Numerical Simulation of a Lab-Scale Molten-Salt External Solar Receiver and Its Experimental Validation
Publication: Journal of Energy Engineering
Volume 147, Issue 1
Abstract
In this work, a lab-scale external receiver with a xenon lamp set was designed to study optical and thermodynamic properties, and its benchmark was also introduced. Eighteen stainless-steel tubes were placed on the receiver to absorb radiant energy from the xenon lamps and achieve light-to-heat conversion. The indirect method was used to obtain the optical efficiency of the xenon lamp setup, and the heat-flux distribution on the surface of the receiver had an average heat flux of . Furthermore, the experimental method was used to study the temperature change of the receiver during the startup, stabilization, and shutdown of the receiver. A numerical simulation was conducted using commercially available software with the realizable model and the discrete ordinates model as the radiative transfer equation to valid the experimental result. The temperatures of the back and front of the receiver were obtained by thermocouples and an infrared thermal imager, respectively. The temperature of the back of the receiver rose rapidly after the lamps were turned on, and the temperature of the heat receiver remained unchanged when it was stable. The velocity of the molten salt was also studied, and the maximum speed was . The temperature increases of the experiment and simulation were approximately 4°C and 4.2°C, respectively, and the temperature of the tube wall was 40°C higher than that of the molten salt. The comparison of the experiment results indicate that the deviation between the receiver’s back temperatures in the simulation and experiment was basically within 5%, indicating consistency, and the thermal efficiency of the receiver was approximately 85%.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the published article.
Acknowledgments
This work is supported by China National Fund for Distinguished Young Scholars (No. 51825605).
References
Agalit, H., N. Zari, M. Maalmi, and M. Maaroufi. 2015. “Numerical investigations of high temperature packed bed TES systems used in hybrid solar tower power plants.” Sol. Energy 122 (Dec): 603–616. https://doi.org/10.1016/j.solener.2015.09.032.
Ardekani, M. M., K. J. Craig, and J. P. Meyer. 2017. “Combined thermal, optical and economic optimization of a linear Fresnel collector.” In Vol. 1850 of Proc., American Institute of Physics Conf., 040004. Melville, NY: American Institute of Physics Publishing.
Du, B.-C., Y. L. He, Z. J. Zheng, and Z. D. Cheng. 2016. “Analysis of thermal stress and fatigue fracture for the solar tower molten salt receiver.” Appl. Therm. Eng. 99: 741–750.
Fernández-Torrijos, M., C. Marugán-Cruz, C. Sobrino, and D. Santana. 2017. “Heat transfer experiments with a central receiver tube subjected to unsteady and non-uniform heat flux.” In Vol. 1850 of Proc., American Institute of Physics Conf., 150002. Melville, NY: American Institute of Physics Publishing.
Gaggioli, W., F. Fabrizi, L. Rinaldi, and P. Di Ascenzi. 2017. “Experimental tests about the cooling/freezing of the molten salts in the receiver tubes of a solar power plant with parabolic trough.” In Vol. 1850 of Proc., American Institute of Physics Conf., 020005. Melville, NY: American Institute of Physics Publishing.
Han, X., C. Xu, X. Ju, X. Du, and G. Wei. 2017. “Parameter optimization of a hybrid solar concentrating photovoltaic/concentrating solar power (CPV/CSP) system.” In Vol. 1850 of Proc., American Institute of Physics Conf., 030024. Melville, NY: American Institute of Physics Publishing.
Ho, C. K. 2017. “Advances in central receivers for concentrating solar applications.” Sol. Energy 152 (Aug): 38–56. https://doi.org/10.1016/j.solener.2017.03.048.
Ho, C. K., S. S. Khalsa, D. D. Gill, and C. A. Sims. 2011. “Evaluation of a new tool for heliostat field flux mapping.” In Proc., SolarPACES, 20–23. Washington, DC: USDOE National Nuclear Security Administration. https://www.osti.gov/servlets/purl/1140911.
Irfan, M. A., and W. Chapman. 2009. “Thermal stresses in radiant tubes due to axial, circumferential and radial temperature distributions.” Appl. Therm. Eng. 29 (10): 1913–1920. https://doi.org/10.1016/j.applthermaleng.2008.08.021.
Jamaluddin, A. S., and P. J. Smith. 1992. “Discrete-ordinates solution of radiative transfer equation in nonaxisymmetric cylindrical enclosures.” J. Thermophys. Heat Transfer 6 (2): 242–245. https://doi.org/10.2514/3.351.
Jaramillo, O. A., C. A. Pérez-Rábago, C. A. Arancibia-Bulnes, and C. A. Estrada. 2008. “A flat-plate calorimeter for concentrated solar flux evaluation.” Renewable Energy 33 (10): 2322–2328. https://doi.org/10.1016/j.renene.2008.01.020.
Johnston, G. 1998. “Focal region measurements of the tiled dish at the Australian National University.” Sol. Energy 63 (2): 117–124. https://doi.org/10.1016/S0038-092X(98)00041-3.
Li, X., W. Kong, Z. Wang, C. Chang, and F. Bai. 2010. “Thermal model and thermodynamic performance of molten salt cavity receiver.” Renewable Energy 35 (5): 981–988. https://doi.org/10.1016/j.renene.2009.11.017.
Liao, Z., and A. Faghri. 2016. “Thermal analysis of a heat pipe solar central receiver for concentrated solar power tower.” Appl. Therm. Eng. 102 (Jun): 952–960. https://doi.org/10.1016/j.applthermaleng.2016.04.043.
Litwin, R. Z. 2002. Receiver system: Lessons learned from solar two receiver system: Lessons learned from solar two. Canoga Park, CA: Boeing Company.
Lüpfert, E., K. Pottler, S. Ulmer, K.-J. Riffelmann, A. Neumann, and B. Schiricke. 2007. “Parabolic trough optical performance analysis techniques.” J. Sol. Energy Eng. 129 (2): 147. https://doi.org/10.1115/1.2710249.
Maadi, S. R., M. Khatibi, E. Ebrahimnia-Bajestan, and D. Wood. 2019. “Coupled thermal-optical numerical modeling of PV/T module: Combining CFD approach and two-band radiation DO model.” Energy Convers. Manage. 198 (Oct): 111781. https://doi.org/10.1016/j.enconman.2019.111781.
Madadi Avargani, V., A. Rahimi, and T. Tavakoli. 2016. “Exergetic optimization and optimum operation of a solar dish collector with a cylindrical receiver.” J. Energy Eng. 142 (4): 1–11. https://doi.org/10.1061/%28ASCE%29EY.1943-7897.0000322.
Marugán-Cruz, C., O. Flores, D. Santana, and M. García-Villalba. 2016. “Heat transfer and thermal stresses in a circular tube with a non-uniform heat flux.” Int. J. Heat Mass Transfer 96 (May): 256–266. https://doi.org/10.1016/j.ijheatmasstransfer.2016.01.035.
Okonkwo, E. C., M. Abid, and T. A. H. Ratlamwala. 2019. “Comparative study of heat transfer enhancement in parabolic trough collector based on modified absorber geometry.” J. Energy Eng. 145 (3): 1–16. https://doi.org/10.1061/(ASCE)EY.1943-7897.0000602.
Petrasch, J., P. Coray, A. Meier, M. Brack, P. Häberling, D. Wuillemin, and A. Steinfeld. 2007. “A novel 50 kW 11,000 suns high-flux solar simulator based on an array of xenon arc lamps.” J. Sol. Energy Eng. 129 (4): 405–411. https://doi.org/10.1115/1.2769701.
Qiu, Y., M. Li, W. Wang, B. Du, and K. Wang. 2018. “An experimental study on the heat transfer performance of a prototype molten-salt rod baffle heat exchanger for concentrated solar power.” Energy 156 (Aug): 63–72. https://doi.org/10.1016/j.energy.2018.05.040.
Reilly, H. E., and G. J. Kolb. 2001. An evaluation of molten-salt power towers including results of the solar two project. Albuquerque, NM: Sandia National Laboratories.
Riffelmann, K. J., A. Neumann, and S. Ulmer. 2006. “Performance enhancement of parabolic trough collectors by solar flux measurement in the focal region.” Sol. Energy 80 (10): 1303–1313. https://doi.org/10.1016/j.solener.2005.09.001.
Rodríguez-Sánchez, M. R., C. Marugan-Cruz, A. Acosta-Iborra, and D. Santana. 2014. “Comparison of simplified heat transfer models and CFD simulations for molten salt external receiver.” Appl. Therm. Eng. 73 (1): 993–1005. https://doi.org/10.1016/j.applthermaleng.2014.08.072.
Rodríguez-Sánchez, M. R., A. Sánchez-González, A. Acosta-Iborra, and D. Santana. 2017a. “Variable velocity in solar external receivers.” In Vol. 1850 of Proc., American Institute of Physics Conf., 030043. Melville, NY: American Institute of Physics Publishing.
Rodríguez-Sanchez, M. R., M. Venegas Bernal, C. Marugán Cruz, and D. Santana. 2017b. “Thermal, mechanical and hydrodynamic analysis to optimize the design of molten salt central receivers of solar tower power plants.” Renewable Energy Power Qual. J. 1 (11): 128–133.
Samanes, J., and J. Garcia-Barberena. 2014. “A model for the transient performance simulation of solar cavity receivers.” Sol. Energy 110 (Dec): 789–806. https://doi.org/10.1016/j.solener.2014.10.015.
Schiricke, B., R. Pitz-Paal, E. Lüpfert, A. Neumann, K. Pottler, M. Pfänder, and K.-J. Riffelmann. 2007. “Validation of optical modeling of parabolic trough collectors by flux measurement.” In Proc., Energy Sustainability Conf. 2007, 1–6. New York: ASME. https://doi.org/10.1115/ES2007-36216.
Wang, F., Y. Shuai, Y. Yuan, and B. Liu. 2012. “Effects of material selection on the thermal stresses of tube receiver under concentrated solar irradiation.” Mater. Des. 33 (1): 284–291. https://doi.org/10.1016/j.matdes.2011.07.048.
Wang, F., Y. Shuai, Y. Yuan, G. Yang, and H. Tan. 2010. “Thermal stress analysis of eccentric tube receiver using concentrated solar radiation.” Sol. Energy 84 (10): 1809–1815. https://doi.org/10.1016/j.solener.2010.07.005.
Wang, P., J. B. Li, F. W. Bai, D. Y. Liu, C. Xu, L. Zhao, and Z. F. Wang. 2017. “Experimental and theoretical evaluation on the thermal performance of a windowed volumetric solar receiver.” Energy 119 (Jan): 652–661. https://doi.org/10.1016/j.energy.2016.11.024.
Xu, T., G. Zhang, C. Peniguel, Z. Liao, X. Li, J. Lu, and Z. Wang. 2017. “Numerical study of cold filling and tube deformation in the molten salt receiver.” In Vol. 1850 of Proc., American Institute of Physics Conf., 070007. Melville, NY: American Institute of Physics Publishing.
Yang, M., X. Yang, X. Yang, and J. Ding. 2010. “Heat transfer enhancement and performance of the molten salt receiver of a solar power tower.” Appl. Energy 87 (9): 2808–2811. https://doi.org/10.1016/j.apenergy.2009.04.042.
Zhang, Q., X. Li, C. Chang, Z. Wang, and H. Liu. 2013. “An experimental study: Thermal performance of molten salt cavity receivers.” Appl. Therm. Eng. 50 (1): 334–341. https://doi.org/10.1016/j.applthermaleng.2012.07.028.
Zou, C., Y. Zhang, Q. Falcoz, P. Neveu, C. Zhang, W. Shu, and S. Huang. 2017a. “Design and optimization of a high-temperature cavity receiver for a solar energy cascade utilization system.” Renewable Energy 103 (Apr): 478–489. https://doi.org/10.1016/j.renene.2016.11.044.
Zou, C., Y. Zhang, H. Feng, Q. Falcoz, P. Neveu, W. Gao, and C. Zhang. 2017b. “Effects of geometric parameters on thermal performance for a cylindrical solar receiver using a 3D numerical model.” Energy Convers. Manage. 149 (Oct): 293–302. https://doi.org/10.1016/j.enconman.2017.06.088.
Information & Authors
Information
Published In
Journal of Energy Engineering
Volume 147 • Issue 1 • February 2021
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Mar 30, 2020
Accepted: Aug 5, 2020
Published online: Oct 19, 2020
Published in print: Feb 1, 2021
Discussion open until: Mar 19, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.