Calculation Technique for Externally Unbonded CFRP Strips in Structural Concrete Retrofitting
Publication: Journal of Engineering Mechanics
Volume 142, Issue 6
Abstract
This paper presents a calculation procedure for externally unbonded carbon fiber–reinforced polymer (CFRP) strips anchored at their ends in flexural strengthening of existing reinforced concrete structures. Due to strain incompatibility between the composite strip and the neighboring concrete surface, the well-known conventional cross-section analysis (CSA) employed for bonded reinforcements cannot be implemented. An iterative force equilibrium and strip strain adaptation with previously defined constitutive materials laws together with an optimization procedure in a numerical computing environment are used to overcome the computational complexities. For validation purposes, two static loading tests on reinforced concrete beams with an externally prestressed CFRP strip without bond except in the anchorage zones are compared to the numerical predictions. Prior to the final evaluation, a model for the anchorage resistance is implemented in the algorithm in order to capture the ultimate load due to anchorage failure. An excellent agreement in terms of structural behavior as well as of ultimate load-carrying capacity is observed. Eventually, the differences in the structural response between bonded and unbonded strips are pointed out.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors want to acknowledge the support of the Swiss Federal Laboratories for Materials Science and Technology (Empa) staff for their assistance in the experimental testing. The financial support (No. 200021_124401/1) of the Swiss National Science Fundation (SNSF) for the doctoral studies of the third author is highly appreciated.
References
Au, F., and Du, J. (2004). “Prediction of ultimate stress in unbonded prestressed tendons.” Mag. Concr. Res., 56(1), 1–11.
Bakis, C., et al. (2002). “Fiber-reinforced polymer composites for construction—State-of-the-art review.” J. Comp. Constr., 73–87.
Bennitz, A. (2011). “Externally unbonded post-tensioned CFRP tendons—A system solution.” Ph.D. thesis, Lulea Univ. of Technology, Lulea, Sweden.
Caggiano, A., and Martinelli, E. (2013). “A fracture-based interface model for simulating the bond behaviour of FRP strips glued to a brittle substrate.” Comp. Struct., 99, 397–403.
Chahrour, A., and Soudki, K. (2005). “Flexural response of reinforced concrete beams strengthened with end-anchored partially bonded carbon fiber-reinforced polymer strips.” J. Comp. Constr., 170–177.
Choi, H. (2008). “Flexural behavior of partially bonded CFRP strengthened concrete T-beams.” Ph.D. thesis, Univ. of Waterloo, Waterloo, ON, Canada.
Choi, H., West, J., and Soudki, K. (2008). “Analysis of the flexural behavior of partially bonded FRP strengthened concrete beams.” J. Comp. Constr., 375–386.
Czaderski, C. (2012). “Strengthening of reinforced concrete members by prestressed externally bonded reinforcement with gradient method.” Ph.D. thesis, ETH Zürich, Zurich, Switzerland.
Czaderski, C., and Motavalli, M. (2007). “40-year-old full-scale concrete bridge girder strengthened with prestressed CFRP Plates anchored using gradient method.” Compos. Part B: Eng., 38(7–8), 878–886.
Czaderski, C., Soudki, K., and Motavalli, M. (2010). “Front and side view image correlation measurements on FRP to concrete pull-off bond tests.” J. Comp. Constr., 451–463.
El-Hacha, R., Wight, R., and Green, M. (2001). “Prestressed fibre-reinforced polymer laminates for strengthening structures.” Prog. Struct. Eng. Mater., 3(2), 111–121.
El-Hacha, R., Wight, R., and Green, M. (2003). “Innovative system for prestressing fiber-reinforced polymer sheets.” ACI Struct. J., 100(3), 305–313.
El Maaddawy, T., and Soudki, K. (2008). “Strengthening of reinforced concrete slabs with mechanically-anchored unbonded FRP system.” Constr. Build. Mater., 22(4), 444–455.
Harmanci, Y. (2013). “Prestressed CFRP for structural retrofitting—Experimental and analytical investigation.” M.Sc. thesis, ETH Zürich, Zurich, Switzerland.
Hognestad, E. (1951). “A study of combined bending and axial load in reinforced concrete members.”, Univ. of Illinois Engineering Experimental Station, Champaign, IL.
Kiefer, J. (1953). “Sequential minimax search for a maximum.” Proc., Am. Math. Soc., 4, 502.
Kim, Y., Green, M., and Fallis, G. (2008). “Repair of bridge girder damaged by impact loads with prestressed CFRP sheets.” J. Bridge Eng., 15–23.
Knuth, D. (1968). The art of computer programming, Addison-Wesley, Boston.
Kotynia, R., Lasek, K., and Staskiewicz, M. (2014). “Flexural behavior of preloaded RC slabs strengthened with prestressed CFRP laminates.” J. Comp. Constr., A4013004.
Kotynia, R., Walendziak, R., Stöcklin, I., and Meier, U. (2011). “RC slabs strengthened with prestressed and gradually anchored CFRP strips under monotonic and cyclic loading.” J. Comp. Constr., 168–180.
Krippendorff, K. (2013). “Combinatorial explosion.” Web Dictionary of Cybernetics and Systems, 〈http://pespmc1.vub.ac.be/asc/COMBIN_EXPLO.html〉.
Lees, J., and Burgoyne, C. (2000). “Analysis of concrete beams with partially bonded composite reinforcement.” ACI Struct. J., 97(2), 252–258.
Marti, P., Alvarez, M., Kaufmann, W., and Sigrist, V. (1999a). “Tension chord model for structural concrete.” Struct. Eng. Int., 115(41), 832–838.
Marti, P., Alvarez, M., Kaufmann, W., and Sigrist, V. (1999b). “Tragverhalten von Stahlbeton—Fortbildungskurs für Bauingenieure.” Institut für Baustatik und Konstruktion (IBK), ETH Zürich, Zurich, Switzerland.
Martinelli, E., and Caggiano, A. (2014). “A unified theoretical model for the monotonic and cyclic response of FRP strips glued to concrete.” Polymers, 6(2), 370–381.
MATLAB [Computer software]. Mathworks, Natick, MA.
Meier, U. (1995). “Strengthening of structures using carbon fibre/epoxy composites.” Constr. Build. Mater., 9(6), 341–351.
Meier, U., Stöcklin, I., and Terrasi, G. (2001). “Civil engineers can make better use of the strength of fibrous materials.” Int. Conf. Composites in Construction (CCC), CRC Press, Taylor&Francis Group, Abingdon, U.K.
Michael, H. (2002). Scientific computing: An introductory survey, 2nd Ed., McGraw-Hill, New York.
Michels, J., Cruz, J. S., Czaderski, C., and Motavalli, M. (2013). “Structural strengthening with prestressed CFRP strips anchored with the gradient method.” J. Compos. Constr., 651–661.
Michels, J., Czaderski, C., El-Hacha, R., Brönnimann, R., and Motavalli, M. (2012). “Temporary bond strength of partly cured epoxy adhesive for anchoring prestressed CFRP strips on concrete.” Comp. Struct., 94(9), 2667–2676.
Michels, J., Martinelli, E., Czaderski, C., and Motavalli, M. (2014a). “Prestressed CFRP strips with gradient anchorage for structural concrete retrofitting: Experiments and numerical modeling.” Polymers, 6(1), 114–131.
Michels, J., Zile, E., Czaderski, C., and Motavalli, M. (2014b). “Debonding failure mechanisms in prestressed CFRP/epoxy/concrete connections.” Eng. Fract. Mech., 132, 16–37.
Motavalli, M., Czaderski, C., and Pfyl-Lang, K. (2011). “Prestressed CFRP for strengthening of reinforced concrete structures: Recent developments at Empa, Switzerland.” J. Compos. Constr., 194–205.
Muttoni, A., and Burdet, O. (2002). “Conception et dimensionnement des éléments de structures en béton armé—course script.” École Polytechnique Fédérale de Lausanne (EPFL), Écublens, Switzerland.
Ng, C., and Tan, K. (2006). “Flexural behaviour of externally prestressed beams. Part I: Analytical model.” Eng. Struct., 28(4), 609–621.
Ng, S., and Lee, S. (2002). “A study of flexural behavior of reinforced concrete beam strengthened with carbon fiber-reinforced plastic (CFRP).” J. Reinf. Plast. Compos., 21(10), 919–938.
Park, R., and Paulay, T. (1975). Reinforced concrete structures, Wiley, New York.
Pellegrino, C., and Modena, C. (2009). “Flexural strengthening of real-scale RC and PRC beams with end-anchored pretensioned FRP laminates.” ACI Struct. J., 106(3), 319–328.
SIA (Schweizer Ingenieur-und Architektenverein). (2004). “Klebebewehrungen (externally bonded reinforcements).”, Zurich, Switzerland.
S&P Clever Reinforcement Company AG. (2012). “S&P Resin 220 epoxy adhesive—Technical data sheet.” Seewen, Switzerland.
Suter, R., and Jungo, D. (2001). “Vorgespannte CFK-Lamellen zur Verstärkung von Bauwerken.” Beton- und Stahlbetonbau, 96(5), 350–358.
Triantafillou, T., and Deskovic, N. (1991). “Innovative prestressing with FRP sheets. Mechanics of short-term behavior.” J. Eng. Mech., 1652–1672.
Wight, R., Green, M., and Erki, M.-A. (2001). “Prestressed FRP sheets for poststrengthening reinforced concrete beams.” J. Compos. Constr., 214–220.
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Jun 1, 2015
Accepted: Aug 12, 2015
Published online: Feb 23, 2016
Published in print: Jun 1, 2016
Discussion open until: Jul 23, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.