Numerical Modeling of Geotextile-Reinforced Embankments over Deep Cement Mixed Columns Incorporating Strain-Softening Behavior of Columns
This article has a reply.
VIEW THE REPLYThis article has a reply.
VIEW THE REPLYPublication: International Journal of Geomechanics
Volume 15, Issue 2
Abstract
Geotextile-reinforced embankments over deep cement mixed (DCM) columns are widely used for the construction of highway embankments over soft clay with low shear strength and high compressibility. Numerical modeling based on the FEM is widely used to investigate the behavior of these embankments during construction and serviceability, incorporating consolidation of the foundation soil over time. However, not much attention has been paid to the strain-softening behavior of DCM columns beyond yield, which is essential in ultimate limit-state computations to determine the stability of embankments during the failure of columns. This paper presents a constitutive model, which is an extension of the Mohr-Coulomb model, for the simulations of strain-softening behavior of cement admixed clays. The model is validated using triaxial test data found in the literature for cement admixed Singapore and Hong Kong marine clays and Ariake clay. A two-dimensional (2D) coupled mechanical and hydraulic numerical implementation of a geotextile-reinforced DCM column-supported (GRCS) embankment constructed over a very soft soil in Finland is carried out incorporating strain-softening behavior of DCM columns. Even though the isolated columns and overlapped column walls used in this embankment do not yield significantly under the service loads, the model simulations show good agreement with field data, confirming the capability of the 2D plane strain finite-element model in predicting the GRCS embankment behavior. Finally, the finite-element model with strain-softening DCM columns is used to investigate the progressive failure of a typical hypothetical GRCS embankment with isolated columns in a square pattern. Results clearly illustrate the bending failure mode caused by progressive softening of the DCM columns, including the plastic hinge development within the columns.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge the financial support provided by the Australian Research Council and Coffey Geotechnics Pty. Ltd. under Linkage Project No. LP0990581.
References
ABAQUS/Standard 6.11 [Computer software]. Waltham, MA, Dassault Systèmes.
Anastasopoulos, I. (2005). “Fault rupture-soil-foundation-structure interaction.” Ph.D. thesis, National Technical Univ., Athens, Greece.
Ariyarathne, P., Liyanapathirana, D. S., and Leo, C. J. (2013). “Comparison of different two-dimensional idealizations for a geosynthetic-reinforced pile-supported embankment.” Int. J. Geomech., 754–768.
Bergado, D. T., and Long, P. V. (1994). “Numerical analysis of embankment on subsiding ground improved by vertical drains and granular piles.” Proc., Int. Conf. on Soil Mechanics and Foundation Engineering, Balkema, Rotterdam, Netherlands, 1361–1361.
British Standards Institution. (2010). “Code of practice for strengthened/reinforced soil and other fills.” BS 8006, London.
Broms, B. B. (1999). “Keynote lecture: Design of lime, lime/cement and cement columns.” Int. Conf. on Dry Mix Methods: Dry mix methods for deep soil stabilization, H. Brendenberg, Broms, and B. Holm, eds., Balkema, Rotterdam, Netherlands, 125–154.
Bruce, D. A. (2001). “An introduction to the deep mixing methods as used in geotechnical applications—Vol. III: The verification and properties of treated ground,” FHWA-RD, Final Rep., National Technical Information Service, Alexandria, VA, 1–455.
Chew, S. H., Kumruzzaman, A. H. M., and Lee, F. H. (2004). “Physicochemical and engineering behavior of cement treated clay.” J. Geotech. Geoenviron. Eng., 696–706.
Fang, Z. (2006). “Physical and numerical modelling of the soft soil ground improved by deep cement mixing method.” Ph.D. thesis, Hong Kong Polytechnic Univ., Hong Kong.
Fliz, G. (2007). “Load transfer, settlement, and stability of embankments founded on columns installed by deep mixing methods.” Geotechnical Engineering Seminar Presentation, Foundation Engineering Laboratory, Geotechnical Engineering Dept., Geotechnical Dept., School of Civil Engineering, National Technical Univ. of Athens, Athens, Greece.
Forsman, J., Honkala, A., and Smura, M. (1999). “Hertsby case: A column stabilised and geotextile reinforced road embankment on soft subsoil.” Dry mix methods for deep soil stabilization, Brendenberg, Broms, and Holm, eds., Balkema, Rotterdam, Netherlands, 263–368.
Han, J., and Gabr, M. A. (2002). “Numerical analysis of geosynthetic-reinforced and pile-supported earth platforms over soft soil.” J. Geotech. Geoenviron. Eng., 44–53.
Horpibulsuk, S., Liu, M., Liyanapathirana, D., and Suebsuk, J. (2010). “Behaviour of cemented clay simulated via the theoretical framework of Structured Cam Clay model.” Comput. Geotech., 37(1–2), 1–9.
Horpibulsuk, S., Miura, N., and Bergado, D. T. (2004). “Undrained shear behavior of cement admixed clay at high water content.” J. Geotech. Geoenviron. Eng., 1096–1105.
Huang, J., and Han, J. (2009). “3D coupled mechanical and hydraulic modeling of a geosynthetic-reinforced deep mixed column-supported embankment.” J. Geotextile Geomembr., 27(4), 272–280.
Huang, J., and Han, J. (2010). “Two-dimensional parametric study of geosynthetic-reinforced column-supported embankments by coupled hydraulic and mechanical modeling.” Comput. Geotech., 37(5), 638–648.
Huang, J., Han, J., and Oztoprak, S. (2009). “Coupled mechanical and hydraulic modeling of geosynthetic-reinforced column-supported embankments.” J. Geotech. Geoenviron. Eng., 1011–1021.
Kamruzzaman, A. H., Chew, S. H., and Lee, F. H. (2009). “Structuration and destructuration behavior of cement-treated Singapore marine clay.” J. Geotech. Geoenviron. Eng., 573–589.
Kitazume, M. (2008). “Stability of group column type DM improved ground under embankment loading behavior of sheet pile quay wall.” Rep. Port and Airport Research Institute (PARI Rep. 047-01-01), Nagase, Yokosuka, Japan., 47(1), 1–55.
Kivelo, M. (1998). “Stabilization of embankments on soft soil with lime/cement columns.” Ph.D. thesis, Royal Institute of Technology, Stockholm, Sweden.
Lawson, C. R. (2000). “Serviceability limits for low-height reinforced piled embankments.” GeoEng 2000: Int. Conf. on Geotechnical and Geological Engineering, Technomic, Lancaster, PA, Paper No. GIGS0776.
Lee, K., Chan, D., and Lam, K. (2004). “Constitutive model for cement treated clay in a critical state framework.” Soils Found., 44(3), 69–77.
Lorenzo, G. A., and Bergado, D. T. (2004). “Fundamental parameters of cement-admixed clay—New approach.” J. Geotech. Geoenviron. Eng., 1042–1050.
Navin, M. (2005). “Stability of embankments founded on soft soil improved with deep mixing method columns.” Ph.D. thesis, Virginia Tech, Blacksburg VA.
Navin, M. P., and Filz, G. M. (2005). “Statistical analysis of strength data from ground improved with DMM columns.” Deep Mixing '05: Int. Conf. on Deep Mixing Best Practice and Recent Advances, Vol. 1, Swedish Deep Stabilization Research Centre, Linköping, Sweden, 145–154.
Navin, M. P., and Fliz, G. M. (2006). “Numerical stability analysis of embankments supported on deep mixed columns.” ASCE Conf. Proc., Ground Modification and Seismic Mitigation (GSP 152), ASCE, Reston, VA, 1–8.
Parry, H. J. (1983). “Coping with Fife’s mining industrial heritage.” Municipal Engineer, U.K., 110(778), 231–240.
Potts, D. M., Dounias, G. T., and Vaughan, P. R. (1990). “Finite-element analysis of progressive failure of Carsington embankment.” Geotechnique, 40(1), 79–101.
Potts, D. M., Kovacevic, N., and Vaughan, P. R. (1997). “Delayed collapse of cut sloped in stiff clay.” Geotechnique, 47(5), 953–982.
Porbaha, A., Shibuya, S., and Kishida, T. (2000). “State of the art in deep mixing technology. Part III: Geotechnical characterization.” Ground Improv., 4(3), 91–110.
Shen, S. L., and Miura, N. (1999). “Soil fracturing of the surrounding clay during deep mixing column installation.” Soils Found., 39(5), 13–22.
Stewart, M. E., Navin, M. P., and Fliz, G. M. (2004). “Analysis of a column-supported test embankment at the I-95/Route 1 interchange.” Geotechnical Engineering for Transportation Projects (GSP 126), M. K. Yegian and E. Kavazanjian, eds., ASCE, Reston, VA, 1337–1346.
Suebsuk, J., Horpibulsuk, S., and Liu, M. (2010). “Modified Structured Cam Clay: A generalised critical state model for destructured, naturally structured and artificially structured clays.” Comput. Geotech., 37(7–8), 956–968.
Walters, D. L., Allen, T. M., and Bathurst, R. J. (2002). “Conversion of geosynthetic strain to load using reinforcement stiffness.” Geosyn. Int., 9(5–6), 483–523.
Wang, W., Zhou, A., and Ling, H. (2009). “Field tests on composite deep-mixing cement pile foundation under expressway embankment.” Slope Stability, Retaining Walls, and Foundations: Selected Papers from the 2009 GeoHunan Int. Conf., ASCE, Reston, VA, 62–67.
Yapage, N. N. S., Liyanapathirana, D. S., Poulos, H. G., Kelly, R. B., and Leo, C. J. (2012). “An investigation of progressive failure of geosynthetic reinforced deep cement mixed column supported embankments.” Int. Conf. on Ground Improvement and Ground Control, Vol. 2, Research Publishing, Singapore, 1345–1351.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jan 1, 2013
Accepted: Jul 16, 2013
Published online: Jul 18, 2013
Published in print: Apr 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.