Time-Dependent Strains in Axially Loaded Reinforced Concrete Columns
Publication: Journal of Engineering Mechanics
Volume 146, Issue 8
Abstract
Time-dependent strains in reinforced concrete (RC) members are usually estimated using approximate algebraic methods. This paper presents an exact method for estimating the time-dependent strains in RC members subjected to concentric axial compression, using creep compliance and shrinkage strain information for the corresponding plain concrete. The axial strain in concrete is taken to be the sum of shrinkage strain and the creep strain. Shrinkage strain in concrete is modeled as a: “lack-of-fit” problem. Assuming a linear viscoelastic constitutive law for concrete and a linear elastic constitutive relation for reinforcing steel, the corresponding one-dimensional viscoelastic boundary value problem is solved. It is assumed that there is a perfect bond between concrete and steel. The proposed method is validated using tests reported in the literature. The prediction of overall time-dependent axial strains under applied axial loads is found to match the observed test results closely. However, there are discrepancies in the relative magnitudes of creep and shrinkage strains, and the possible reasons for these are also discussed.
Get full access to this article
View all available purchase options and get full access to this article.
Data Availability Statement
All data, models, and code generated or used during the study appear in the published article.
References
ACI (American Concrete Institute). 2008. Guide for modeling and calculating shrinkage and creep in hardened concrete. ACI209.2R-08. Farmington Hills, MI: ACI.
ASTM. 2015. Standard test method for creep of concrete in compression. ASTM C512/C512 M-15. West Conshohocken, PA: ASTM.
Balaguru, P., and E. G. Nawy. 1982. “Evaluation of creep strains and stress redistribution in RC columns.” ACI Special Publication 76 (1): 309–324.
Bazant, Z., M. Hubler, and Q. Yu. 2011. “Pervasiveness of excessive segmental bridge deflections: Wake-up call for creep.” ACI Struct. J. 108 (6): 766–774.
Bazant, Z. P., and S. Baweja. 2000. “Creep and shrinkage prediction model for analysis and design of concrete structures: Model B3.” ACI Special Publication 194 (1): 1–84.
Bazant, Z. P., and F. H. Wittmann. 1982. Creep and shrinkage in concrete structures. New York: Wiley.
Bažant, Z. P., and M. Jirásek. 2018. Vol. 225 of Creep and hygrothermal effects in concrete structures. New York: Springer.
Beerends, R. J., H. G. ter Morsche, J. Van den Berg, and E. Van de Vrie. 2003. Fourier and Laplace transforms. Cambridge, UK: Cambridge University Press.
Carreira, D., and T. Poulos. 2007. “Designing for effects of creep and shrinkage in high-rise concrete buildings.” ACI Special Publication 246 (1): 107–132.
CEB FIB. 2013. FIB model code for concrete structures 2010. CEB FIB MC 2010. Lausanne, Switzerland: Fédération Internationale du Béton.
Christensen, R. 2012. Theory of viscoelasticity: An introduction. Amsterdam, Netherlands: Elsevier.
Fintel, M., and F. R. Khan. 1969. “Effects of column creep and shrinkage in tall structures—Prediction of inelastic column shortening.” ACI J. Proc. 66 (12): 957–967.
Gardner, N. J., and M. J. Lockman. 2000. “Design provisions for shrinkage and creep of concrete.” ACI Special Publication 194 (1): 101–133.
Gribniak, V., G. Kaklauskas, and D. Bacinskas. 2008. “Shrinkage in reinforced concrete structures: A computational aspect.” J. Civ. Eng. Manage. 14 (1): 49–60. https://doi.org/10.3846/1392-3730.2008.14.49-60.
Holm, T. A., and J. Pistrang. 1966. “Time-dependent load transfer in reinforced lightweight concrete columns.” ACI J. Proc. 63 (11): 1231–1246.
Khazanovich, L. 1990. “Age-adjusted effective modulus method for time-dependent loads.” J. Eng. Mech. 116 (12): 2784–2789. https://doi.org/10.1061/(ASCE)0733-9399(1990)116:12(2784).
Kim, C.-S., and Y. Gong. 2018. “Numerical investigation of creep and shrinkage effects on minimum reinforcement of concentrically and eccentrically loaded RC columns.” Eng. Struct. 174 (Nov): 509–525. https://doi.org/10.1016/j.engstruct.2018.07.032.
Lin, C.-H., and R. W. Furlong. 1995. “Longitudinal steel limits for concrete columns.” Struct. J. 92 (3): 282–287.
Lin, W., J. P. Liu, and J. Z. Liu. 2015. “Influence of reinforcement placement on the creep of concrete.” In Vol. 629 of Key engineering materials, 130–135. Zurich, Switzerland: Trans Tech Publications.
Müller, H., and H. Hilsdorf. 1990. “Evaluation of the time-dependent behavior of concrete, summary report on the work of general task group 9.” CEB Bulletin d’Information, 199 (1): 290.
Pan, Z., Z. Lü, and C. C. Fu. 2011. “Experimental study on creep and shrinkage of high-strength plain concrete and reinforced concrete.” Adv. Struct. Eng. 14 (2): 235–247. https://doi.org/10.1260/1369-4332.14.2.235.
Peronto, J., R. Sinn, and M. Huizinga. 2017. “Vertical shortening considerations in the 1 km tall Jeddah Tower.” Int. J. High-Rise Build. 6 (1): 21–31. https://doi.org/10.21022/IJHRB.2017.6.1.21.
Samra, R. M. 1989. “Creep model for reinforced concrete columns.” Struct. J. 86 (1): 77–82.
Shariff, M. N. 2020. “Creep and shrinkage studies on reinforced concrete walls and columns.” Ph.D. thesis, Dept. of Civil Engineering, Indian Institute of Technology Madras.
Shariff, M. N., U. Saravanan, D. Menon, and K. R. Rajagopal. 2019. “Analysis of the ASTM C512 spring-loaded CREEP frame.” J. Mater. Civ. Eng. 31 (10): 04019234. https://doi.org/10.1061/(ASCE)MT.1943-5533.0002859.
Wendner, R., M. H. Hubler, and Z. P. Bazant. 2013. “The B4 model for multi-decade creep and shrinkage prediction.” In Mechanics and physics of creep, shrinkage, and durability of concrete, 429–436. Reston, VA: ASCE.
Wineman, A. S., and K. R. Rajagopal. 2000. Mechanical response of polymers: An introduction. Cambridge, UK: Cambridge University Press.
Zhang, Y. T. 2012. “Experimental research on concrete shrinkage and creep for main girder of Sutong continuous rigid-frame bridge.” In Vol. 594 of Advanced materials research, 1547–1551. Zurich, Switzerland: Trans Tech Publications.
Zhang, Y. T. 2014. “Finite element analysis on creep and shrinkage of reinforced concrete.” In Vol. 838 of Advanced materials research, 53–56. Zurich, Switzerland: Trans Tech Publications.
Ziehl, P. H., J. E. Cloyd, and M. E. Kreger. 2004. “Investigation of minimum longitudinal reinforcement requirements for concrete columns using present-day construction materials.” Struct. J. 101 (2): 165–175.
Ziehl, P. H., J. E. Cloyd, M. E. Kreger, and R. River. 1998. Evaluation of minimum longitudinal reinforcement requirements for reinforced concrete columns. Washington, DC: USDOT.
Information & Authors
Information
Published In
Copyright
©2020 American Society of Civil Engineers.
History
Received: Sep 6, 2019
Accepted: Mar 9, 2020
Published online: May 21, 2020
Published in print: Aug 1, 2020
Discussion open until: Oct 21, 2020
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.