Effects of Stretch and Preferential Diffusion in Laminar Syngas Premixed Flames
Publication: Journal of Energy Engineering
Volume 143, Issue 5
Abstract
Syngas is considered a promising renewable fuel because of its superior emission characteristics and high flexibility with respect to its production and utilization. However, its composition can vary widely, which poses challenges with its use in practical systems. In this regard, fundamental studies dealing with its combustion and emission behavior can provide valuable input for designing such systems. This paper reports a computational study on the structure, thermal-diffusive instability, and extinction of syngas premixed counterflow flames. One-dimensional (1D) and two-dimensional (2D) simulations are performed using validated computational fluid dynamics (CFD)–based codes and a chemistry model with 52 species and 544 reactions. Results focus on the effects of stretch, preferential diffusion, and radiation on flame characteristics. The effect of preferential diffusion is to increase and decrease the peak heat release rate with strain rate for lean and rich syngas flames, respectively. Similarly, the flame temperature is higher and lower than the adiabatic flame temperature for lean and rich flames, respectively. In addition, for lean flames, the flame temperature exhibits nonmonotonic variation, first increasing and then decreasing with strain rate as the flame approaches extinction. At low strain rates (), the effect of radiation is to reduce flame temperature and burning rate and to cause extinction at very low strain rates. Thus, flame radiation leads to two extinction limits in terms of strain rates. Temporal evolution of the extinction process at high strain rates indicates that extinction starts locally near the centerline, and this region subsequently spreads radially until the flame extinguishes globally. Simulations are also used to examine correlations between stretch and burning rate. Lean flames are found to be diffusively unstable (), and their propensity toward instability increases as the mixture becomes leaner or content in syngas increases. Conversely, rich syngas flames are diffusively stable (), and their propensity toward instability decreases as the mixture becomes richer or content increases. These results are consistent with previous studies dealing with spherical flames burning and hydrocarbon fuels.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The author greatly appreciates many years of research collaborations with Dr. V. R. Katta (Innovative Scientific Solutions, Inc., Dayton, Ohio). All the simulations were performed by Mr. Cesare D’ippolito.
References
Aggarwal, S. K. (2009). “Extinction of laminar partially premixed flames.” Prog. Energy Combust. Sci., 35(6), 528–570.
Aggarwal, S. K., Bongiovanni, D., and Santarelli, M. (2015). “Extinction of laminar diffusion flames burning the anodic syngas fuel from solid oxide fuel cell.” Int. J. Hydrogen Energy, 40(22), 7214–7230.
Askari, O., Moghaddas, A., Alholm, A., Vien, K., Alhazmi, B., and Metghalchi, H. (2016). “Laminar burning speed measurement and flame instability study of H2/CO/air mixtures at high temperatures and pressures using a novel multi-shell mode.” Combust. Flame, 168(6), 20–31.
Aung, K. T., Hassan, M. I., and Faeth, G. M. (1997). “Flame/stretch interactions of laminar premixed hydrogen/air flames at normal temperature and pressure.” Combust. Flame, 109(1–2), 1–24.
Bouvet, N., Halter, F., Chauveau, C., and Yoon, Y. (2013). “On the effective Lewis number formulations for lean hydrogen/hydrocarbon/air mixtures.” Int. J. Hydrogen Energy, 38(14), 5949–5960.
Briones, A. M., Aggarwal, S. K., and Katta, V. R. (2006). “A numerical investigation of flame liftoff stabilization, and blowout.” Phys. Fluids, 18(4), .
Chelliah, H. K., Law, C. K., Ueda, T., Smooke, M. D., and Williams, F. A. (1990). “An experimental and theoretical investigation of the dilution, pressure and flow-field effects in the extinction conditions of methane air diffusion flames.” Proc. Combust. Inst., 23(1), 503–511.
Chemkin-Pro [Computer software]. ANSYS, San Diego.
Choi, S. K., Cho, E. S., and Chung, S. H. (2014). “Quantification of extinction mechanism in counterflow premixed flames.” J. Mech. Sci. Technol., 28(9), 3863–3871.
Clavin, P. (1985). “Dynamic behavior of premixed flame fronts in laminar and turbulent flows.” Prog. Energy Combust. Sci., 11(1), 1–59.
Davis, S., Quinard, J., and Searby, G. (2002). “Determination of Markstein numbers in counterflow premixed flames.” Combust. Flame, 130(1), 112–122.
D’ippolito, C. (2015). “A numerical study of syngas laminar premixed flames: Effects of Lewis number and stretch.” M.S. thesis, Univ. of Illinois at Chicago, Chicago.
Dixon-Lewis, G. (2006). “Laminar premixed flame extinction limits; combined effects of stretch and radiative loss in the single flame unburnt-to-burnt and the twin-flame unburnt-to-unburnt opposed flow configurations.” Proc. Royal Society A. Math. Phys. Eng. Sci., 462(2066), 349–370.
Giles, D. E., Som, S., and Aggarwal, S. K. (2006). “A numerical investigation on the structure and emission characteristics of counterflow syngas diffusion flames.” Fuel, 85(12–13), 1729–1742.
Grosshandler, W. L. (1993). “RADCAL: A narrow-band model for radiation calculations in a combustion environment.”, National Institute of Standards and Technology, Gaithersburg, MD.
Hawkes, E. R., and Chen, J. H. (2004). “Direct numerical simulation of hydrogen-enriched lean premixed methane-air flames.” Combust. Flame, 138(3), 242–258.
Karlovitz, B., Denniston, D. W., Knapschaefer, D. H., and Wells, F. E. (1953). “Studies on turbulent flames. A: Flame propagation across velocity gradients. B: Turbulence measurement in flames.” Proc. Combust. Inst., 4(1), 613–620.
Katta, V. R., Aggarwal, S. K., and Roquemore, W. M. (2012). “Evaluation of chemical-kinetics models for n-heptane combustion using a multidimensional CFD code.” Fuel, 93, 339–350.
Katta, V. R., and Roquemore, W. M. (2008). “Calculation of multidimensional flames using large chemical kinetics.” AIAA J., 46(7), 1640–1650.
Kéromnès, A., et al. (2013). “An experimental and detailed chemical kinetic modeling study of hydrogen and syngas mixture oxidation at elevated pressures.” Combust. Flame, 160(6), 995–1011.
Kwon, O. C., and Faeth, G. M. (2001). “Flame/stretch interactions of premixed hydrogen-fueled flames: Measurements and predictions.” Combust. Flame, 124(4), 590–610.
Law, C. K. (1989). “Dynamics of stretched flames.” Proc. Combust. Inst., 22(1), 1381–1402.
Law, C. K., and Sung, C. (2000). “Structure, aerodynamics, and geometry of premixed flamelets.” Prog. Energy Combust. Sci., 26(4), 459–505.
Linteris, G. T., Rumminger, M. D., and Babushok, V. R. (2008). “Catalytic inhibition of laminar flames by transition metal compounds.” Prog. Energy Combust. Sci., 34(3), 288–329.
Majoumerd, M. M., De, S., Assadi, M., and Breuhaus, P. (2012). “An EU initiative for future generation of IGCC power plants using hydrogen-rich syngas: Simulation results for the baseline configuration.” Appl. Energy, 99(11), 280–290.
Natarajan, J., Kochar, Y., Lieuwen, T., and Seitzman, J. (2009). “Pressure and preheat dependence of laminar flame speeds of mixtures.” Proc. Combust. Inst., 32(1), 1261–1268.
Olm, C., Zsély, I. G., Varga, T., Curran, H. J., and Turányi, T. (2015). “Comparison of the performance of several recent syngas combustion mechanisms.” Combust. Flame, 162(5), 1793–1812.
Park, J., Kwon, O. B., Yun, J. H., Keel, S. I., Cho, H. C., and Kim, S. (2008). “Preferential diffusion effects on flame characteristics in H2/CO syngas diffusion flames diluted with CO2.” Int. J. Hydrogen Energy, 33(23), 7286–7294.
Poling, B. E., Prausnitz, J. M., and O’Connell, J. P. (2007). The properties of gases and liquids, 5th Ed., McGraw-Hill, Singapore.
Prathap, C., Ray, A., and Ravi, M. R. (2008). “Investigation of nitrogen dilution effects on the laminar burning velocity and flame stability of syngas fuel at atmospheric condition.” Combust. Flame, 155(1–2), 145–160.
Prathap, C., Ray, A., and Ravi, M. R. (2012). “Effects of dilution with carbon dioxide on the laminar burning velocity and flame stability of –CO mixtures at atmospheric condition.” Combus. Flame, 159(2), 482–492.
Puri, I. K., Aggarwal, S. K., Azzoni, R., and Ratti, S. (2001). “On the similitude between lifted and burner-stabilized triple flames: A numerical and experimental investigation.” Combust. Flame, 124(1/2), 311–325.
Puri, I. K., and Seshadri, K. (1986). “Extinction of diffusion flames burning diluted methane and diluted propane in diluted air.” Combust. Flame, 65(2), 137–150.
Qin, X., Puri, I. K., Aggarwal, S. K., and Katta, V. R. (2004). “Gravity, radiation and coflow effects on partially premixed flames.” Phys. Fluids, 16(8), 2963–2974.
Quattrocchi, S. (2014). “Liftoff and blowout characteristics and structure analysis of syngas diffusion flames.” M.S. thesis, Univ. of Illinois at Chicago, Chicago.
Rozenchan, G., Zhu, D. L., Law, C. K., and Tse, S. D. (2002). “Outward propagation, burning velocities, and chemical effects of methane flames up to 60 atm.” Proc. Combust. Inst., 29(2), 1461–1470.
Safer, K., Tabet, F., Ouadha, A., Safer, M., and Gökalp, I. (2013). “Combustion characteristics of hydrogen-rich alternative fuels in counter-flow diffusion flame configuration.” Energy Convers. Manage., 74(10), 269–278.
Sayad, P., Schonborn, A., and Klingmann, J. (2016). “Experimental investigation of the stability limits of premixed syngas-air flames at two moderate swirl numbers.” Combust. Flame, 164(2), 270–282.
Shih, H. Y. (2012). “Computed NOx emission characteristics of opposed-jet syngas diffusion flames.” Combust. Flame, 159(5), 1851–1863.
Som, S., Ramírez, A. I., Hagerdorn, J., Saveliev, A., and Aggarwal, S. K. (2008). “A numerical and experimental study of counterflow syngas flames at different pressures.” Fuel, 87(3), 319–334.
Sun, C. J., Sung, C. J., Zhu, L., and Law, C. K. (1996). “Response of counterflow premixed and diffusion flames to strain rate variations at reduced and elevated pressures.” Proc. Combust. Inst., 26(1), 1111–1120.
Sun, H., Yang, S. I., Jomaas, G., and Law, C. K. (2007). “High-pressure laminar flame speeds and kinetic modeling of carbon monoxide/hydrogen combustion.” Proc. Combust. Inst., 31(1), 439–446.
Tseng, L. K., Ismail, M. A., and Faeth, G. M. (1993). “Laminar burning velocities and Markstein numbers of hydrocarbon/air flames.” Combust. Flame, 95(4), 410–426.
Turns, S. (2012). An introduction to combustion, concepts and applications, 3rd Ed., McGraw-Hill, New York.
UCSD (University of California, San Diego). (2015). “Mechanical and aerospace engineering (combustion re-search), UCSD: Chemical-kinetic mechanisms for combustion applications.” ⟨http://combustion.ucsd.edu⟩ (Dec. 14, 2014).
Vagelopoulos, C. M., and Egolfopoulos, F. N. (1994). “Further considerations on the determination of laminar flame speeds with the counterflow twin-flame technique.” Proc. Combust. Inst., 25(1), 1317–1323.
Wang, H., et al. (2007). “USC Mech Version II: High-temperature combustion reaction model of /CO/C1-C4 Compounds.” ⟨http://ignis.usc.edu/USC_Mech_II.htm⟩ (May, 2007).
Williams, F. A. (2000). “Progress in knowledge of flamelet structure and extinction.” Prog. Energy Combust. Sci., 26(4), 657–682.
Williams, T. C., Shaddix, C. R., and Schefer, R. W. (2007). “Effect of syngas composition and -diluted oxygen on performance of a premixed swirl-stabilized combustor.” Combust. Sci. Tech., 180(1), 64–88.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Jun 29, 2016
Accepted: Nov 14, 2016
Published ahead of print: Apr 17, 2017
Published online: Apr 18, 2017
Discussion open until: Sep 18, 2017
Published in print: Oct 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.