Postliquefaction Undrained Shear Behavior of Sand-Silt Mixtures at Constant Void Ratio
Publication: International Journal of Geomechanics
Volume 13, Issue 4
Abstract
A detailed study on the postliquefaction undrained shear behavior of sand-silt mixtures at constant void ratios is presented in this article. The influence of different parameters such as density, amplitude of cyclic shear stress, and drainage conditions on the postliquefaction undrained response of sand-silt mixtures has been investigated, in addition to the effect of fines content. The results showed that the limiting silt content plays a vital role in the strength of the soil under both cyclic and monotonic shear loading. Both the liquefaction resistance and postliquefaction shear strength of the soils are found to decrease with an increase in the fines content until the limiting silt content is reached. However, further increase in the silt content beyond the limiting silt content increases the liquefaction resistance as well as the postliquefaction shear strength of the soils. It is also observed that these variations on the liquefaction and postliquefaction resistance of soils are closely related to the variations in relative density.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors acknowledge the financial support provided by the Ministry of Earth Sciences, formerly the Ministry of Science and Technology (Seismology Division), Government of India, for carrying out the research work reported in this technical paper. The authors also acknowledge the two anonymous reviewers for their careful and constructive views, which significantly improved the manuscript.
References
Andrews, D. C. A., and Martin, G. R. (2000). “Criteria for liquefaction of silty soils.” Proc., 12th WCEE 2000 Conf., New Zealand Society for Earthquake Engineering, Upper Hutt, NZ, 1–8.
ASTM. (1996). “Standard test method for load controlled cyclic triaxial strength of soil.” D5311-92, West Conshohocken, PA.
Bartlett, S., and Youd, L. (1992). “Empirical prediction of lateral spread displacements.” Proc., US-Japan Workshop, National Center for Earthquake Engineering Research, Buffalo, NY, 351–365.
Bouferra, R., Benseddiq, N., and Shahrour, I. (2007). “Saturation and preloading effects on the cyclic behavior of sand.” Int. J. Geomech., 7(5), 396–401.
Bureau of Indian Standards (IS). (1980). “Methods of test for soils: Determination of specific gravity, part-3.” IS 2720, New Delhi, India.
Bureau of Indian Standards (IS). (1983). “Methods of test for soils: Determination of density index (relative density) of cohesionless soils, part-14.” IS 2720, New Delhi, India.
Byrne, P. (1990). “A model for predicting liquefaction induced displacements.” Soil Mechanics Series No. 147, Dept. of Civil Engineering, Univ. of British Columbia, Vancouver, Canada.
Chameau, J. L., and Sutterer, K. (1994). “Influence of fines in liquefaction potential and steady state considerations.” Proc., 13th Int. Conf. on Soil Mechanics and Foundation Engineering, Taylor & Francis, New Delhi, India, 183–184.
Chang, N. Y. (1990). “Influence of fines content and plasticity on earthquake-induced soil liquefaction.” Contract Rep. DACW3988-C-0078, Waterways Experiment Station, Vicksburg, MS.
Dash, H. K. (2008). “Undrained cyclic and monotonic response of sand-silt mixtures.” Ph.D. thesis, Indian Institute of Science, Bangalore, India.
Dash, H. K., and Sitharam, T. G. (2009). “Undrained cyclic pore pressure response of sand-silt mixtures: Effect of nonplastic fines and other parameters.” J. Geotech. Geol. Eng., 27(4), 501–517.
Dash, H. K., Sitharam, T. G., and Baudet, B. (2010). “Influence of non-plastic fines on the response of a silty sand to cyclic loading.” Soils Found., 50(5), 695–704.
Desai, C. S. (2000). “Evaluation of liquefaction using disturbed state and energy approaches.” J. Geotech. Geol. Eng., 126(7), 618–631.
El Shamy, U., et al. (2010). “Micromechanical aspects of liquefaction-induced lateral spreading.” Int. J. Geomech., 10(5), 190–201.
Hamada, M., Towhata, I., Yasuda, S., and Isoyama, R. (1987). “Study on permanent ground displacement induced by seismic liquefaction.” Comput. Geotech., 4(4), 197–220.
Hazirbaba, K. (2005). “Pore pressure generation characteristics of sands and silty sands: A strain approach.” Ph.D. thesis, Univ. of Texas, Austin, TX.
Ishihara, K. (1993). “Liquefaction and flow failure during earthquakes.” Geotechnique, 43(3), 351–415.
Jakka, R. S., Datta, M., and Ramana, G. V. (2010). “Liquefaction behaviour of loose and compacted pond ash.” Soil. Dyn. Earthquake Eng., 30(7), 580–590.
Koester, J. P. (1994). “The influence of fines type and content on cyclic strength.” Ground failures under seismic conditions, ASCE, New York, 17–33.
Kokusho, T., Hara, T., and Hiraoka, R. (2004). “Undrained shear strength of granular soils with different particle gradations.” J. Geotech. Geoenviron. Eng., 130(6), 621–629.
Kuerbis, R., Negussey, D., and Vaid, Y. P. (1988). “Effect of gradation and fines content on the undrained response of sand.” Hydraulic fill structures, ASCE, New York, 330–345.
Mroz, Z., Boukpeti, N., and Drescher, A. (2003). “Constitutive model for static liquefaction.” Int. J. Geomech., 3(2), 133–144.
Park, I. J., and Desai, C. S. (2000). “Cyclic behavior and liquefaction of sand using disturbed state concept.” J. Geotech. Geoenviron. Eng., 126(9), 834–846.
Pitman, T. D., Robertson, P. K., and Sego, D. C. (1994). “Influence of fines on the collapse of loose sands.” Can. Geotech. J., 31(5), 728–739.
Polito, C. P., and Martin, J. R., II. (2001). “Effects of nonplastic fines on the liquefaction resistance of sands.” J. Geotech. Geoenviron. Eng., 127(5), 408–415.
Singh, S. (1994). “Liquefaction characteristics of silts.” Ground failures under seismic conditions, ASCE, New York, 105–116.
Sitharam, T. G., and Dash, H. K. (2009). “Effect of initial gross void ratio on cyclic response of sand-silt mixtures.” Int. J. Geotech. Eng., 3(1), 1–10.
Sitharam, T. G., Vinod, J. S., and Ravishankar, B. V. (2009). “Post-liquefaction undrained monotonie behaviour of sands: Experiments and DEM simulations.” Geotechnique, 59(9), 739–749.
Thevanayagam, S. (1998). “Effects of fines and confining stress on undrained shear strength of silty sands.” J. Geotech. Geoenviron. Eng., 124(6), 479–491.
Thevanayagam, S. (2007a). “Intergrain contact density indices for granular mixes-I: Framework.” Earthquake Eng. Eng. Vib., 6(2), 123–134.
Thevanayagam, S. (2007b). “Intergrain contact density indices for granular mixes-II: Liquefaction resistance.” Earthquake Eng. Eng. Vib., 6(2), 135–146.
Thevanayagam, S., and Mohan, S. (2000). “Intergranular state variables and stress-strain behaviour of silty sands.” Geotechnique, 50(1), 1–23.
Toyoto, N., Yasuhara, K., Murakami, S., and Hyde, A. F. L. (1995). “Post cyclic triaxial behaviour of Toyoura sand.” Proc., 1st Int. Conf. on Earthquake Geotechnical Engineering, TC4, ISSMGE, London, 189–195.
Tsuchida, H. (1970). “Prediction and counter measure against the liquefaction in sand deposits.” Proc., Seminar Abstract in: Port Harbour Research Institute, Ministry of Transport, Yokosuka, Japan, 3.1–3.33.
Vaid, Y. P. (1994). “Liquefaction of silty soils.” Ground failures under seismic conditions, ASCE, New York, 1–16.
Vaid, Y. P., and Thomas, J. (1995). “Liquefaction and postliquefaction behavior of sand.” J. Geotech. Eng., 121(2), 163–173.
Yamamuro, J. A., and Lade, P. V. (1998). “Steady-state concepts and static liquefaction of silty sands.” J. Geotech. Geoenviron. Eng., 124(9), 868–877.
Youd, T. L., Hansen, C. M., and Bartlett, S. F. (2002). “Revised multilinear regression equations for prediction of lateral spread displacement.” J. Geotech. Geoenviron. Eng., 128(12), 1007–1017.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Jun 28, 2011
Accepted: May 16, 2012
Published online: Jul 15, 2013
Published in print: Aug 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.