Predicting the Heat Release Rate of Ion Current Combustion Process Fuelled with Hydrogen/Carbon Dioxide and Natural Gas
Publication: Journal of Energy Engineering
Volume 145, Issue 1
Abstract
The effects of initial pressure, equivalence ratio, hydrogen fraction, and dilution ratio on the characteristics of ion currents and heat release rate (HRR) were comparatively investigated with natural gas as a fuel. Ion currents were measured with a central electrode; chamber pressure was measured with a pressure sensor, and HRR was calculated based on the measured pressure data. The feature parameters of the ion current and HRR correspond with each other; the start time, peak time, duration time, and peak values of the ion current and HRR have the same variation under the initial conditions. The interdependency between these parameters was discussed in detail. This study indicates that a good correlation exists between the characteristic parameters of the ion current and HRR under different initial conditions. The characteristic parameters of ion currents can be directly used to predict and analyze the HRR and the response dynamics of a flame in the combustion process.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work is supported by National Natural Science Foundation of China (No. 51676011).
References
Auzins, J., H. Johansson, and J. Nytomt. 1995. Ion-gap sense in misfire detection, knock and engine control. New York: SAE International.
Badawy, T., N. Rai, J. Singh, W. Bryzik, and N. Henein. 2011. “Effect of design and operating parameters on the ion current in a single-cylinder diesel engine.” Int. J. Engine Res. 12 (6): 601–616. https://doi.org/10.1177/1468087411412033.
Binjuwair, S., T. I. Mohamad, A. Almaleki, A. Alkudsi, and I. Alshunaifi. 2015. “The effects of research octane number and fuel systems on the performance and emissions of a spark ignition engine: A study on Saudi Arabian RON91 and RON95 with port injection and direct injection systems.” Fuel 158: 351–360. https://doi.org/10.1016/j.fuel.2015.05.041.
Dakhil, S. F., and T. A. Gabbar. 2012. “Study the effect of initial temperature and equivalence ratio on the pre–mixed flame propagation.” Basrah J. Eng. Sci. 12 (2): 88–101.
Dinesh, K. R., H. Shalaby, K. H. Luo, J. A. Van Oijen, and D. Thévenin. 2017. “Heat release rate variations in high hydrogen content premixed syngas flames at elevated pressures: Effect of equivalence ratio.” Int. J. Hydrogen Energy 42 (10): 7029–7044. https://doi.org/10.1016/j.ijhydene.2016.11.205.
Dong, G., Y. Chen, Z. Wu, L. Li, and R. Dibble. 2015. “Study on the phase relation between ion current signal and combustion phase in an HCCI combustion engine.” Proc. Combust. Inst. 35 (3): 3097–3105. https://doi.org/10.1016/j.proci.2014.08.033.
Fang, J., X. Wu, H. Duan, C. Li, and Z. Gao. 2015. “Effects of electric fields on the combustion characteristics of lean burn methane-air mixtures.” Energies 8 (4): 2587–2605. https://doi.org/10.3390/en8042587.
Gao, Z., X. Wu, H. Gao, B. Liu, J. Wang, X. Meng, and Z. Huang. 2010. “Investigation on characteristics of ionization current in a spark-ignition engine fueled with natural gas-hydrogen blends with BSS de-noising method.” Int. J. Hydrogen Energy 35 (23): 12918–12929. https://doi.org/10.1016/j.ijhydene.2010.08.129.
Gao, Z., X. Wu, Z. Huang, S. Yoshiyama, E. Tomita, K. Yamazaki, and T. Higashi. 2013. “The interdependency between the maximal pressure and ion current in a spark-ignition engine.” Int. J. Engine Res. 14 (4): 320–332. https://doi.org/10.1177/1468087412456512.
García, M. T., F. J. Jiménez-Espadafor Aguilar, and T. Sánchez Lencero. 2009. “Combustion characteristics, emissions and heat release rate analysis of a homogeneous charge compression ignition engine with exhaust gas recirculation fuelled with diesel.” Energy Fuels 23 (5): 2396–2404. https://doi.org/10.1021/ef801010m.
Gürbüz, H. 2016. “Experimental evaluation of combustion parameters with ion-current sensor integrated to fast response thermocouple in SI engine.” J. Energy Eng. 143 (2): 04016046. https://doi.org/10.1061/(ASCE)EY.1943-7897.0000401.
Heywood, J. B. 1988. Internal combustion engine fundamentals. New York: McGraw-Hill.
Huang, Z., Y. Zhang, K. Zeng, B. Liu, Q. Wang, and D. Jiang. 2007. “Natural gas–hydrogen–air premixed mixture combustion with a constant volume bomb.” Energy Fuels 21 (2): 692–698. https://doi.org/10.1021/ef0603131.
Jerzak, W. 2014. “The effect of adding CO2 to the axis of natural gas combustion flame on the variations in CO and NOx concentrations in the combustion chamber.” J. Power Technol. 94 (3): 202–210.
Kosmadakis, G. M., F. Moreno, J. Arroyo, M. Muñoz, and C. D. Rakopoulos. 2015. “Combustion analysis of a spark-ignition engine fueled on methane-hydrogen blend with variable equivalence ratio using a computational fluid dynamics code.” J. Energy Eng. 142 (2): E4015002. https://doi.org/10.1061/(ASCE)EY.1943-7897.0000300.
Labuda, S., J. Sotton, M. Bellenoue, A. P. Chernukho, and A. N. Migoun. 2011. “Application of ionization probes for diagnostics of knocking combustion.” In Proc., 7th Mediterranean Combustion Symp. Sardinia, Italy: Chia Laguna.
Lakshminarayanan, P. A., Y. V. Aghav, A. D. Dani, and P. S. Mehta. 2002. “Accurate prediction of the rate of heat release in a modern direct injection diesel engine.” Proc. Inst. Mech. Eng. Part D: J. Automobile Eng. 216 (8): 663–675. https://doi.org/10.1177/095440700221600805.
Li, M., Q. Zhang, and G. Li. 2015. “Emission characteristics of a natural gas engine operating in lean-burn and stoichiometric modes.” J. Energy Eng. 142 (3): 04015039. https://doi.org/10.1061/(ASCE)EY.1943-7897.0000304.
Liu, F., H. Guo, and G. J. Smallwood. 2003. “The chemical effect of replacement of in air on the burning velocity of and premixed flames.” Combust. Flame 133 (4): 495–497. https://doi.org/10.1016/S0010-2180(03)00019-1.
Mack, J. H., R. H. Butt, Y. Chen, J. Y. Chen, and R. W. Dibble. 2016. “Experimental and numerical investigation of ion signals in boosted HCCI combustion using cesium and potassium acetate additives.” Energy Convers. Manage. 108: 181–189. https://doi.org/10.1016/j.enconman.2015.11.012.
Mao, C., X. M. Wu, Z. Q. Gao, X. W. Meng, Z. H. Huang, and Y. F. Lou. 2011. “Relationship between ionization current in post-flame and temperature around electrodes.” Trans. CSICE 29 (03): 260–265.
Nikolaou, Z. M., and N. Swaminathan. 2014. “Heat release rate markers for premixed combustion.” Combust. Flame 161 (12): 3073–3084. https://doi.org/10.1016/j.combustflame.2014.05.019.
Peerlings, L. B., V. N. Kornilov, and P. de Goey. 2013. “Flame ion generation rate as a measure of the flame thermo-acoustic response.” Combust. Flame 160 (11): 2490–2496. https://doi.org/10.1016/j.combustflame.2013.05.014.
Ramachandran, S. 2009. “Rapid thermodynamic simulation model of an internal combustion engine on alternate fuels.” In Vol. 2 of Proc., Int. Multiconf. of Engineers and Computer Scientists, 18–20. Hong Kong.
Rao, R., and D. Honnery. 2014. “The prediction of torque in a diesel engine using ion currents and artificial neural networks.” Int. J. Engine Res. 15 (3): 370–380. https://doi.org/10.1177/1468087413489567.
Rao, R., and D. Honnery. 2015. “A simplified mechanism for the prediction of the ion current during methane oxidation in engine-like conditions.” Combust. Flame 162 (7): 2928–2936. https://doi.org/10.1016/j.combustflame.2015.03.011.
Strandh, P., M. Christensen, J. Bengtsson, R. Johansson, A. Vressner, P. Tunestål, and B. Johansson. 2003. Ion current sensing for HCCI combustion feedback. New York: SAE International.
Tanaka, T., K. Narahara, M. Tabata, S. Yoshiyama, and E. Tomita. 2005. “Ion current measurement in a homogeneous charge compression ignition engine.” Int. J. Engine Res. 6 (5): 453–463. https://doi.org/10.1243/146808705X30413.
Vressner, A., P. Strandh, A. Hultqvist, P. Tunestål, and B. Johansson. 2004. Multiple point ion current diagnostics in an HCCI engine. New York: SAE International.
Wei, Z. L., C. W. Leung, C. S. Cheung, and Z. H. Huang. 2016. “Effects of equivalence ratio, addition on the heat release characteristics of premixed laminar biogas-hydrogen flame.” Int. J. Hydrogen Energy 41 (15): 6567–6580. https://doi.org/10.1016/j.ijhydene.2016.01.170.
Woschni, G. 1967. A universally applicable equation for the instantaneous heat transfer coefficient in the internal combustion engine. New York: SAE International.
Yadav, S. S., and K. K. Singh. 2015. “Simulation of working process and performance of a SI Engine using hydrogen and natural gas as a fuel (using GT-Power).” Int. J. Sci. Eng. Technol. 2 (2): 127–134. https://doi.org/10.5958/2395-3381.2015.00014.3.
Yoshiyama, S., E. Tomita, M. Mori, and Y. Sato. 2007. Ion current in a homogeneous charge compression ignition engine. New York: SAE International.
Zeng, W., H. Ma, Y. Liang, and E. Hu. 2015. “Experimental and modeling study on effects of and on ignition characteristics of methane/air mixture.” J. Adv. Res. 6 (2): 189–201. https://doi.org/10.1016/j.jare.2014.01.003.
Zhang, Q., M. Li, G. Li, and S. Shao. 2014. “Effects of injection parameters on the combustion and emission characteristics of diesel-piloted direct-injection natural gas engine during idle conditions.” J. Energy Eng. 141 (4): 04014043. https://doi.org/10.1061/(ASCE)EY.1943-7897.0000239.
Zheng, S., X. Zhang, J. Xu, and B. Jin. 2012. “Effects of initial pressure and hydrogen concentration on laminar combustion characteristics of diluted natural gas-hydrogen–air mixture.” Int. J. Hydrogen Energy 37 (17): 12852–12859. https://doi.org/10.1016/j.ijhydene.2012.05.089.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Jan 10, 2018
Accepted: May 30, 2018
Published online: Oct 18, 2018
Published in print: Feb 1, 2019
Discussion open until: Mar 18, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.