommendations. In this study, the effects of pile spacing and clay stiffness on the p-multipliers were investigated using the results of two series of centrifuge tests. The soil profile consisted of four lightly overconsolidated clay layers overlying a dense sand layer. The pile groups had a symmetrical layout consisting of 2 × 2 piles spaced at center-to-center distances of 3.0 and 7.0 pile diameter (D) and were driven into improved (stiff clay) and unimproved soft clay. Ground improvement was done in situ using simulated cement deep soil mixing (CDSM). Computer analyses were performed to back-calculate the p-multipliers. There was very good agreement between the measured and computed responses for both the leading and trailing rows of piles in the unimproved and improved soft clay. The results reveal that increasing the clay stiffness and pile spacing in the direction of loading increase p-multipliers. No pile–soil–pile interaction was observed for the 7D spacing. The proposed set of p-multipliers for the soft clay was found to be in close agreement with some current guidelines, whereas other design guidelines appear to recommend relatively conservative values of p-multipliers for both soft and stiff clay (improved ground).
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research reported herein was supported by the National Science Foundation (NSF) under Grant CMMI-0830328. This support is gratefully acknowledged.
References
AASHTO. (2012). AASHTO LRFD bridge design specifications, Washington, DC.
Arulmoli, K., Muraleetharan, K. K., Hossain, M. M., and Fruth, L. S. (1992). VELACS: Verification of liquefaction analyses by centrifuge studies, laboratory testing program, soil data report, Earth Technology, Irvine, CA.
Ashour, M., and Ardalan, H. (2011). “Employment of the P-multiplier in pile-group analysis.” J. Bridge Eng., 612–623.
Ashour, M., Norris, G., and Pilling, P. (1998). “Lateral loading of a pile in layered soil using the strain wedge model.” J. Geotech. Geoenviron. Eng., 303–315.
Brandenberg, S., Wilson, D., and Rashid, M. (2010). “Weighted residual numerical differentiation algorithm applied to experimental bending moment data.” J. Geotech. Geoenviron. Eng., 854–863.
Brown, D., Morrison, C., and Reese, L. (1988). “Lateral load behavior of pile group in sand.” J. Geotech. Engrg., 1261–1276.
Brown, D., Reese, L., and O'Neill, M. (1987). “Cyclic lateral loading of a large‐scale pile group.” J. Geotech. Engrg., 1326–1343.
Brown, D. A., O’Neill, M. W., Hoit, M., McVay, M., EL Naggar, M. H., and Chakraborty, S. (2001). “Static and dynamic lateral loading of pile groups.” Rep. No. NCHRP 461, National Cooperative Highway Research Program, Transportation Research Board, Washington, DC.
Canadian Geotechnical Society. (1978). Canadian foundation engineering manual. Part III: Deep foundations, Canadian Geotechnical Society, Montreal.
Chandrasekaran, S., Boominathan, A., and Dodagoudar, G. (2010). “Group interaction effects on laterally loaded piles in clay.” J. Geotech. Geoenviron. Eng., 573–582.
Cox, W. R., Dixon, D. A., and Murphy, B. S. (1984). “Lateral load tests of 25.4-mm (1-in.) diameter piles in very soft clay in side-by-side and in-line groups.” Laterally loaded deep foundations: Analysis and performance, ASTM, West Conshohocken, PA.
Dafalias, Y., and Herrmann, L. (1986). “Bounding surface plasticity. II: Application to isotropic cohesive soils.” J. Eng. Mech., 1263–1291.
Davisson, M. T. (1970). “Lateral load capacity of piles.” Proc., 49th Annual Meeting of the Highway Research Board, Highway Research Board, Washington, DC, 104–112.
Fayyazi, M. S., Taiebat, M., and Finn, W. D. L. (2014). “Group reduction factors for analysis of laterally loaded pile groups.” Can. Geotech. J., 758–769.
FEMA. (2012). “Foundation analysis and design.” FEMA P-751, Washington, DC.
Focht, J. A., and Koch, K. J. (1973). “Rational analysis of the lateral performance of offshore pile groups.” Proc., 5th Offshore Technology Conf. Houston, SPE, Richardson, TX, 701–708.
Garnier, J., et al. (2007). “Catalogue of scaling laws and similitude questions in geotechnical centrifuge modelling.” Int. J. Phys. Model. Geotech., 7(3), 1–23.
GROUP 8.0 [Computer software]. Ensoft, Austin, TX.
Hannigan, P. J., Goble, G. G., Likins, G. E., and Rausche, F. (2006). Design and construction of driven pile foundations, reference manual—Volume I, Federal Highway Administration, Washington, DC.
Huang, A., Hsueh, C., O’Neill, M., Chern, S., and Chen, C. (2001). “Effects of construction on laterally loaded pile groups.” J. Geotech. Geoenviron. Eng., 385–397.
Ilyas, T., Leung, C., Chow, Y., and Budi, S. (2004). “Centrifuge model study of laterally loaded pile groups in clay.” J. Geotech. Geoenviron. Eng., 274–283.
Japan Road Association. (1976). “Road bridge substructure design guide and explanatory notes.” Designing of pile foundations, Tokyo, 144.
Kutter, B. L. (1992). “Dynamic centrifuge modeling of geotechnical structures.” Transportation Research Record, 1336, 24–30.
Kutter, B. L. (1995). “Recent advances in centrifuge modeling of seismic shaking.” Proc., 3rd Int. Conf. on Recent Advances in Geotechnical Earthquake Engineering and Soil Dynamics, Missouri Univ. of Science and Technology, Rolla, MO, 927–942.
Ladd, C. C., Foott, R., Ishihara, K., Schlosser, F., and Poulos, H. G. (1977). “Stress-deformation and strength characteristics: State of the art report.” Proc., 9th Int. Conf. on Soil Mechanics and Foundation Engineering, Japanese Society of Soil Mechanics and Foundation Engineering, Tokyo, 421–494.
LPILE Plus 5.0 [Computer software]. Ensoft, Austin, TX.
Matlock, H. (1970). “Correlations for design of laterally-loaded piles in soft clay.” Proc., 2nd Annual Offshore Technology Conf. OTC, SPE, Richardson, TX, 577–594.
Meimon, Y., Baguelin, F., and Jezequel, J. F. (1986). “Pile group behavior under long term lateral monotonic and cyclic loading.” 3rd Int. Conf. on Numerical Methods in Offshore Piling, Inst. Francais Du Petrole, Nantes, France, 286–302.
Mokwa, R., and Duncan, J. (2005). “Discussion of ‘centrifuge model study of laterally loaded pile groups in clay’ by T. Ilyas, C. F. Leung, Y. K. Chow, and S. S. Budi.” J. Geotech. Geoenviron. Eng., 1305–1308.
Ooi, P., and Duncan, J. (1994). “Lateral load analysis of groups of piles and drilled shafts.” J. Geotech. Engrg., 1034–1050.
Poulos, H. (1971). “Behavior of laterally loaded piles. II: Pile groups.” J. Soil Mech. Found. Div., 733–751.
Rao, S., Ramakrishna, V., and Rao, M. (1998). “Influence of rigidity on laterally loaded pile groups in marine clay.” J. Geotech. Geoenviron. Eng., 542–549.
Reese, L. C., Cox, W. R., and Koop, F. D. (1974). “Analysis of laterally loaded piles in sand.” Proc., 5th Annual Offshore Technology Conf., SPE, Richardson, TX.
Reese, L. C., Cox, W. R., and Koop, F. D. (1975). “Field testing and analysis of laterally loaded piles in stiff clay.” Proc., 7th Offshore Technology Conf., SPE, Richardson, TX.
Reese, L. C., and Van Impe, W. F. (2001). Single piles and pile groups under lateral loading, A. A. Balkema, Rotterdam, Netherlands.
Reese, L. C., and van Impe, W. F. (2011). Single piles and pile groups under lateral loading, CRC Press, Boca Raton, FL.
Reese, L. C., Wang, S. T., Arrellaga, J. A., Hendrix, J., and Vasquez, L. (2010). Computer program GROUP V. 8.0—A program for the analysis of a group of piles subjected to axial and lateral loading. User’s manual, Ensoft, Austin, TX.
Rollins, K., Adsero, M., and Brown, D. (2010a). “Jet grouting to increase lateral resistance of pile group in soft clay.” Contemporary topics in ground modification, problem soils, and geo-support, ASCE, Reston, VA, 265–272.
Rollins, K., and Brown, D. (2011). “Design guidelines for increasing the lateral resistance of highway-bridge pile foundations by improving weak soils.” Rep. No. NCHRP 697, National Cooperative Highway Research Program, Transportation Research Board, Washington, DC.
Rollins, K., Herbst, M., Adsero, M., and Brown, D. (2010b). “Jet grouting and soil mixing for increased lateral pile group resistance.” Advances in analysis, modeling & design, Geotechnical special publication 199, D. O. Fratta, A. J. Puppala, and B. Muhunthan, eds., ASCE, Reston, VA, 1563–1572.
Rollins, K., Olsen, K., Jensen, D., Garrett, B., Olsen, R., and Egbert, J. (2006). “Pile spacing effects on lateral pile group behavior: Analysis.” J. Geotech. Geoenviron. Eng., 1272–1283.
Rollins, K., Peterson, K., and Weaver, T. (1998). “Lateral load behavior of full-scale pile group in clay.” J. Geotech. Geoenviron. Eng., 468–478.
Rollins, K., and Sparks, A. (2002). “Lateral resistance of full-scale pile cap with gravel backfill.” J. Geotech. Geoenviron. Eng., 711–723.
Ruesta, P., and Townsend, F. (1997). “Evaluation of laterally loaded pile group at Roosevelt Bridge.” J. Geotech. Geoenviron. Eng., 1153–1161.
Schofield, A. N. (1981). “Dynamic and earthquake geotechnical centrifuge modelling.” Int. Conf. on Recent Advances in Geotechnical Earthquake Engineering and Soil Dynamics, Missouri Univ. of Science and Technology, Rolla, MO, 1081–1100.
Taghavi, A. (2015). “Seismic and quasi-static lateral load behavior of pile groups in improved soft clay: Centrifuge and numerical modeling.” Ph.D. thesis, Univ. of Oklahoma, Norman, OK.
Taghavi, A., Muraleetharan, K., Miller, G., and Cerato, A. (2013). Seismic and cyclic lateral load tests of pile groups and single piles—Centrifuge Model No. 4, Network for Earthquake Engineering Simulation, National Science Foundation, Arlington, VA.
Taghavi, A., Muraleetharan, K. K., Miller, G. A., and Cerato, A. B. (2015). “Centrifuge modeling of laterally loaded pile groups in improved soft clay.” J. Geotech. Geoenviron. Eng., 04015099.
Thompson, Z. M. (2011). “Stress-strain behavior of unimproved and cement-improved soft clays.” M.Sc. thesis, Univ. of Oklahoma, Norman, OK.
USACE (U.S. Army Corps of Engineers). (1993). “Design of pile foundations.” Technical Engineering and Design Guides No. 1, Washington, DC.
Wilson, D. W. (1998). “Soil-pile-superstructure interaction in liquefying sand and soft clay.” Ph.D. thesis, Univ. of California, Davis, CA.
Wroth, C. P. (1984). “The interpretation of in situ soil tests.” Géotechnique, 34(4), 449–489.
Zhang, L., McVay, M., and Lai, P. (1999). “Numerical analysis of laterally loaded 3 × 3 to 7 × 3 Pile groups in sands.” J. Geotech. Geoenviron. Eng., 936–946.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 17 • Issue 4 • April 2017
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Oct 5, 2015
Accepted: Jul 29, 2016
Published online: Sep 9, 2016
Discussion open until: Feb 9, 2017
Published in print: Apr 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.