Dependencies of Shear Wave Velocity and Shear Modulus of Soil on Saturation
Publication: Journal of Engineering Mechanics
Volume 142, Issue 11
Abstract
Shear wave propagation in soil is a physical phenomenon and has been used widely for monitoring and seismic property assessment in geotechnical engineering. Shear wave velocity and small-strain shear modulus are the key parameters in defining material response to various dynamic loadings. To date, the dependencies of and on saturation, especially in high suction range, are still not well understood because of the limited testing methodology and experimental evidence. In this study, the authors present a new laboratory instrumentation of measuring shear wave propagation in different types of unsaturated soils. Low relative humidity and water mist injection environment are used for measuring shear wave velocity under both drying and wetting conditions. Bender element technique was used to measure the shear wave responses. Step function was used as excitation, and determination of a first arrival time was identified and consistently used for all shear wave measurements. Shear wave evolution and the calculated and with varying volumetric water content under zero total stress condition along drying and wetting are presented. The effects of different soil–water regimes on the evolution of are examined. It is found that or depends highly on soil types, saturation, and drying/wetting state. Parameter or is the lowest when a soil is saturated and the highest when it is dry—varying from tens of meters per second for or a few megapascals for at full saturation for all soils to up to of or 2 GPa of in clayey soil at dry state. The variability of or on soil type becomes more pronounced as soil has more clayey materials. It is also identified that hydraulic hysteresis of or is prominent only in the capillary water retention regime for all types of soil.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research is supported by a grant from the National Science Foundation (NSF CMMI-1230544).
References
Airey, D., and Mohsin, A. K. M. (2013). “Evaluation of shear wave velocity from bender elements using cross-correlation.” Geotech. Test. J., 36(4), 1–9.
Alramahi, B., Dante, F., Khalid, A. A., and Stephen, T. (2007). “A suction-control apparatus for the measurement of P and S-wave velocity in soils.” Geotech. Test. J., 31(1), 266–275.
Blewett, J., Blewett, I. J., and Woodward, P. K. (2000). “Phase and amplitude responses associated with the measurement of shear-wave velocity in sand by bender elements.” Can. Geotech. J., 37(6), 1348–1357.
Bonal, J., Donohue, S., and McNally, C. (2012). “Wavelet analysis of bender element signals.” Geotechnique, 62(3), 243–252.
Cho, G. C., and Santamarina, J. C. (2001). “Unsaturated particulate materials: particle-level studies.” J. Geotech. Geoenviron. Eng., 84–96.
Clayton, C. R. I. (2011). “Stiffness at small strain: Research and practice.” Géotechnique, 61(1), 5–37.
Dong, Y., and Lu, N. (2016). “Correlation between small-strain shear modulus and suction stress of unsaturated soils in capillary regime.” J. Geotech. Geoenviron. Eng., 04016056.
Dong, Y., Lu, N., and McCartney, J. (2016). “A unified model for small-strain shear modulus of variably saturated soil.” J. Geotech. Geoenviron. Eng., 04016039.
Ghayoomi, M., McCartney, J. S., and Ko, H. Y. (2011). “Centrifuge test to assess the seismic compression of partially saturated sand layers.” Geotech. Test. J., 34(4), 321–331.
Heitor, A., Indraratna, B., and Rujikiatkamjorn, C. (2013). “Laboratory study of small-strain behavior of a compacted silty sand.” Can. Geotech. J., 50(2), 179–188.
Inci, G., Nazli, Y., and Takaaki, K. (2003). “Experimental investigation of dynamic response of compacted clayey soils.” Geotech. Test. J., 26(2), 125.
Jovičić, V., and Coop, M. R. (1998). “The measurement of stiffness anisotropy in clays with bender element tests in the triaxial apparatus.” Geotech. Test. J., 21(1), 3–10.
Khosravi, A., and McCartney, J. S. (2012). “Impact of hydraulic hysteresis on the small-strain shear modulus of unsaturated soils.” J. Geotech. Geoenviron. Eng., 1326–1333.
Kramer, S. L. (1996). Geotechnical earthquake engineering, Prentice Hall, Upper Saddle River, NJ.
Lebeau, M., and Konrad, J. M. (2010). “A new capillary and thin film flow model for predicting the hydraulic conductivity of unsaturated porous media.” Water Resour. Res., 46(12), W12554.
Lee, J. S., and Santamarina, J. C. (2005). “Bender element: Performance and signal interpretation.” J. Geotech. Geoenviron. Eng., 1063–1070.
Leong, E. C., Cahyadi, J., and Rahardjo, H. (2009). “Measuring shear and compression wave velocities of soil using bender-extender elements.” Can. Geotech. J., 46(7), 792–812.
Lu, N. (2016). “Generalized soil water retention equation for adsorption and capillarity.” J. Geotech. Geoenviron. Eng., 04016051.
Lu, N., and Kaya, M. (2013). “A drying cake method for measuring suction-stress characteristic curve, soil–water-retention curve, and hydraulic conductivity function.” Geotech. Test. J., 36(1), 1–19.
Lu, N., and Kaya, M. (2014). “Power law for elastic moduli of unsaturated soil.” J. Geotech. Geoenviron. Eng., 46–56.
Lu, N., and Khorshidi, M. (2015). “Mechanisms for soil–water retention and hysteresis at high suction range.” J. Geotech. Geoenviron. Eng., 04015032.
Lu, N., and Likos, W. J. (2004). Unsaturated soil mechanics, Wiley, Hoboken, NJ.
Mancuso, C., Vassallo, R., and d’Onofrio, A. (2002). “Small strain behavior of a silty sand in controlled-suction resonant column torsional shear tests.” Can. Geotech. J., 39(1), 22–31.
Marinho, F. A. M., Chandler, R. J., and Crilly, M. S. (1995). “Stiffness measurements on an unsaturated high plasticity clay using bender elements.” Proc., 1st Int. Conf. on Unsaturated Soils, ASCE, Reston, VA, 535–544.
Ng, C. W. W., Xu, J., and Yung, S. Y. (2009). “Effects of imbibition-drainage and stress ratio on an-isotropic stiffness of an unsaturated soil at very small strains.” Can. Geotech. J., 46(9), 1062–1076.
Ng, C. W. W., and Yung, S. Y. (2008). “Determination of the anisotropic shear stiffness of an unsaturated decomposed soil.” Géotechnique, 58(1), 23–35.
Oh, W. T., and Vanapalli, S. K. (2014). “Semi-empirical model for estimating the small-strain shear modulus of unsaturated non-plastic sandy soils.” Geotech. Geol. Eng., 32(2), 259–271.
Qian, X., Gray, D. H., and Woods, R. D. (1991). “Resonant column tests on partially saturated sands.” Geotech. Test. J., 14(3), 266–275.
Revil, A., and Lu, N. (2013). “Unified water sorption and desorption isotherms for clayey porous materials.” Water Resour. Res., 49(9), 5685–5699.
Salgado, R., Bandini, P., and Karim, A. (2000). “Shear strength and stiffness of silty sand.” J. Geotech. Geoenviron. Eng., 451–462.
Sawangsuriya, A., Edil, T. B., and Bosscher, P. J. (2009). “Modulus-suction moisture relationship for compacted soils in post compaction state.” J. Geotech. Geoenviron. Eng., 1390–1403.
Shibuya, S., and Mitachi, T. (1994). “Small strain shear modulus of clay sedimentation in a state of normal consolidation.” Soils Found., 34(4), 67–77.
Sorensen, K. K., Baudet, B. A., and Simpson, B. (2010). “Influence of strain rate and acceleration on the behaviour of reconstituted clays at small strains.” Géotechnique, 60(10), 751–763.
Styler, M. A. and Howie, J. A. (2013). “Combined time and frequency domain approach to the interpretation of bender-element tests on sand.” Geotech. Test. J., 36(5), 1–11.
Truong, Q., Lee, J., Dong, Y., and Yun, T. (2011). “Capillary induced small-strain stiffness for hydrophilic and hydrophobic granular materials: Experimental and numerical studies.” Soils Found., 51(4), 713–721.
Wang, Y. H., Cascante, G., and Santamarina, J. C. (2003). “Resonant column testing: The inherent counter EMF effect.” Geotech. Test. J., 26(3), 1–11.
Yang, J., and Gu, X. Q. (2013). “Shear stiffness of granular material at small strains: Does it depend on grain size?” Géotechnique, 63(2), 165–179.
Youn, J. U., Choo, Y. W., and Kim, D. S. (2008). “Measurement of small-strain shear modulus G max of dry and saturated sands by bender element, resonant column, and torsional shear tests.” Can. Geotech. J., 45(10), 1426–1438.
Zeng, X. and Ni, B. (1998). “Application of bender elements in measuring of sand under condition.” Geotech. Test. J., 21(3), 251–263.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Feb 4, 2016
Accepted: May 25, 2016
Published online: Jul 21, 2016
Published in print: Nov 1, 2016
Discussion open until: Dec 21, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.