Innovative Energy Storage for Off-Grid RES-Based Power Systems: Integration of Flywheels with Hydrogen Utilization in Fuel Cells
Publication: Journal of Energy Engineering
Volume 140, Issue 4
Abstract
This work investigates the feasibility of a renewable energy sources (RES)-based stand-alone power system for electricity supply, to several simulated buildings, where energy is stored in a flywheel energy storage system (FESS). The system is assumed to be located on Naxos Island, Greece, due to the island’s high wind and solar potential and was designed to cover both the load of a typical house and a country house, where the excess electricity could be sold to the grid. An innovative storage device type, consisting of flywheels and electrochemical batteries, was selected as the energy buffer. The energy produced by hydrogen used in the proton electrolyte membrane (PEM) fuel cell (FC) charges the flywheel. This apparatus is compared to diesel generators commonly used in stationary applications. Optimization of the system, in terms of energy efficiency and economic feasibility, is also considered. The two systems were simulated using sensitivity, optimization, and simulation modeling software, and custom calculations of both energy and finance were carried out. It was found that a one-way grid connected project using state-of-the-art and totally green technologies, including hydrogen-fed PEM-FC and flywheels, can totally cover the electrical demands of a typical house and country house, obtaining cost per consumed energy as low as 1.374 and , respectively. These results actually indicate that hydrogen technology could be a reliable energy alternative in the near future.
Get full access to this article
View all available purchase options and get full access to this article.
References
Barbir, F. (2005). “PEM electrolysis for production of hydrogen from renewable energy sources.” Solar Energy, 78(5), 661–669.
Bernal-Agustin, J. L., and Dufo-Lopez, R. (2009). “Simulation and optimization of stand-alone hybrid renewable energy systems.” Renew. Sustain. Energy Rev., 13(8), 2111–2118.
Bolund, B., Bernhoff, H., and Leijon, M. (2007). “Flywheel energy and power storage systems.” Renew. Sustain. Energy Rev., 11(2), 235–258.
Brealy, A. R., and Myers, C. S. (1991). Principles of corporate finance, 4th Ed., McGraw-Hill, New York.
California Energy Commission, and California Public Utilities Commission. (2013). “List of eligible inverters.” 〈http://www.gosolarcalifornia.org/equipment/inverters.php〉 (Oct. 14, 2013).
Clarke, R. E., Giddey, S., and Badwal, S. P. S. (2010). “Stand-alone PEM water electrolysis system for fail safe operation with a renewable energy source.” Int. J. Hydrogen Energy, 35(3), 928–935.
Cummins Power Generation. (2008). “Generator set data sheet, Model DGDB.” 〈http://www.cumminspower.com/www/common/templatehtml/technicaldocument/SpecSheets/Diesel/na/d-3425.pdf〉 (Jan. 1, 2008).
Davies, T. S., Jefferson, C. M., and Mayer, R. M. (1988). “Use of flywheel storage for wind diesel systems.” J. Wind Eng. Ind. Aerod., 27(1–3), 157–165.
Direct Industry. (2013). “Products > Energy: Production and distribution > Gasoline generator > Cadoppi.” 〈http://www.directindustry.com/prod/cadoppi/gasoline-generator-sets-66301-585676.html〉 (Oct. 14, 2013).
Doukas, H., Papadopoulou, A., Savvakis, N., Tsoutsos, T., and Psarras, J. (2012). “Assessing energy sustainability of rural communities using principal component analysis.” Renew. Sustain. Energy Rev., 16(4), 1949–1957.
Duffie, J. A., and Beckman, W. A. (1980). Solar engineering of thermal processes, Wiley, New York.
Elmitwally, A., and Rashed, M. (2009). “High-performance isolated PV-diesel system.” J. Energy Eng., 44–52.
European Union. (2012). “European Commission > Eurostat > Publications > Recently published.” 〈http://epp.eurostat.ec.europa.eu/portal/page/portal/publications/recently_published〉.
Farret, F. A., and Simoes, M. G. (2006). Integration of alternative sources of energy, Wiley, New York.
Glasnovic, Z., and Margeta, J. (2010). “Sustainable electric power system: Is it possible? Case study: Croatia.” J. Energy Eng., 103–113.
Hamelin, J., Agbossou, K., Laperrieve, A., Laurencelle, F., and Bose, T. (2001). “Dynamic behavior of PEM fuel cell stack for stationary applications.” Int. J. Hydrogen Energy, 26(6), 625–629.
HOMER Energy Team. (2013). “HOMER (The hybrid optimization model for electric renewables).” 〈http://homerenergy.com/Pre_DL.html〉 (Oct. 14, 2013).
Kaldellis, J. K., Kapsali, M., and Katsanou, E. (2012). “Renewable energy applications in greece—What is the public attitude?” Energy Policy, 42, 37–48.
Kolhe, M., Agbossou, K., Hamelin, J., and Bose, T. K. (2003). “Analytical model for predicting the performance of photovoltaic array coupled with a wind turbine in a stand-alone renewable energy system based on hydrogen.” Renew. Energy, 28(5), 727–742.
Leclercq, L., Robyns, B., and Grave, J. M. (2003). “Control based on fuzzy logic of a flywheel energy storage system associated with the wind and diesel generators.” Math. Comput. Simulat., 63(3–5), 271–280.
Lilienthal, P. D., Lambert, T. W., and Gilman, P. (2004). “Computer modeling of renewable power systems.” Encyclopedia of energy, Vol. 1, C. J. Cleveland, ed., Elsevier, Amsterdam, Netherlands, 633–647.
Little, M., Muray, T., and David, I. (2007). “Electrical integration of renewable energy into stand-alone power supplies incorporating hydrogen storage.” Int. J. Hydrogen Energy, 32(10–11), 1582–1588.
Liu, H., and Jiang, J. (2007). “Flywheel energy storage-An upswing technology for energy sustainability.” Energy Build., 39(5), 599–604.
Manwell, F. J., McGouan, G. J., and Rogers, L. A. (2002). Wind energy explained theory design and application, Wiley, New York.
Millet, P., Ngameni, R., Grigoriev, S. A., and Fateev, V. N. (2011). “Scientific and engineering issues related to PEM technology: Water electrolysers, fuel cells and unitized regenerative systems.” Int. J. Hydrogen Energy, 36(6), 4156–4163.
Nair, N. K. C., and Garimella, N. (2010). “Battery energy storage systems: Assessment for small-scale renewable energy integration.” Energy Build., 42(11), 2124–2130.
Nakken, T., Frantzen, E., Hagen, E. F., and Strom, H. (2006). “Utsira—demonstrating the renewable hydrogen society.” WHEC, Vol. 16, Norwegian Energy Company, Utsira, Norway.
National Institute of Standards and Technology (NIST). (2011). “NIST Chemistry WebBook.” U.S. Secretary of Commerce, 〈http://webbook.nist.gov/chemistry/〉.
Niiyama, K., Yagai, T., Tsuda, M., and Hamajima, T. (2008). “Optimization of hybrid power system composed of SMES and flywheel MG for large pulsed load.” Physica C., 468(15-20), 2111–2114.
Niknam, T., Golestaneh, F., and Shafiei, M. (2013). “Probabilistic energy management of a renewable microgrid with hydrogen storage using self-adaptive charge search algorithm.” Energy, 49, 252–267.
Panahandeh, B., Bard, J., Outzourhit, A., and Zejli, D. (2011). “Simulation of PV—wind-hybrid systems combined with hydrogen storage for rural electrification.” Int. J. Hydrogen Energy, 36(6), 4185–4197.
Perrin, M., et al. (2006). “Temperature behaviour: Comparison for nine storage technologies Results from the INVESTIRE Network.” J. Power Sour., 154(2), 545–549.
Posso, F., Contreras, A., and Veziroglu, A. (2009). “The use of hydrogen in the rural sector in Venezuela: Technical and financial study of the storage phase.” Renew. Energy, 34(5), 1234–1240.
Prodromidis, G. N., and Coutelieris, F. A. (2010). “Simulation and optimization of a stand-alone power plant based on renewable energy sources.” Int. J. Hydrogen Energy, 35(19), 10599–10603.
Prodromidis, G. N., and Coutelieris, F. A. (2011). “A comparative feasibility study of stand-alone and grid connected RES-based systems in several Greek Islands.” Renew. Energy, 36(7), 1957–1963.
Prodromidis, G. N., and Coutelieris, F. A. (2012). “Simulation of economical and technical feasibility of battery and flywheel hybrid energy storage systems in autonomous projects.” Renew. Energy, 39(1), 149–153.
Ruddell, A. (2002). “Storage technology report: WP-ST6 flywheel. Investigation on storage technologies for intermittent renewable energies: Evaluation and recommended R&D strategy.” Project funded by the European Community under the 5th Framework Programme.
Shabani, B., and Andrews, J. (2011). “An experimental investigation of a PEM fuel cell to supply both heat and power in a solar-hydrogen RAPS system.” Int. J. Hydrogen Energy, 36(9), 5442–5452.
Stamenic, L., Rajkovic, M., and Klisic, D. (2012). “Performance optimization of the BIPV powered electrolyser and fuel cells installation.” Energy Build., 51, 39–47.
U.S. Dept. of Energy, Energy Efficiency, and Renewable Energy, by the Pacific Northwest National Laboratory. (2003) “Flywheel energy storage—an alternative to batteries for uninterruptible power supply systems.” U.S. Dept. of Energy’s Federal Energy Management Program (FEMP), Washington, DC.
Wang, L., Lee, D. J., Lee, W. J., and Chen, Z. (2008). “Analysis of a novel autonomous marine hybrid power generation/energy storage system with a high-voltage direct current link.” J. Power Sour., 185(2), 1284–1292.
Wilkinson, D. P., Zhang, J., Hui, R., Fergus, J., and Li, X. (2010). “Proton exchange membrane fuel cells: Materials properties and performance.” CRC, Boca Raton, FL.
World Weather Online. (2013). “Historical or past local weather API.” 〈http://www.worldweatheronline.com/premium-weather.aspx?menu=historical〉 (Oct. 14, 2013).
Yilanci, A., Dincer, I., and Ozturk, H. K. (2008). “Performance analysis of a PEM fuel cell unit in a solar–hydrogen system.” Int. J. Hydrogen Energy, 33(24), 7538–7552.
Ziogou, C., Ipsakis, D., Seferlis, P., Bezergianni, S., Papadopoulou, S., and Voutetakis, S. (2013). “Optimal production of renewable hydrogen based on an efficient energy management strategy.” Energy, 55, 58–67.
Information & Authors
Information
Published In
Journal of Energy Engineering
Volume 140 • Issue 4 • December 2014
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Mar 11, 2013
Accepted: Oct 2, 2013
Published online: Oct 4, 2013
Discussion open until: Jul 19, 2014
Published in print: Dec 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.