Coupled Hydro-Mechanical Elastoplastic Constitutive Model for Unsaturated Sands and Silts. II: Integration, Calibration, and Validation
Publication: International Journal of Geomechanics
Volume 12, Issue 3
Abstract
Following the comprehensive model formulation given in Part I, a fully implicit integration procedure for the rate equations using a closest point projection method is presented in this paper. The stress-update algorithm and calibration procedure for all the model parameters are discussed in detail. Two sets of laboratory test results, one from unsaturated Minco silt and another one from Toyoura sand, are used to validate the proposed model. The model is shown to have the ability to capture the coupling effects between hydro- and mechanical behavior and predict the laboratory tests reasonably well.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the U.S. National Science Foundation (Grant No. CMS-0301457) and the Oklahoma Center for the Advancement of Science and Technology (Project No. AR081-045).
References
Alawaji, H. A. S., Runesson, K., and Sture, S. (1991). “Integration of constitutive equations in soil plasticity.” J. Eng. Mech.JENMDT, 117(8), 1771–1790.
Borja, R. I., and Lee, S. R. (1990). “Cam-clay plasticity, Part I: Implicit integration of elasto-plastic constitutive relations.” Comput. Methods Appl. Mech. Eng.CMMECC, 78(1), 49–72.
Borja, R. I. (1991). “Cam-clay plasticity, Part II: Implicit integration of constitutive equation based on a nonlinear elastic stress predictor.” Comput. Methods Appl. Mech. Eng.CMMECC, 88(2), 225–240.
Braudel, H. J., Abouaf, M., and Chenot, J. L. (1986). “An implicit and incremental formulation for the solution of elastoplastic problems by the finite element method.” Comput. Struct., 22(5), 801–814.CMSTCJ
Deshpande, S. D. (1997). “Static and dynamic centrifuge modeling of unsaturated soil embankment.” M.S. thesis, School of Civil Engineering and Environmental Science, Univ. of Oklahoma, Norman, OK.
Jeremic, B., and Sture, S. (1997). “Implicit integrations in elastoplastic geotechnics.” Mech. Cohes.-Frict. MaterMCFMFA, 2(2), 165–183.
Liu, C., and Muraleetharan, K. K. (2012). “Coupled hydro-mechanical elastoplastic constitutive model for unsaturated sands and silts. I: Formulation.” Int. J. Geomech., 12(3), 239–247.IJGNAI
Macari, E. J., Hoyos, L. R., and Arduino, P. (2003). “Constitutive modeling of unsaturated soil behavior under axisymmetric stress states using a stress/suction-controlled cubical test cell.” Int. J. Plast., 19(10), 1481–1515.IJPLER
Macari, E. J., Weihe, S., and Arduino, P. (1997). “Implicit integration of elastoplastic constitutive Models for frictional materials with highly non-linear hardening functions.” Mech. Cohes.-Frict. MaterMCFMFA, 2(1), 1–29.
Manzari, M. T., and Prachathananukit, R. (2001). “On integration of a cyclic soil plasticity model.” Int. J. Numer. Anal. Methods Geomech., 25(6), 525–549.IJNGDZ
Oda, M., Koishikawa, I., and Higuchi, T. (1978). “Experimental study of anisotropic shear strength of sand by plane strain test.” Soil Found., 18(1), 25–38.
Ortiz, M., and Popov, E. P. (1985). “Accuracy and stability of integration algorithms for elastoplastic constitutive relations.” Int. J. Numer. Methods Eng.IJNMBH, 21(9), 1561–1576.
Simo, J. C., and Ortiz, M. A. (1985). “A unified approach to finite deformation elastoplastic analysis based on the use of hyperelastic constitutive equations.” Comput. Methods Appl. Mech. Eng., 49(2), 221–245.CMMECC
Simo, J. C., and Taylor, R. L. (1985). “Consistent tangent operators for rate-independent elasto-plasticity.” Comput. Methods Appl. Mech. Eng., 48(1), 101–118.CMMECC
Uchida, K., and Stedman, J. D. (2001). “Liquefaction behavior of Toyoura sand under cyclic strain controlled triaxial loading.” Proc. 11th Int. Offshore Polar Engng. Conf., Stavanger, Norway.
Unno, T., Kazama, M., Uzuoka, R., and Sento, N. (2008). “Liquefaction of unsaturated sand considering the pore air pressure and volume compressibility of the soil particle skeleton.” Soil Found., 48(1), 87–99.
Verdugo, R., and Ishihara, K. (1996). “The steady state of sandy soils.” Soil Found., 36(2), 81–91.
Vermeer, P. A. (1978). “A double hardening model for sands.” Geotechnique, 28(4), 413–433.GTNQA8
Vinayagam, T. (2004). “Understanding the stress-strain behavior of unsaturated Minco silt using laboratory testing and constitutive modeling.” M.S. thesis, School of Civil Engineering and Environmental Science, Univ. of Oklahoma, Norman, OK.
Yang, Y., Muraleetharan, K. K., and Yu, H. S. (2008). “Generalized trapezoidal numerical integration of an advanced soil model.” Int. J. Numer. Anal. Methods Geomech., 32(1), 43–64.IJNGDZ
Information & Authors
Information
Published In
Copyright
© 2012. American Society of Civil Engineers.
History
Received: Jul 28, 2010
Accepted: May 19, 2011
Published online: May 23, 2011
Published in print: Jun 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.