Stiffness Behavior of Soil Stabilized with Alkali-Activated Fly Ash from Small to Large Strains
Publication: International Journal of Geomechanics
Volume 17, Issue 3
Abstract
Alkaline activation of fly ash creates a geopolymeric cement that can replace ordinary portland cement in several applications such as soil improvement, with the advantage of much lower carbon dioxide emissions and reusing an industrial by-product otherwise landfilled, which averts several environmental problems. In this paper, the behavior of a silty sand improved by the alkaline activation of fly ash is analyzed from small to large strains by presenting uniaxial and drained triaxial compression test results and seismic wave velocities measured throughout the curing period. The dynamic, cyclic, and static tests showed a significant increase in stiffness with curing time, even beyond the 28-day curing period. On the basis of the nondestructive wave-propagation technique, the increase of the shear and compression wave velocities with time were drawn, giving the evolution of the elastic shear modulus and the Poisson ratio values. The dynamic Young modulus was compared to the correspondent secant Young modulus obtained from the mechanical tests. In addition, the evolution of the properties of this stabilized soil with curing time was compared and confronted to that of soil cement on the basis of the elastic stiffness of both materials, which showed that the most significant difference lies on the curing rate.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge the company Pegop–Energia Eléctrica SA, which runs the thermoelectric power plant of Pego, for the supply of fly ash, and Agência de Inovação (ANI) for support through the ECOSOLO Project (Reference 38899/2012). Particular acknowledgment is also due to the Portuguese Science and Technology Foundation for its financial support through the SFRH/BPD/85863/2012 scholarship funded by the Portuguese Ministry of Science and Technology (MCTES) and the European Social Fund (FSE) by the POCH program.
References
ACI (American Concrete Institute) Committee 209. (1998). “Prediction of creep, shrinkage, and temperature effects in concrete structures.” Committee Rep. ACI 209R-92, ACI Manual of concrete practice, part I, Farmington Hills, MI.
Amaral, M. F. (2009). “Dynamic shear modulus evaluation in soil–cement mixtures using time domain ultrasonic impulses and recording the resonant frequencies with Fourier spectral analysis.” M.Sc. thesis. Faculty of Engineering, Univ. of Porto, Porto, Portugal (in Portuguese).
Arroyo, M., Wood, D. M., and Greening, P. D. (2003). “Source near-field effects and pulse tests in soil samples.” Géotechnique, 53(3), 337–345.
ASTM. (1996). “Standard test method for compressive strength of molded soil-cement cylinders.” D 1633-96, Annual Book of Standards, Vol. 04.08, West Conshohoken, PA.
ASTM. (2003). “Standard specification for coal fly ash and raw or calcined natural pozzolan for use in concrete.” C618, Annual Book of Standards, Vol. 04.02, West Conshohoken, PA.
ASTM. (2011). “Method for consolidated drained triaxial compression test for soils.” D 7181, Annual Book of Standards, Vol. 04.09, West Conshohoken, PA.
Bernal, S., Gutiérrez, R. M., Pedraza, A. L., and Provis, J. L. (2011). “Effect of binder content on the performance of alkali-activated slag concretes.” Cement and Concrete Research, 41(1), 1–8.
Camusso, M., and Barla, M. (2009). “Microparameters calibration for loose and cemented soil when using particle methods.” Int. J. Geomech., 217–229.
Chen, R., Lee, I., and Zhang, L. (2014). “Biopolymer stabilization of mine tailings for dust control.” J. Geotech. Geoenviron. Eng., 04014100.
Cheng, L., Cord-Ruwisch, R., and Shahin, M. A. (2013). “Cementation of sand soil by microbially induced calcite precipitation at various degrees of saturation.” Can. Geotech. J., 50(1), 81–90.
Clayton, C., Khatrush, S., Bica, A., and Siddique, A. (1989). “The use of hall-effect semiconductors in geotechnical instrumentation.” Geotech. Test. J., 12(1), 69–76.
Consoli, N., Viana da Fonseca, A., Cruz, R., and Rios, S. (2011). “Voids/cement ratio controlling tensile strength of cement treated soils.” J. Geotech. Environ. Eng., 1126–1131.
Cristelo, N., Glendinning, S., and Teixeira Pinto, A. (2011). “Deep soft soil improvement by alkaline activation.” Ground Improv., 164(2), 73–82.
Cristelo, N., Glendinning, S., Fernandes, L., and Teixeira Pinto, A. (2013). “Effects of alkaline-activated fly ash and portland cement on soft soil stabilisation.” Acta Geotech., 8(4), 395–405.
Cuccovillo, T., and Coop, M. R. (1999). “On the mechanics of structured sands.” Géotechnique, 49(6), 741–760.
Dupas, J. M., and Pecker, A. (1979). “Static and dynamic properties of sand-cement.” J. Geotech. Engrg. Div., 105(3), 419–436.
Gomes Correia, A., Viana da Fonseca, A., and Gambin, M. (2004). “Routine and advanced analysis of mechanical in situ tests. Results on saprolitic soils from granites more or less mixed in Portugal.” Proc., ISC-2 on Geotechnical and Geophysical Site Characterization, A. Viana da Fonseca and A. Mayne, eds., Millpress, Rotterdam, Netherlands, 75–95.
Goto, S., Tatsuoka, F., Shibuya, S., Kim, Y., and Sato, T. (1991). “A simple gauge for local small strain measurements in the laboratory.” Soils Found., 31(1), 169–180.
Hayano, K., Tatsuoka, F., and Sato, T. (1997). “Deformation characteristics of a sedimentary soft mudstone from triaxial compression tests using rectangular prism specimens.” Géotechnique, 47(3), 439–449.
Hossain, M., and Yin, J. (2014). “Dilatancy and strength of an unsaturated soil-cement interface in direct shear tests.” Int. J. Geomech., 04014081.
Kang, X., Ge, L., and Liao, W. C. (2016). “Cement hydration–based micromechanics modeling of the time-dependent small-strain stiffness of fly ash–stabilized soils.” Int. J. Geomech., 04015071.
Khatami, H. R., and O’Kelly, B. C. (2013). “Improving mechanical properties of sand using biopolymers.” J. Geotech. Geoenviron. Eng., 1402–1406.
Leroueil, S., and Vaughan, P. R. (1990). “The general and congruent effects of structure in natural soils and weak rocks.” Géotechnique, 40(3), 467–488.
Little, D. (1995). Handbook for stabilization of pavement subgrades and base courses with lime, Kendall/Hunt Publishing Co., Dubuque, IA.
Palomo, A., Grutzeck, M. W., and Blanco, M. T. (1999). “Alkali-activated fly ashes. A cement for the future.” Cem. Concr. Res., 29(8), 1323–1329.
Rahimi, M., Chan, D., and Nouri, A. (2016). “Bounding surface constitutive model for cemented sand under monotonic loading.” Int. J. Geomech., 04015049.
Rios, S., Viana da Fonseca, A., and Baudet, B. (2012). “Effect of the porosity/cement ratio on the compression of cemented soil.” J. Geotech. Environ. Eng., 1422–1426.
Rios, S., Viana da Fonseca, A., and Baudet, B. (2014). “On the shearing behaviour of an artificially cemented soil.” Acta Geotech., 9(2), 215–226.
Rios, S., Cristelo, C., Viana da Fonseca, A., and Ferreira, C. (2016). “Structural performance of alkali activated soil-ash versus soil-cement.” J. Mater. Civ. Eng., 215–226.
Sauceda, M., Johnson, D. W., Huang, J., Bin-Shafique, S., Sponsel, V. M., and Appleford, M. (2014). “Soil-strength enhancements from polymer-infused roots.” J. Geotech. Geoenviron. Eng., 04013004.
Scrivener, K. L., and Kirkpatrick, R. J. (2008). “Innovation in use and research on cementitious material.” Cem. Concr. Res., 38(2), 128–136.
Sukmak, P., Horpibulsuk, S., and Shen, S. L. (2013). “Strength development in clay–fly ash geopolymer.” Constr. Build. Mater., 40, 566–574.
Turner, L. K., and Collins, F. G. (2013). “Carbon dioxide equivalent (CO2-e) emissions: A comparison between geopolymer and OPC cement concrete.” Constr. Build. Mater., 43, 125–130.
Vardanega, P. J., and Bolton, M. D. (2013). “Stiffness of clays and silts: Normalizing shear modulus and shear strain.” J. Geotech. Geoenviron. Eng., 1575–1589.
Viana da Fonseca, A., Ferreira, C., and Fahey, M. (2009). “A framework interpreting bender element tests, combining time-domain and frequency-domain methods.” Geotech. Test. J., 32(2), 1–17.
Viana da Fonseca, A., Coop, M. R., Fahey, M., and Consoli, N. C. (2011). “The interpretation of conventional and non-conventional laboratory tests for challenging geotechnical problems.” Proc., 5th Int. Symp. on Deformation Characteristics of Geomaterials, IOS Press, Amsterdam, Netherlands, 1–36.
Viana da Fonseca, A., Rios, S., and Amaral, M. F. (2013). “Structural anisotropy by static compaction.” Eng. Geol., 154, 89–97.
Yi, Y., Liska, M., Unluer, C., and Al-Tabbaa, A. (2013). “Carbonating magnesia for soil stabilization.” Can. Geotech. J., 50(8), 899–905.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Mar 26, 2015
Accepted: Jul 11, 2016
Published online: Aug 26, 2016
Discussion open until: Jan 26, 2017
Published in print: Mar 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.