Investigation of Disk-Stabilized Propane Flames Operated under Stratified and Vitiated Inlet Mixture Conditions
Publication: Journal of Energy Engineering
Volume 142, Issue 2
Abstract
The work describes an experimental investigation of propane flames established through fuel injection and gradual premixing with preheated and vitiated oxidizing air, within a double-cavity arrangement, formed along a cylinder and two concentric disks. Ignition of the inlet stratified and vitiated mixture and flame stabilization is established at the recirculation region of the afterbody disk. Measurements of mean velocities, temperatures, and chemiluminescence and gas analysis provided information for the interpretation of the relative variations in flame structure and burner performance. The study illustrates some aspects regarding the influence of the preheated/vitiated conditions on the combustion of the inlet stratified fuel-air mixture profile, with respect to flame front stabilization, disposition, and burner emissions. Some important differences in the vitiated flame structure and topology are discussed in comparison to the unvitiated case characteristics, in an initial effort to establish the possible advantages or disadvantages of incorporating preheat and vitiation in stratified operation.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was partly supported by the Research Council of the University of Patras.
References
AESO (Aircraft Environmental Support Office). (1987). “Gaseous emissions from aircraft engines.” A handbook for the calculation of emission indexes and gaseous emissions from aircraft engines, San Diego, CA.
Al-Qurashi, K., Lueking, A. D., and Boehman, A. L. (2011). “The deconvolution of the thermal, dilution, and chemical effects of exhaust gas recirculation (EGR) on the reactivity of engine and flame soot.” Combust. Flame, 158(9), 1696–1704.
Amato, A., Seitzman, J. M., and Lieuwen, T. C. (2013). Gas turbine emissions, Cambridge University Press, Cambridge, U.K., 209–234.
Andrews, G. E., Ahmed, N. T., Phylaktou, R., and King, P. (2009). “Weak extinction in low NOx gas turbine combustion.” ASME Turbo Expo 2009: Power for Land, Sea, and Air, Vol. 2, Orlando, FL, 623–638.
Baltasar, J., Carvalho, M. G., Coelho, P., and Costa, M. (1997). “Flue gas recirculation in a gas-fired laboratory furnace: Measurements and modeling.” Fuel, 76(10), 919–929.
Cavaliere, A., and de Joannon, M. (2004). “Mild combustion.” Progr. Eng. Combust. Sci., 30(4), 329–366.
DaVis 8.0 [Computer software]. LaVsion, 〈http://www.lavision.de/en/news/archive/1149/〉.
Dunn-Rankin, D., Miyasato, M. M., and Pham, T. K. (2008). “Introduction and perspectives.” Lean combustion: Technology and control, Academic Press, Waltham, MA, 1–18.
Efstathiou, A., Souflas, K., and Koutmos, P. (2011). “A computational investigation of partially premixed disk stabilized propane-air flames with mixture preparation through air preheat.” 13th Int. Conf. on Numerical Combustion (ICNC2011), National Technical University of Athens (NTUA), Kesariani, Greece.
ElKady, A. M., Evulet, A. T., Brand, A., Ursin, T. P., and Lynghjem, A. (2009). “Application of exhaust gas recirculation in a DLN F-class combustion system for postcombustion carbon capture.” J. Eng. Gas Turb. Power, 131(3), 034505.
Fleck, B. A., Sobiesiak, A., and Becker, H. A. (2000). “Experimental and numerical investigation of the novel low CGRI burner.” Combust. Sci. Tech., 161(1), 89–112.
Fuller, C., et al. (2012). “Effects of vitiation and pressure on laminar flame speeds of n-decane.” AIAA 50th Aerospace Science Meeting, AIAA, Reston, VA.
Fuller, C., Gokulakrishnan, P., Klassen, M., Roby, R., and Kiel, B. (2011). “Improved correlation for blowout of bluff body stabilized flames.” 49th AIAA Aerospace Sciences Meeting, AIAA, Reston, VA, 2011–2096.
Giakoumis, E. G., Rakopoulos, C. D., and Rakopoulos, D. C. (2014). “Assessment of NOx emissions during transient diesel engine operation with biodiesel blends.” J. Energy Eng., A4014004.
Gokulakrishnan, P. (2002). “The chemistry of product-gas entrainment in low-NOx, multi-jet natural-gas burners.” Ph.D. thesis, Queen’s Univ., Kingston, ON.
Gore, J. P., and Zhan, N. J. (1996). “NO emission and major species concentrations in partially premixed laminar methane/air co-flow jet flames.” Combust. Flame, 105(3), 414–418.
Guethe, F., Stankovic, D., Genin, F., Syed, K., and Winkler, D. (2011). “Flue gas recirculation of the ALSTOM sequential gas turbine combustor tested at high pressure.” ASME 2011 Turbo Expo: Turbine Technical Conf. and Exposition, Vol. 2, Vancouver, BC, Canada, 399–408.
Gupta, A. K., Bolz, S., and Hasegawa, T. (1999). “Effect of air preheat and oxygen concentration on flame structure and emission.” Proc. ASME J. Energy Resour. Technol., 121(3), 209–216.
IEA (International Energy Agency). (2014). “World energy outlook 2014 factsheet.” 〈http://www.worldenergyoutlook.org/media/weowebsite/2014/141112_WEO_FactSheets.pdf〉 (Jul. 12, 2015).
Kalb, J., and Sattelmayer, T. (2004). “Lean blowout limit and NOx-production of a premixed sub-ppm-NOx burner with periodic flue gas recirculation.” J. Eng. Gas Turb. Power, 128(2), 247–254.
Karagiannaki, C., Paterakis, G., Souflas, K., Dogkas, E., and Koutmos, P. (2015). “Performance evaluation of a model swirl burner under premixed or stratified inlet mixture conditions.” J. Energy Eng., C4014010.
Katsuki, M., and Hasegawa, T. (1988). “The science and technology of combustion in highly preheated air.” Proc. Comb. Inst., 27(2), 3135–3146.
Kosmadakis, G., and Rakopoulos, C. (2015). “Computational fluid dynamics study of alternative nitric-oxide emission mechanisms in a spark-ignition engine fueled with hydrogen and operating in a wide range of exhaust gas recirculation rates for load control.” J. Energy Eng., C4014008.
Lieuwen, T. C., and Yang, V. (2005). “Combustion instabilities in gas turbine engines: Operational experience, fundamental mechanisms, and modeling.” Progress in astronautics and aeronautics, AIAA, Reston, VA.
Lim, J., Gore, J., and Viskanta, R. (2000). “A study of the effects of air preheat on the structure of methane/air counterflow diffusion flames.” Combust. Flame, 121(1–2), 262–274.
Mokhov, A. V., and Levinsky, H. B. (2000). “A LIF and CARS investigation of upstream heat loss and flue-gas recirculation as control strategies for laminar, premixed natural-gas/air flames.” Proc. Comb. Inst., 28(2), 2467–2474.
Singh, B., and Lear, W. E. (2009). “Flame blowout stability in vitated combustion.” 7th Int. Energy Conversion Engineering Conf., AIAA, Reston, VA.
Stohr, M., Boxx, I., Carter, C., and Meier, W. (2011). “Dynamics of lean blowout of a swirl-stabilized flame in a gas turbine model combustor.” Proc. Comb. Inst., 33(2), 2953–2960.
Sweeney, M. S., Hochgreb, S., Dunn, M. J., and Barlow, R. S. (2012). “The structure of turbulent stratified and premixed methane/air flames II: Swirling flows.” Combust. Flame, 159(9), 2912–2929.
Syred, N. (2006). “A review of oscillation mechanisms and the role of the processing vortex core (PVC) in swirl combustion systems.” Progr. Energy Combust. Syst., 32(2), 93–161.
Trimis, D. (1996). “Verbrennungsvorgange in porosen inerten medien.” Dissertation, Lehrstuhl fur Stromungsmechanik, Universitat Erlangen, Erlangen, Germany.
Tuttle, S. G. (2013). “Lean blowoff behavior of asymmetrically-fueled bluff body-stabilized flames.” Combust. Flame, 160(9), 1677–1692.
Xiouris, C., and Koutmos, P. (2011). “An experimental investigation of the interaction of swirl flow with partially premixed disk stabilized propane flames.” Exp. Therm. Fluid Sci., 35(6), 1055–1066.
Xiouris, C., and Koutmos, P. (2012). “Fluid dynamics modelling of a stratified disk burner in swirl co-flow.” Appl. Therm. Eng., 35, 60–70.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Apr 20, 2015
Accepted: Aug 6, 2015
Published online: Sep 23, 2015
Discussion open until: Feb 23, 2016
Published in print: Jun 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.