Real-Time Variable Multidelay Controller for Multihazard Mitigation
Publication: Journal of Engineering Mechanics
Volume 144, Issue 2
Abstract
High performance control systems (HPCS), including semiactive, active, and hybrid damping systems, are effective solutions to increase structural performance versus multihazard excitations. However, the implementation of HPCS within structural systems is still in its infancy, because of the complexity in designing a robust closed-loop control system that can ensure reliable and high mitigation performance. To overcome this challenge, a new type of controller with high adaptive capabilities is proposed. The control algorithm is based on real-time embedding of measurements to minimally represent the essential dynamics of the controlled system, therefore providing adaptive input space capabilities. This type of controller is termed an input-space dependent controller. In this paper, a specialized case of input-space dependent controller is investigated, where the embedding dimension is fixed, but the time delay used in the construction of the embedding varies with time. This constitutes a variable multidelay controller (VMDC), which includes an algorithm enabling the online selection of a time delay based on information theory. Here, optimal time delay selection is first studied and its applicability of the VMDC algorithm demonstrated. Numerical simulations are conducted on a single-degree-of-freedom (SDOF) system to study the performance of the VMDC versus different control strategies. Results show a significant gain in performance from the inclusion of an adaptive input space, and that the algorithm was robust with respect to noise. Simulations also demonstrate that critical gains in performance could be obtained from added knowledge in the system’s dynamics by comparing mitigation results with a linear quadratic regulator (LQR) controller. Additional simulations are conducted on a three degrees-of-freedom (3DOF) system, which consists of a model structure equipped with an actuator and subjected to nonsimultaneous multihazards. Results show enhanced mitigation performance of the VMDC versus LQR strategies when using limited-state feedback, validating the capability of the controller at mitigating vibrations based on limited knowledge and limited measurements, and thus its promise at multihazard applications.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This material is based upon work supported by the National Science Foundation under Grant No. 1300960. Their support is gratefully acknowledged. Any opinions, findings, and conclusions or recommendations expressed in this material are those of the authors and do not necessarily reflect the views of the National Science Foundation.
References
Amjadian, M., and Agrawal, A. K. (2017). “Vibration control using a variable coil-based friction damper.” SPIE Smart Structures and Materials+ Nondestructive Evaluation and Health Monitoring, International Society for Optics and Photonics, SPIE, Bellingham, WA, 101642J–101642J.
Anderson, B. D. (2005). “Failures of adaptive control theory and their resolution.” Commun. Inf. Syst., 5(1), 1–20.
Anderson, B. D., and Dehghani, A. (2008). “Challenges of adaptive control-past, permanent and future.” Ann. Rev. Control, 32(2), 123–135.
Caballero, V. (2000). “On an embedding theorem.” Acta Mathematica Hungarica, 88(4), 269–278.
Campestrini, L., Eckhard, D., Gevers, M., and Bazanella, A. S. (2011). “Virtual reference feedback tuning for non-minimum phase plants.” Automatica, 47(8), 1778–1784.
Cao, L., Downey, A., Laflamme, S., Taylor, D., and Ricles, J. (2015). “Variable friction device for structural control based on duo-servo vehicle brake: Modeling and experimental validation.” J. Sound Vibr., 348, 41–56.
Cao, L., and Laflamme, S. (2016a). “Input space-dependent controller for multi-hazard mitigation.” SPIE Smart Structures and Materials+ Nondestructive Evaluation and Health Monitoring, SPIE, Bellingham, WA, 97992H–97992H.
Cao, L., and Laflamme, S. (2016b). “Multi-delay controller for multi-hazard mitigation.” 2016 American Control Conf. (ACC), IEEE, Piscataway, NJ, 1851–1856.
Cao, L., Laflamme, S., Taylor, D., and Ricles, J. (2016). “Simulations of a variable friction device for multihazard mitigation.” J. Struct. Eng., H4016001.
Connor, J. J., and Laflamme, S. (2014). Structural motion engineering, Springer, New York.
Da Silva, A., Alexandre, P., Ferreira, V., and Velasquez, R. (2008). “Input space to neural network based load forecasters.” Int. J. Forecasting, 24(4), 616–629.
Dyke, S., and Spencer, B. (1997). “A comparison of semi-active control strategies for the MR damper.” Proc., Intelligent Information Systems, 1997. IIS’97, IEEE, Piscataway, NJ, 580–584.
Fraser, A. M., and Swinney, H. L. (1986). “Independent coordinates for strange attractors from mutual information.” Phys. Rev. A, 33(2), 1134–1140.
Hou, Z., and Jin, S. (2011). “Data-driven model-free adaptive control for a class of MIMO nonlinear discrete-time systems.” IEEE Trans. Neural Networks, 22(12), 2173–2188.
Kennel, M., Brown, R., and Abarbanel, H. (1992). “Determining embedding dimension for phase-space reconstruction using a geometrical construction.” Phys. Rev. A, 45(6), 3403–3411.
Laflamme, S., and Connor, J. (2009). “Application of self-tuning Gaussian networks for control of civil structures equipped with magnetorheological dampers.” Proc., SPIE, Vol. 7288, SPIE, Bellingham, WA.
Laflamme, S., Slotine, J.-J. E., and Connor, J. J. (2011). “Wavelet network for semi-active control.” J. Eng. Mech., 462–474.
Laflamme, S., Slotine, J.-J. E., and Connor, J. J. (2012a). “Self-organizing input space for control of structures.” Smart Mater. Struct., 21(11), 115015.
Laflamme, S., Taylor, D., Abdellaoui Maane, M., and Connor, J. J. (2012b). “Modified friction device for control of large-scale systems.” Struct. Control Health Monit., 19(4), 548–564.
Lee, H.-J., Yang, G., Jung, H.-J., Spencer, B. F., and Lee, I.-W. (2006). “Semi-active neurocontrol of a base-isolated benchmark structure.” Struct. Control Health Monit., 13(2–3), 682–692.
Li, H., Liu, H., Gao, H., and Shi, P. (2012). “Reliable fuzzy control for active suspension systems with actuator delay and fault.” IEEE Trans. Fuzzy Syst., 20(2), 342–357.
Li, K., and Peng, J. (2007). “Neural input selection—A fast model-based approach.” Neurocomputing, 70(4–6), 762–769.
Love, J., Tait, M., and Toopchi-Nezhad, H. (2011). “A hybrid structural control system using a tuned liquid damper to reduce the wind induced motion of a base isolated structure.” Eng. Struct., 33(3), 738–746.
Materazzi, A. L., and Ubertini, F. (2012). “Robust structural control with system constraints.” Struct. Control Health Monit., 19(3), 472–490.
Michalowicz, J. V., Nichols, J. M., and Bucholtz, F. (2009). “Calculation of entropy and mutual information for sinusoids.”, Elsevier, Amsterdam, Netherlands.
Moniz, L., et al. (2005). “A multivariate, attractor-based approach to structural health monitoring.” J. Sound Vibr., 283(1–2), 295–310.
Monroig, E., Aihara, K., and Fujino, Y. (2009). “Modeling dynamics from only output data.” Phys. Rev. E, 79(5), 56208.
Overbey, L., Olson, C., and Todd, M. (2007). “A parametric investigation of state-space-based prediction error methods with stochastic excitation for structural health monitoring.” Smart Mater. Struct., 16(5), 1621–1638.
Slotine, J.-J. E., and Li, W. (1991). Applied nonlinear control, Vol. 199, Prentice-Hall, Englewood Cliffs, NJ.
Spall, J. C. (2009). “Feedback and weighting mechanisms for improving Jacobian estimates in the adaptive simultaneous perturbation algorithm.” IEEE Trans. Autom. Control, 54(6), 1216–1229.
Stark, J. (1999). “Delay embeddings for forced systems. I: Deterministic forcing.” J. Nonlinear Sci., 9(3), 255–332.
Stark, J., Broomhead, D., Davies, M., and Huke, J. (2003). “Delay embeddings for forced systems. II: Stochastic forcing.” J. Nonlinear Sci., 13(6), 519–577.
Takens, F. (1981). “Detecting strange attractors in turbulence.” Dynamical systems and turbulence, Warwick 1980, Springer, New York, 366–381.
Tikka, J. (2009). “Simultaneous input variable and basis function selection for RBF networks.” Neurocomputing, 72(10–12), 2649–2658.
Ubertini, F. (2008). “Active feedback control for cable vibrations.” Smart Struct. Syst., 4(4), 407–428.
Ubertini, F., and Materazzi, A. L. (2013). “Seismic response control of buildings with force saturation constraints.” Smart Struct. Syst., 12(2), 157–179.
Van Helvoort, J., de Jager, B., and Steinbuch, M. (2007). “Direct data-driven recursive controller unfalsification with analytic update.” Automatica, 43(12), 2034–2046.
Venanzi, I., Ubertini, F., and Materazzi, A. L. (2013). “Optimal design of an array of active tuned mass dampers for wind-exposed high-rise buildings.” Struct. Control Health Monit., 20(6), 903–917.
Yang, J. N., and Agrawal, A. K. (2002). “Semi-active hybrid control systems for nonlinear buildings against near-field earthquakes.” Eng. Struct., 24(3), 271–280.
Zolock, J., and Greif, R. (2009). “A methodology for the modeling of forced dynamical systems from time series measurements using time-delay neural networks.” J. Vibr. Acoust., 131(1), 011003.
Zou, Z., Bao, Y., Li, H., Spencer, B. F., and Ou, J. (2015). “Embedding compressive sensing-based data loss recovery algorithm into wireless smart sensors for structural health monitoring.” IEEE Sens. J., 15(2), 646–650.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: Aug 26, 2016
Accepted: Aug 4, 2017
Published online: Dec 6, 2017
Published in print: Feb 1, 2018
Discussion open until: May 6, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.