Modeling and Experimental Verification of a Straight-Through Evacuated Tube Installed on a Façade for Solar Space Heating
Publication: Journal of Energy Engineering
Volume 144, Issue 1
Abstract
Using solar energy for space heating is a promising technology to offset buildings’ energy consumption and reduce environmental pollution. Solar air heating system is free of freezing and inexpensive owing to its inherent simplicity in many circumstances. In this paper, the performance of a straight-through evacuated tube (ST tube) which opens on both ends for space heating, is studied. A thermal model for a single ST tube installed on a building façade for solar space heating using hot air was developed and an experimental measurement was conducted. The results predicted by the thermal model and experimental measurement agreed well, which confirms the validity of the thermal model. The performance and some aspects for practical application of the ST tubes for solar space heating are studied and discussed. The daily average efficiency of the ST tube was approximately 55% under the experimental conditions. The radiative thermal resistance from the absorber tube to the cover tube was almost equal to the total resistance, and the emissivity of coating on the outside surface of absorber tube had great effect on total heat loss. The cost and useful heat gains for a single room in a building in Beijing was studied. The payback period of this solar space heating system is approximately 8 years. The performance of solar collectors, including multiple ST tubes, will be studied in the next research.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research is supported by the national key project of the Ministry of Science and Technology, China, on “Green Buildings and Building Industrialization” through Grant No. 2016YFC0700500 and by the National Natural Science Foundation of China (No. 51406119).
References
Arkar, C., and Medved, S. (2015). “Optimization of latent heat storage in solar air heating system with vacuum tube air solar collector.” Sol. Energy, 111(1), 10–20.
Beekley, D. C., and Mather, G. R. (1978). Analysis and experimental tests of a high-performance evacuated tubular collector, U.S. Dept. of Energy, Washington, DC.
China National Standardization Administration Committee. (2005). “All-glass evacuated solar tubes.”, Beijing.
China Weather Bureau and Tsinghua University. (2005). Dedicated meteorological dataset to thermal environment analysis for buildings in China, China Architecture and Building Press, Beijing.
Dai, W. W., Wang, J., Su, Z. Y., Gong, G. J., and Zhang, Y. M. (2014). “Research on thermal performance of straight-through solar evacuated tube.” J. Southeast Univ., 44(1), 104–109 (in Chinese).
Duffie, J. A., and Beckman, W. A. (2013). Solar engineering of thermal processes, 4th Ed., Wiley, Hoboken, NJ.
Hakan, F., Oztop, N., Fatih, B., and Arif, H. (2013). “Energetic and exergetic aspects of solar air heating (solar collector) systems.” Renew. Sust. Energ. Rev., 21(5), 59–83.
Holman, J. P. (2010). Heat transfer: Empirical and practical relation convection heat transfer, 10th Ed., McGraw-Hill Education, New York.
Incropera, F. P., Dewitt, D. P., Bergman, T. L., and Lavine, A. S. (2007). Fundamentals of heat and mass transfer, Wiley, Hoboken, NJ.
Jiang, Y. (2015). Annual report of China building energy efficiency, China Architecture and Building Press, Beijing.
Moreau, A., and Laurencelle, F. (2012). “Field study of solar domestic water heaters in Quebec.” Energy Procedia, 30(11), 1331–1338.
Mussard, M. (2017). “Solar energy under cold climatic conditions: A review.” Renew. Sust. Energ Rev., 74(7), 733–745.
Papanicolaou, E., Belessiotis, V., Li, X., and Wang, Z. (2007). “Study of the thermal performance and air-flow features of a solar air heater with evacuated tubes.” Proc., ISES Solar World Congress 2007, Vol. IV, Tsinghua University Press, Beijing, 627–633.
Paradis, P. L., Rousse, D. R., Stéphane, H., Lamarche, L., and Quesada, G. (2015). “Thermal modeling of evacuated tube solar air collectors.” Sol. Energy, 115(5), 708–721.
Sabiha, M. A., Saidur, R., Mekhilef, S., and Mahian, O. (2015). “Progress and latest developments of evacuated tube solar collectors.” Renew. Sust. Energ. Rev., 51(11), 1038–1054.
Utzinger, D. M., Klein, S. A., and Mitchell, J. W. (1980). “The effect of air flow rate in collector-storage walls.” Sol. Energy, 25(6), 511–519.
Yuan, Y. L., Li, Y., Dai, Y. J., and Wang, R. Z. (2010). “Experimental study on thermal performance of evacuated tubular solar air collector with inserted tubes.” J. Sol. Energy, 31(11), 1429–1433 (in Chinese).
Zhu, T. T., Zhao, Y. H., Diao, Y. H., Li, F. F., and Quan, Z. H. (2017). “Experimental investigation and performance evaluation of a vacuum tube solar air collector based on micro heat pipe arrays.” J. Clean Prod., 142(1), 3517–3526.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jan 23, 2017
Accepted: Jul 11, 2017
Published online: Nov 23, 2017
Published in print: Feb 1, 2018
Discussion open until: Apr 23, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.