Discrete-Element Method Simulations of the Response of Soil-Foundation-Structure Systems to Multidirectional Seismic Motion
Publication: International Journal of Geomechanics
Volume 13, Issue 5
Abstract
In this study, a three-dimensional microscale framework utilizing the discrete-element method (DEM) is presented to analyze the seismic response of soil-foundation-structure systems subjected to three-directional base motion. The proposed approach is employed to investigate the response of a single lumped mass on a square spread footing founded on a dry granular deposit. The soil is idealized as a collection of spherical particles using DEM. The spread footing is modeled as a rigid block composed of clumped particles, and its motion is described by the resultant forces and moments acting upon it. The structure is modeled as a column made of clumped particles with a concentrated mass specified for the particle at the top. Analysis is done in a fully coupled scheme in time domain while taking into account the effects of soil nonlinear behavior, possible separation between the foundation base and soil because of rocking, possible sliding of the footing, and dynamic soil-foundation interactions. A technique to idealize several base boundary conditions to mimic rigid and elastic rock as well as an infinite medium is also presented. Microscale energy dissipation in the soil deposit in the free field and in the presence of the structure is quantified. Simulations were conducted to investigate the response of the deposit with and without the structure to various scenarios of multidirectional shaking patterns. Vertical motion amplification in the free field was similar to that of shear wave propagation. However, there was less nonlinearity for vertical motion than there was for horizontal motion. Lateral motion had a small impact on the amplification of the vertical input motion. The inclusion of vertical motion did not influence the amplification of horizontal motion at frequencies far from the resonance frequency of vertical motion.
Get full access to this article
View all available purchase options and get full access to this article.
References
Barla, M., Piovano, G., and Grasselli, G. (2012). “Rock slide simulation with the combined finite-discrete element method.” Int. J. Geomech., 12(6), 711–721.
Beresnev, I., Nightengale, A., and Silva, J. (2002). “Properties of vertical ground motions.” Bull. Seismol. Soc. Am., 92(8), 3152–3164.
Broderick, B., and Elnashai, A. (1995). “Analysis of the failure of Interstate 10 Freeway Ramp during the Northridge Earthquake of 17 January 1994.” Earthquake Eng. Struct. Dynam., 24(2), 189–208.
Cook, B., Lee, M., DiGiovanni, A., Bronowski, D., Perkins, E., and Williams, J. (2004). “Discrete element modeling applied to laboratory simulation of near-wellbore mechanics.” Int. J. Geomech., 4(1), 19–27.
Cundall, P., and Strack, O. (1979). “A discrete numerical model for granular assemblies.” Geotechnique, 29(1), 47–65.
Dobry, R., et al. (2000). “New site coefficients and site classification system used in recent building seismic code provisions.” Earthq. Spectra, 16(1), 41–67.
Elgamal, A., and He, L. (2004). “Vertical earthquake ground motion records: An overview.” J. Earthquake Eng., 8(5), 663–697.
El Shamy, U., et al. (2010). “Micromechanical aspects of liquefaction-induced lateral spreading.” Int. J. Geomech., 10(5), 190–201.
El Shamy, U., and Denissen, C. (2012). “Microscale energy dissipation mechanisms in cyclically-loaded granular soils.” Geotech. Geol. Eng., 30(2), 343–361.
El Shamy, U., and Zamani, N. (2012). “Discrete element method simulations of the seismic response of shallow foundations including soil-foundation-structure interaction.” Int. J. Numer. Anal. Methods Geomech., 36(10), 1303–1329.
Frankel, A., et al. (2000). “USGS national seismic hazard maps.” Earthq. Spectra, 16(1), 1–19.
Gadre, A., and Dobry, R. (1998). “Lateral cyclic loading centrifuge tests on square embedded footing.” J. Geotech. Geoenviron. Eng., 124(11), 1128–1138.
Gazetas, G. (1991). “Formulas and charts for impedances of surface and embedded foundations.” J. Geotech. Engrg., 117(9), 1363–1381.
Gazetas, G., Panagiotidou, A., and Gerolymos, N. (2010). “Pushover and inelastic-seismic response of shallow foundations supporting a slender structure.” Proc., 5th Int. Conf. on Recent Advances in Geotechnical Earthquake Engineering and Soil Dynamics, Missouri Univ. of Science and Technology, Rolla, MO.
Iai, S., Tobita, T., and Nakahara, T. (2005). “Generalized scaling relations for dynamic centrifuge tests.” Geotechnique, 29(1), 105–118.
Iwasaki, Y., and Tai, M. (1996). “Strong motion records at Kobe Port Island.” Soils Found., 29–40.
Jiang, M., Leroueil, S., Zhu, H., Yu, S., and Konrad, J. (2009). “Two-dimensional discrete element theory for rough particles.” Int. J. Geomech., 9(1), 20–33.
Joyner, W., and Chen, A. (1975). “Calculation of nonlinear ground response in earthquakes.” Bull. Seismol. Soc. Am., 65(5), 1315–1336.
Joyner, W., Warrick, R., and Fumal, T. (1981). “The effect of quaternary alluvium on strong ground motion in the Coyote Lake, California, Earthquake of 1979.” Bull. Seismol. Soc. Am., 71(1), 1333–1349.
Karabalis, D., and Mohammadi, M. (1998). “3D dynamic foundation-soil-foundation interaction on layered soil.” Soil. Dyn. Earthquake Eng., 17(3), 139–152.
Kausel, E., and Roesset, J. (1975). “Dynamic stiffness of circular foundations.” J. Engrg. Mech. Div., 101(6), 771–785.
Kim, S., Holub, C., and Elnashai, A. (2011). “Analytical assessment of the effect of vertical earthquake motion on RC bridge piers.” J. Struct. Eng., 137(2), 252–260.
King, G., Dickin, E., and Lyndon, A. (1984). “The development of a medium size centrifugal testing facilities.” Proc., Symp. on the Application of Centrifuge Modeling to Geotechnical Design, Taylor & Francis, Manchester, U.K.
Kramer, S. (1996). Geotechnical earthquake engineering, Prentice Hall, Englewood Cliffs, NJ.
Kunar, R., Beresford, P., and Cundall, P. (1977). “A tested soil-structure model for surface structures.” Proc., Int. Symp. on Soil-Structure Interaction, Vol. 1, Roorkee Univ., Roorkee, India, 137–144.
Kutter, B. (1992). “Dynamic centrifuge modeling of geotechnical structures.” Transportation Research Record 1336, Transportation Research Board, Washington, DC, 24–30.
Lysmer, J., Roger, L., and Kuhlemeyer, A. (1969). “Finite dynamic model for infinite media.” J. Engrg. Mech. Div., 95(4), 858–877.
Lysmer, J., Tabatabie Raisi, M., Tajirian, F., and Ostadan, F. (1981). SASSI: A system for analysis of soil-structure interaction, Dept. of Civil Engineering, Univ. of California, Berkeley, CA.
Lysmer, J., Udaka, T., Tsai, C., and Seed, H. (1975). FLUSH: A computer program for approximate 3-D analysis of soil-structure interaction problems, Earthquake Engineering Research Center, Berkeley, CA.
Modarresi, H., and Benzenati, I. (1992). “An absorbing boundary element for dynamic analysis of two-phase media.” Proc., 10th World Conf. on Earthquake Engineering, International Association for Earthquake Engineering, Tokyo, 1157–1163.
Modaressi, H., and Foerster, E. (2000). Cyberquake: User’s manual, Bureau de Recherches Geologiques et Minieres (BRGM), France.
Mylonakis, G., Nikolaou, S., and Gazetas, G. (2006). “Footings under seismic loading: Analysis and design issues with emphasis on bridge foundations.” Soil. Dyn. Earthquake Eng., 26(9), 824–853.
Ostadan, F., Chen, C., and Lysmer, J. (2000). SASSI2000: A system for analysis of soil-structure interaction, Dept. of Civil Engineering, Univ. of California, Berkeley, CA.
O’Sullivan, C. (2011). “Particle-based discrete element modeling: A geomechanics perspective.” Int. J. Geomech., 11(6), 449–464.
Papazoglou, A., and Elnashai, A. (1996). “Analytical and field evidence of the damaging effect of vertical earthquake ground motion.” Earthquake Eng. Struct. Dynam., 25(10), 1109–1137.
Particle Flow Code PFC3D 3.1 [Computer software]. Minneapolis, Itasca Consulting Group.
Pitilakis, D., Dietz, M., Wood, D., Clouteau, D., and Modaressi, A. (2008). “Numerical simulation of dynamic soil-structure interaction in shaking table testing.” Soil. Dyn. Earthquake Eng., 28(6), 453–467.
Pyke, R., Seed, B., and Chan, C. (1975). “Settlement of sands under multidirectional shaking.” J. Geotech. Engrg. Div., 101(4), 379–398.
Rayhani, M., and El Naggar, M. (2008). “Seismic response of sands in centrifuge tests.” Can. Geotech. J., 45(4), 470–483.
Seed, H., and Idriss, I. (1988). “The Mexico earthquake of September 19, 1985 relationships between soil conditions and earthquake ground motions.” Earthq. Spectra, 4(4), 687–729.
Seed, H., Murarka, R., Lysmer, J., and Idriss, I. (1976). “Relationships of maximum acceleration, maximum velocity, distance from source, and local site conditions for moderately strong earthquakes.” Bull. Seismol. Soc. Am., 66(4), 1323–1342.
Stuart, J. (1962). “Interference between foundations with special reference to surface footings in sand.” Geotechnique, 12(1), 15–23.
Trifunac, M., and Todorovska, M. (1996). “Nonlinear soil response—1994 Northridge, California, earthquake.” J. Geotech. Eng., 122(9), 725–735.
Uyanik, O. (2010). “Compressional and shear-wave velocity measurements in unconsolidated top-soil and comparison of the results.” Int. J. Phys. Sci., 5(7), 1034–1039.
White, W., Villiappan, S., and Lee, I. (1977). “Unified boundary for finite dynamic models.” J. Engrg. Mech. Div., 103(5), 949–964.
Wolf, J. (1985). Dynamic soil-structure interaction, Prentice Hall, Englewood Cliffs, NJ.
Wolf, J. P. (1994). Simple physical models for foundation vibrations, Prentice Hall, Englewood Cliffs, NJ.
Yang, J., Sato, T., Savidis, S., and Li, X. (2002). “Horizontal and vertical components of earthquake ground motions at liquefiable sites.” Soil. Dyn. Earthquake Eng., 22(3), 229–240.
Zamani, N. (2012). “Coupled microscale framework for the seismic response of soil-foundation-structure systems.” Ph.D. thesis, Southern Methodist Univ., Dallas.
Zamani, N., and El Shamy, U. (2011). “Analysis of wave propagation in dry granular soils using DEM simulations.” Acta Geotech., 6(3), 167–182.
Information & Authors
Information
Published In
International Journal of Geomechanics
Volume 13 • Issue 5 • October 2013
Pages: 595 - 610
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Nov 29, 2011
Accepted: Aug 9, 2012
Published online: Aug 23, 2012
Published in print: Oct 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.