Experimental Evaluation of the Stoichiometry of Sulfide-Related Concrete Sewer Corrosion
Publication: Journal of Environmental Engineering
Volume 140, Issue 2
Abstract
Stoichiometry of hydrogen sulfide–induced corrosion of concrete sewers was quantified in a bench-scale experimental setup consisting of six concrete pipe reactors. The setup was installed in an underground sewer research and monitoring station with access to fresh municipal wastewater. Hydrogen sulfide gas was injected intermittently into the headspace of the pipe reactors in peak concentrations of approximately . Mass balance calculations on total injected amounts of hydrogen sulfide gas and observed corrosion depths demonstrated that only a fraction of the hydrogen sulfide gas caused corrosion. The stoichiometry of the corrosion process was found to depend on both duration and level of hydrogen sulfide exposure. The highest fraction of sulfide-causing corrosion was found after extended exposure and low injection frequencies. When sulfide exposure was terminated, a significant potential for sustained corrosion was observed. This was most likely the result of sulfuric acid production from oxidation of reaction intermediates accumulated during sulfide exposure such as elemental sulfur.
Get full access to this article
View all available purchase options and get full access to this article.
References
Apgar, D., and Witherspoon, J. (2007). “Minimization of odors and corrosion in collection systems (Phase 1).”, Water Environment Research Foundation (WERF), Alexandria, VA.
Boehm, M., Devinny, J., Jahani, F., and Rosen, G. (1998). “On a moving-boundary system modeling corrosion in sewer pipes.” Appl. Math. Comput., 92(2–3), 247–269.
Boon, A. G., and Lister, A. R. (1975). “Formation of sulfide in rising main sewers and its prevention by injection of oxygen.” Prog. Water Technol., 7(2), 289–300.
Buisman, C. J., Jspeert, P. I., Hof, A., Janssen, A. J., Hagen, R. T., and Lettinga, G. (1991). “Kinetic parameters of a mixed culture oxidizing sulfide and sulfur with oxygen.” Biotechnol. Bioeng., 38(8), 813–820.
Danish Standards. (2002). “Concrete products—sewer and drain pipes—requirements.”, Charlottenlund, Denmark.
De Belie, N., Monteny, J., Beeldens, A., Vincke, E., Van Gemert, D., and Verstraete, W. (2004). “Experimental research and prediction of the effect of chemical and biogenic sulfuric acid on different types of commercially produced concrete sewer pipes.” Cem. Concr. Res., 34(12), 2223–2236.
Eaton, A. D., Clesceri, L. S., Rice, E. W., and Greenberg, A. E., eds. (2005). Standard methods for the examination of water and wastewater, 21st Ed., American Public Health Association, American Water Works Association, Water Environment Federation, Washington DC.
Fattuhi, N. I., and Hughes, B. P. (1988). “Ordinary Portland-cement mixes with selected admixtures subjected to sulfuric-acid attack.” ACI Mater. J., 85(6), 512–518.
Hass, D., Kemnitz, E., Grunze, B., Sekowski, R., and Worzala, H. (1985). “Zur darstellung und charakterisierung von calciumhydrogensulfaten.” Zeitschrift für Anorganische und Allgemeine Chemie (ZAAC), 525(6), 173–178.
Herisson, J., van Hullebusch, E. D., Moletta-Denat, M., Taquet, P., and Chaussadent, T. (2013). “Toward an accelerated biodeterioration test to understand the behavior of Portland and calcium aluminate cementitous materials in sewer networks.” Int. Biodeterior. Biodegrad., 84, 236–243.
Islander, R. L., Devinny, J. S., Mansfeld, F., Postyn, A., and Shih, H. (1991). “Microbial ecology of crown corrosion in sewers.” J. Environ. Eng., 751–770.
Jensen, H. S., Nielsen, A. H., Hvitved-Jacobsen, T., and Vollertsen, J. (2009). “Modeling of hydrogen sulfide oxidation in concrete corrosion products from sewer pipes.” Water Environ. Res., 81(4), 365–373.
Kelly, D. P., and Wood, A. P. (2000). “Reclassification of some species of Thiobacillus to the newly designated genera Acidithiobacillus gen. nov., Halothiobacillus gen. nov. and Thermithiobacillus gen. nov.” Int. J. Syst. Evol. Microbiol., 50(2), 511–516.
Kleinjan, W. E., de Keizer, A., and Janssen, A. J. H. (2003). “Biologically produced sulfur.” Top. Curr. Chem., 230(1), 167–188.
Madsen, H. I., Vollertsen, J., and Hvitved-Jacobsen, T. (2006). “Gas phase transport in gravity sewers—a methodology for determination of horizontal gas transport and ventilation.” Water Environ. Res., 78(11), 2203–2209.
Nica, D., Davis, J. L., Kirby, L., Zuo, G., and Roberts, D. J. (2000). “Isolation and characterization of microorganisms involved in the biodeterioration of concrete in sewers.” Int. Biodeterior. Biodegrad., 46(1), 61–68.
Nielsen, A. H., Hvitved-Jacobsen, T., and Vollertsen, J. (2012). “Effect of sewer headspace air-flow on hydrogen sulfide removal by corroding concrete surfaces.” Water Environ. Res., 84(3), 265–273.
Nielsen, A. H., Vollertsen, J., Jensen, H. S., Wium-Andersen, T., and Hvitved-Jacobsen, T. (2008). “Influence of pipe material and surfaces on sulfide-related odor and corrosion in sewers.” Water Res., 42(15), 4206–4214.
Okabe, S., Odagiri, M., Ito, T., and Satoh, H. (2007). “Succession of sulfur-oxidizing bacteria in the microbial community on corroding concrete in sewer systems.” Appl. Environ. Microbiol., 73(3), 971–980.
Parker, C. D., and Prisk, J. (1953). “The oxidation of inorganic compounds of sulphur by various sulphur bacteria.” J. Gen. Microbiol., 8(3), 344–364.
Pomeroy, R. D., and Parkhurst, J. D. (1977). “The forecasting of sulfide buildup rates in sewers.” Prog. Water Technol., 9(3), 621–628.
Sand, W. (1997). “Microbial mechanisms of deterioration of inorganic substrates—a general mechanistic overview.” Int. Biodeterior. Biodegrad., 40(2–4), 183–190.
Shinabe, K., Oketani, S., Ochi, T., and Matsumura, M. (1995). “Characteristics of hydrogen sulfide removal by Thiobacillus thiooxidans KS1 isolated from a carrier-packed biological deodorization system.” J. Ferment. Bioeng., 80(6), 592–598.
Snell, F. D., Hilton, C. L., and Ettre, L. S. (1966–1974). Encyclopedia of industrial chemical analysis, Vol. 15, Interscience Publishers Division, Wiley, New York, 230.
U.S. Environmental Protection Agency (USEPA). (1974). “Sulfide control in sanitary sewerage systems.”, Washington, DC.
Vincke, E., Verstichel, S., Monteny, J., and Verstraete, W. (1999). “A new test procedure for biogenic sulfuric acid corrosion of concrete.” Biodegradation, 10(6), 421–428.
Vollertsen, J., Nielsen, A. H., Jensen, H. S., Wium-Andersen, T., and Hvitved-Jacobsen, T. (2008). “Corrosion of concrete sewers—the kinetics of hydrogen sulfide oxidation.” Sci. Total Environ., 394(1), 162–170.
Wirsen, C. O., et al. (2002). “Characterization of an autotrophic sulfide-oxidizing marine Arcobacter sp. that produces filamentous sulfur.” Appl. Environ. Microbiol., 68(1), 316–325.
Yongsiri, C., Vollertsen, J., and Hvitved-Jacobsen, T. (2005). “Influence of wastewater constituents on hydrogen sulfide emission in sewer networks.” J. Environ. Eng., 167–1683.
Zhang, L., De Schryver, P., De Gusseme, B., De Muynck, W., Boon, N., and Verstraete, W. (2008). “Chemical and biological technologies for hydrogen sulfide emission control in sewer systems: A review.” Water Res., 42(1–2), 1–12.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Feb 7, 2013
Accepted: Oct 4, 2013
Published online: Oct 7, 2013
Published in print: Feb 1, 2014
Discussion open until: Apr 27, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.