Assessment of Construction Joint Effect in Full-Scale Concrete Beams by Acoustic Emission Activity
Publication: Journal of Engineering Mechanics
Volume 136, Issue 7
Abstract
In the present paper the mechanical and acoustic emission (AE) behaviors of full-scale reinforced concrete beams are evaluated. One of the beams was constructed in two parts, which were assembled later in order to evaluate the effect of the joints in the structural behavior. The load was applied by means of a four-point-bending configuration. It is revealed that at initial stages of loading, the conventional measurements of strain and deflection, as well as pulse velocity, do not show any discrepancy, although the structural performance of the two beams is eventually proven to be quite different. On the contrary, AE parameters, even from early load steps, indicate that the damage accumulation is much faster in the assembled beam. This is confirmed by the calculated sources of AE events which are close to the construction joints. The results show that the AE technique is suitable to monitor the deterioration process of full-scale structures and yields valuable information that cannot be obtained at the early stages of damage by any other way.
Get full access to this article
View all available purchase options and get full access to this article.
References
Colombo, S., Forde, M. C., Main, I. G., and Shigeishi, M. (2005). “Predicting the ultimate bending capacity of concrete beams from the ‘relaxation ratio’ analysis of AE signals.” Constr. Build. Mater., 19, 746–754.
Colombo, S., Main, I. G., and Forde, M. C. (2003). “Assessing damage of reinforced concrete beam using ‘b-value’ analysis of acoustic emission signals.” J. Mater. Civ. Eng., 15(3), 280–286.
Grosse, C., Reinhardt, H., and Dahm, T. (1997). “Localization and classification of fracture types in concrete with quantitative acoustic emission measurement techniques.” NDT Int., 30(4), 223–230.
Grosse, C. U., and Finck, F. (2006). “Quantitative evaluation of fracture processes in concrete using signal-based acoustic emission techniques.” Cem. Concr. Compos., 28(4), 330–336.
Kurz, J. H., Finck, F., Grosse, C. U., and Reinhardt, H. W. (2006). “Stress drop and stress redistribution in concrete quantified over time by the b-value analysis.” Struct. Health Monit., 5, 69–81.
Kurz, J. H., Grosse, C. U., and Reinhardt, H. W. (2005). “Strategies for reliable onset time picking of acoustic emission and of ultrasound signals in concrete.” Ultrasonics, 43(7), 538–546.
Mihashi, H., Nomura, N., and Niiseki, S. (1991). “Influence of aggregate size on fracture process zone of concrete detected with three dimensional acoustic emission technique.” Cem. Concr. Res., 21, 737–744.
Ohtsu, M., Uchida, M., Okamoto, T., and Yuyama, S. (2002). “Damage assessment of reinforced concrete beams qualified by acoustic emission.” ACI Struct. J., 99(4), 411–417.
Popovics, S., and Popovics, J. S. (1991). “Effect of stresses on the ultrasonic pulse velocity in concrete.” Mater. Struct., 24, 15–23.
Schechinger, B., and Vogel, T. (2007). “Acoustic emission for monitoring a reinforced concrete beam subject to four-point-bending.” Constr. Build. Mater., 21(3), 483–490.
Shiotani, T., Bisschop, J., and Van Mier, J. G. M. (2003). “Temporal and spatial development of drying shrinkage cracking in cement-based materials.” Eng. Fract. Mech., 70(12), 1509–1525.
Shiotani, T., Fujii, K., Aoki, T., and Amou, K., (1994). “Evaluation of progressive failure using AE sources and improved b-value on slope model tests.” J. Acoust. Emiss., VII(7), 529–534.
Shiotani, T., Luo, X., and Haya, H. (2006). “Damage diagnosis of railway concrete structures by means of one-dimensional AE sources.” J. Acoust. Emiss., 24, 205–214.
Shiotani, T., Nakanishi, Y., Iwaki, K., Luo, X., and Haya, H. (2005). “Evaluation of reinforcement in damaged railway concrete piles by means of acoustic emission.” J. Acoust. Emiss., 23, 260–271.
Shiotani, T., Nakanishi, Y., Luo, X., and Haya, H. (2004b). “Damage assessment in deteriorated railway sub-structures using AE technique.” J. Acoust. Emiss., 22, 39–48.
Shiotani, T., Nakanishi, Y., Luo, X., Haya, H., and Inaba, T. (2004a). “Damage evaluation for railway structures by means of acoustic emission.” Key Eng. Mater., 270–273, 1622–1630.
Shiotani, T., Ohtsu, M., and Ikeda, K. (2001). “Detection and evaluation of AE waves due to rock deformation.” Constr. Build. Mater., 15(5–6), 235–246.
Shiotani, T., Shigeishi, M., and Ohtsu, M. (1999). “Acoustic emission characteristics of concrete piles.” Constr. Build. Mater., 13, 73–85.
Suaris, W., and Fernando, V. (1987). “Detection of crack growth in concrete from ultrasonic intensity measurements.” Mater. Struct., 20, 214–220.
Triantafillou, T. C., and Papanikolaou, C. G. (2006). “Shear strengthening of reinforced concrete members with textile reinforced mortar (TRM) jackets.” Mater. Struct., 39(1), 93–103.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Dec 3, 2009
Accepted: Dec 17, 2009
Published online: Dec 19, 2009
Published in print: Jul 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.