Novel Approach to Measuring Tensile Strength of Compacted Clayey Soil during Desiccation
Publication: International Journal of Geomechanics
Volume 16, Issue 6
Abstract
Desiccation of soil is the gradual process of moisture loss from a fully or partially saturated condition to a dry state. If the soil is constrained against shrinkage during desiccation, it will begin to crack when tensile stresses in the soil exceed the tensile strength. Fundamental to understanding desiccation crack development in clayey soils is the accurate determination of the tensile strength during desiccation. Although numerous published studies have focused on soil desiccation and soil tensile strength, very little has been focused on experimental determination of tensile strength during desiccation. This paper presents the first generation of a novel apparatus designed to determine tensile strength during desiccation. During drying the tensile forces in a thin compacted soil layer are measured while simultaneously monitoring moisture content changes and crack formation via time-lapse photography. Results are presented from desiccation tests performed on two clayey compacted soils of medium to high plasticity. Soil water characteristic curves (SWCCs) were determined to relate the tensile strength to suction. The results demonstrate that the tensile strength of compacted soil is influenced by initial water content, suction, dry unit weight, soil pore structure, and soil type. Measured tensile strengths compare favorably with results of a theoretical model that considers microstructural and macrostructural aspects of unsaturated compacted clayey soil.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors are grateful for the financial support of the Oklahoma DOT and the Oklahoma Transportation Center and to Michael Schmitz of the University of Oklahoma (OU) for assisting with the design and fabrication of the desiccation test box. The authors are also grateful to Wassim Tabet, graduate student at OU, for his assistance with experiments conducted early in the research.
References
Al-Hussaini, M. M., and Townsend, F. C. (1974). Investigation of tensile testing of compacted soils, U.S. Army Engineer Waterways Experiment Station, Vicksburg, MI.
Alonso, O. S., Vaunat, J., and Pereira, J. M. (2010). “A microstructurally based effective stress for unsaturated soils.” Géotechnique, 60(12), 913–925.
Amarasiri, A., and Kodikara, J. (2011). “Use of material interfaces in DEM to simulate soil fracture propagation in Mode I cracking.” Int. J. Geomech., 314–322.
Amarasiri, A. L., and Kodikara, J. (2013). “Numerical modeling of desiccation cracking using the cohesive crack method.” Int. J. Geomech., 213–221.
Amarisiri, A., Shannon, B., and Kodikara, J. (2014). “Numerical modelling of desiccation cracking in a restrained ring test.” Can. Geotech. J., 51(1), 67–76.
Ayad, R., Konrad, J. M., and Soulié, M. (1997). “Desiccation of a sensitive clay: Application of the model CRACK.” Can. Geotech. J., 34(6), 943–951.
Barzegar, A. R., Oades, J. M., Rengasamy, P., and Murray, R. S. (1995). “Tensile strength of dry, remoulded soils as affected by properties of the clay fraction.” Geoderma, 65(1–2), 93–108.
Bishop, A. W. (1959). “The principle of effective stress.” Teknisk Ukeblad, 106(39), 859–863.
Costa, S., and Kodikara, J. (2012). “Evaluation of J-integral for clay soils using a new ring test.” Geotech. Test. J., 35(6), 1–9.
Costa, S., Kodikara, J., and Shannon, B. (2013). “Salient factors controlling desiccation cracking of clay in laboratory experiments.” Géotechnique, 63(1), 18–29.
Fang, H. Y. (1997). Introduction to environmental geotechnology, CRC Press, Boca Raton, FL.
Fang, H. Y., and Fernandez, J. (1981). “Determination of tensile strength of soils by unconfined-penetration test.” ASTM STP 740, American Society for Testing and Materials, West Conshohocken, PA, 130–144.
Hanson, J., Hardin, B., and Mahboub, K. (1994). “Fracture toughness of compacted cohesive soils using ring test.” J. Geotech. Engrg., 872–891.
Kim, T., Kim, T., Kang, G., and Ge, L. (2012). “Factors influencing crack-induced tensile strength of compacted soil.” J. Mater. Civ. Eng., 315–320.
Kim, T. H., and Hwang, C. (2003). “Modeling of tensile strength on moist granular earth material at low water content.” Eng. Geol., 69(3–4), 233–244.
Kodikara, J., and Costa, S. (2013). “Desiccation cracking in clayey soils: Mechanisms and modelling.” Multiphysical testing of soils and shales, Springer series in geomechanics and geoengineering, L. Laloui and A. Ferrari, eds., Springer, Berlin, 21–32.
Kodikara, J. K., and Choi, X. (2006). “A simplified analytical model for desiccation cracking of clay layers in laboratory tests.” Proc., 4th Int. Conf. on Unsaturated Soils, Geotechnical Special Publication 147, G. A. Miller, C. E. Zapata, S. L. Houston, and D. G. Fredlund, eds., Vol. 2, ASCE, Reston, VA, 2558–2567.
Konrad, J. M., and Ayad, R. (1997). “An idealized framework for the analysis of cohesive soils undergoing desiccation.” Can. Geotech. J., 34(4), 477–488.
Lachenbruch, A. H. (1961). “Depth and spacing of tension cracks.” J. Geophys. Res., 66(12), 4273–4292.
Lakshmikantha, M. R., Prat, P. C., and Ledesma, A. (2006). “An experimental study of cracking mechanisms in drying soils.” Proc., 5th Int. Congress on Environmental Geotechnics, Telford, London.
Lakshmikantha, M. R., Prat, P. C., and Ledesma, A. (2012). “Experimental evidence of size effect in soil cracking.” Can. Geotech. J., 49(3), 264–284.
Lu, N., Kim, T., Sture, S., and Likos, W. (2009). “Tensile strength of unsaturated sand.” J. Eng. Mech., 1410–1419.
Miller, C. J., Mi, H., and Yesiller, N. (1998). “Experimental analysis of desiccation crack propagation in clay liners.” J. Am. Water Resour. Assoc., 34(3), 677–686.
Miller, G. A., Hassanikhah, A., Varsei, M. (2015). “Desiccation crack depth and tensile strength in compacted soil.” Unsaturated Soil Mechanics–From Theory to Practice: Proc., 6th Asia Pacific Conf. on Unsaturated Soils, CRC Press, Boca Raton, FL.
Morris, P. H., Graham, J., and Williams, D. J. (1992). “Cracking in drying soils.” Can. Geotech. J., 29(2), 263–277.
Nahlawi, H., Chakrabarti, S., and Kodikara, J. (2004). “A direct tensile strength testing method for unsaturated geomaterials.” Geotech. Test. J., 27(4), 11767.
Nahlawi, H., and Kodikara, J. K. (2006). “Laboratory experiments on desiccation cracking of thin soil layers.” Geotech. Geol. Eng., 24(6), 1641–1664.
Peron, H., Hueckel, T., Laloui, L., and Hu, L. B. (2009). “Fundamentals of desiccation cracking of fine-grained soils: Experimental characterization and mechanisms identification.” Can. Geotech. J., 46(10), 1177–1201.
Rodríguez, R., Sánchez, M., Ledesma, A., and Lloret, A. (2007). “Experimental and numerical analysis of desiccation of a mining waste.” Can. Geotech. J., 44(6), 644–658.
Tamrakar, S., Mitachi, T., Toyosawa, Y., and Itoh, K. (2005). “Development of a new soil tensile strength test apparatus.” Proc., Geo-Frontiers 2005, Site Characterization and Modeling, Geotechnical Special Publication 138 (CD-ROM), J. Dejong, et al., eds., ASCE, Reston, VA, 1–10.
Trabelsi, H., Jamei, M., Zenzri, H., and Olivella, S. (2012). “Crack patterns in clayey soils: Experiments and modeling.” Int. J. Numer. Anal. Methods Geomech., 36(11), 1410–1433.
van Genuchten, M. T. (1980). “Closed-form equation for predicting the hydraulic conductivity of unsaturated soils.” Soil Sci. Soc. Am. J., 44(5), 892–898.
Vesga, L. F. (2009). “Direct tensile-shear test (DTS) on unsaturated kaolinite clay.” Geotech. Test. J., 32(5), 101563.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 16 • Issue 6 • December 2016
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Oct 6, 2015
Accepted: Mar 30, 2016
Published online: May 17, 2016
Discussion open until: Oct 17, 2016
Published in print: Dec 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.