Preparation of Waterborne Polyurethane Foam with Active Carbon and Its Adsorption for Phenol in Aqueous Solution
Publication: Journal of Environmental Engineering
Volume 139, Issue 8
Abstract
Concerned about environmental pollution and health safety risks, waterborne polyurethane (WPU) was introduced in place of conventional binders in preparing an active carbon polyurethane foam, active carbon WPU foam (ACWPU foam), through two sequential steps. The scanning electron microscopy and wettability tests showed that the WPU-based process was effective for achieving a higher active carbon content, enhanced pores’ wall roughness, and improved hydrophilicity of the foam, which was explained by infrared spectroscopy. Adsorption behavior of the ACWPU foam for phenol in aqueous solutions was investigated by batch experiments. The results showed that the maximum removal capacity of phenol ( foam) with of sorbent was observed at at pH 7. Removals of more than 85% occurred in 2.5 h, and the loading half-time was calculated to be only 26.77 min. In addition, adsorption kinetic data were described by a pseudo-second-order equation and the equilibrium data fitted very well with the Langmuir and Temkin models. Further, the ACWPU foam could be fully recycled via 0.01 M NaOH. In general, WPU as an environmentally friendly binder had excellent application in preparing ACWPU foam. Meanwhile, this foam should be a promising adsorbent in the recovery of phenol.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors gratefully acknowledge financial support from the National Major Specific Program of Science and Technology on Controlling and Administering of Water’s Pollution (2008ZX07212-001-04), Key Research Program of Gansu Province (2GS064-A52-036-02, GS022-A52-082).
References
Ahmaruzzaman, M. (2008). “Adsorption of phenolic compounds on low-cost adsorbents: A review.” Adv. Colloid Interface Sci., 143(1–2), 48–67.
Aksu, Z., and Kabasakal, E. (2004). “Batch adsorption of 2,4-dichlorophenoxy-acetic acid (2,4-D) from aqueous solution by granular activated carbon.” Sep. Purif. Technol., 35(3), 223–240.
Ewa, L. B., René, S., Anja, D., Ute, B., and Matthias, K. (2008). “Effect of anionic and nonionic surfactants on the kinetics of the aerobic heterotrophic biodegradation of organic matter in industrial wastewater.” Water Res., 42(4–5), 923–930.
Fiamegos, Y., Stalikas, C., and Pilidis, G. (2002). “4-aminoantipyrine spectrophotometric method of phenol analysis study of the reaction products via liquid chromatography with diode-array and mass spectrometric detection.” Anal. Chim. Acta, 467(1–2), 105–114.
Furukawa, M., Hamada, Y., and Kojio, K. (2003). “Aggregation structure and mechanical properties of functionally graded polyurethane elastomers.” J. Polym. Sci. Part B: Polym. Phys., 41(20), 2355–2364.
Guido, B., Silvia, B., Carlo, R., and Laura, A. (2008). “Technologies for the removal of phenol from fluid streams: A short review of recent developments.” J. Hazard. Mater., 160(2–3), 265–288.
Hollender, J., et al. (2009). “Elimination of organic micropollutants in a municipal wastewater treatment plant upgraded with a full-scale post-ozonation followed by sand filtration.” Environ. Sci. Technol., 43(20), 7862–7869.
Jayakumar, R., and Nanjundan, S. (2004). “Calcium-containing poly(urethane-urea)s: Synthesis, spectral, and thermal studies.” J. Polym. Sci. Part A: Polym. Chem., 42(8), 1809–1819.
Jiang, X., et al. (2007). “Synthesis and degradation of nontoxic biodegradable waterborne polyurethanes elastomer with poly(-caprolactone) and poly(ethylene glycol) as soft segment.” Eur. Polym. J., 43(5), 1838–1846.
Jorgensen, T. C., and Weatherley, L. R. (2003). “Ammonia removal from wastewater by ion exchange in the presence of organic contaminants.” Water Res., 37(8), 1723–1728.
Jung, D. H., Kim, E. Y., Kang, Y. S., and Kim, B. K. (2010). “High solid and high performance UV cured waterborne polyurethanes.” Colloids Surf. A, 370(1–3), 58–63.
Katsaounos, C. Z., Paleologos, E. K., Giokas, D. L., and Karayannisa, M. I. (2003). “The 4-aminoantipyrine method revisited: Determination of trace phenols by micellar assisted preconcentration.” Int. J. Environ. Anal. Chem., 83(6), 507–514.
Li, F. K., Qi, L. Y., Yang, J. P., Xu, M., Luo, X. L., and Ma, D. Z. (2000). “Polyurethane/conducting carbon black composites: structure, electric conductivity, strain recovery behavior, and their relationships.” J. Appl. Polym. Sci., 75(1), 68–77.
Li, X. G., Ma, X. L., Sun, J., and Huang, M. R. (2009). “Powerful reactive sorption of silver (I) and mercury(II) onto poly (o-phenylenediamine) microparticles.” Langmuir, 25(3), 1675–1684.
Lin, S. H., and Juang, R. S. (2009). “Adsorption of phenol and its derivatives from water using synthetic resins and low-cost natural adsorbents: A review.” J. Environ. Manage., 90(3), 1336–1349.
Lin, S. H., and Peng, C. F. (1996). “Continuous treatment of textile wastewater by combined coagulation, electrochemical oxidation and activated sludge.” Water Res., 30(3), 587–592.
Liu, Q. S., Zheng, T., Wang, P., Jiang, J. P., and Li, N. (2010). “Adsorption isotherm, kinetic and mechanism studies of some substituted phenols on activated carbon fibers.” Chem. Eng. J., 157(2–3), 348–356.
Liu, Z., Kanjo, Y., and Mizutani, S. (2009). “Removal mechanisms for endocrine disrupting compounds (EDCs) in wastewater treatment—Physical means, biodegradation, and chemical advanced oxidation: A review.” Sci. Total Environ., 407(2), 731–748.
Madbouly, S. A., and Otaigbe, J. U. (2006). “Kinetic analysis of fractal gel formation in waterborne polyurethane dispersions undergoing high deformation flows.” Macromolecules, 39(12), 4144–4151.
Mequanint, K., and Sanderson, R. (2003). “Nano-structure phosphorus-containing polyurethane dispersions: Synthesis and crosslinking with melamine formaldehyde resin.” Polymer, 44(9), 2631–2639.
Moreno-Castilla, C. (2004). “Adsorption of organic molecules from aqueous solutions on carbon materials.” Carbon, 42(1), 83–94.
Nanda, A. K., and Wicks, D. A. (2006). “The influence of the ionic concentration, concentration of the polymer, degree of neutralization and chain extension on aqueous polyurethane dispersions prepared by the acetone process.” Polymer, 47(6), 1805–1811.
Ochiai, B., Amemiya, H., Yamazaki, H., and Endo, T. (2006). “Synthesis and properties of poly(carbonate-urethane) consisting of alternating carbonate and urethane moieties.” J. Polym. Sci. Part A: Polym. Chem., 44(9), 2802–2808.
Park, S. J., and Kim, K. D. (2001). “Influence of activation temperature on adsorption characteristics of activated carbon fiber composites.” Carbon, 39(11), 1741–1746.
Pinto, M. L., Pires, J., Carvalho, A. P., Carvalho, M. B., and Bordado, J. C. (2005). “Characterization of adsorbent materials supported on polyurethane foams by nitrogen and toluene adsorption.” Microporous Mesoporous Mater., 80(1–3), 253–262.
Pinto, M. L., Pires, J., Carvalho, A. P., Carvalho, M. B., and Bordado, J. C. (2006). “Synthesis and regeneration of polyurethane/adsorbent composites and their characterization by adsorption methods.” Microporous Mesoporous Mater., 89(1–3), 260–269.
Senturk, H. B., Ozdes, D., Gundogdu, A., Duran, C., and Soylak, M. (2009). “Removal of phenol from aqueous solutions by adsorption onto organomodified tirebolu bentonite: Equilibrium, kinetic and thermodynamic study.” J. Hazard. Mater., 172(1), 353–362.
Shan, G. B., Liu, H. Z., Xing, J. M., Zhang, G. D., and Wang, K. (2004). “Magnetic alumina sorbent for separating polycyclic aromatic compounds from model gasoline by π-complexation.” Ind. Eng. Chem. Res., 43(3), 758–761.
Sharaf, M. A., Sayed, S. A., Younis, A. A., Farag, A. B., and Arida, H. A. (2007). “Removal of ions from aqueous solution by ETS-4 microporous titanosilicate-kinetic and equilibrium studies.” Anal. Lett., 40(18), 3443–3456.
Song, Z., Williams, C. J., and Edyvean, R. G. J. (2000). “Sedimentation of tannery wastewater.” Water Res., 34(7), 2171–2176.
Srihari, V., and Das, A. (2008). “The kinetic and thermodynamic studies of phenol-sorption onto three agro-based carbons.” Desalination, 225(1–3), 220–234.
Sud, D., Mahajana, G., and Kaura, M. P. (2008). “Agricultural waste material as potential adsorbent for sequestering heavy metal ions from aqueous solutions—A review.” Bioresour. Technol., 99(14), 6017–6027.
Takeichi, T., Yamazaki, Y., Zuo, M., Ito, A., Matsumoto, A., and Inagaki, M. (2001). “Preparation of porous carbon films by the pyrolysis of poly(urethane-imide) films and their pore characteristics.” Carbon, 39(2), 257–265.
Thuan, T., Chung, Y., and Ahn, D. (2003). “Study of nitrogen and organics removal in sequencing batch reactor (SBR) using hybrid media.” J. Environ. Sci. Health. Part A, 38(3), 577–588.
Verma, V. K., Tewari, S., and Rai, J. P. N. (2008). “Ion exchange during heavy metal bio-sorption from aqueous solution by dried biomass of macrophytes.” Bioresour. Technol., 99(6), 1932–1938.
Vierke, L., et al. (2011). “Air concentrations and particle–gas partitioning of polyfluoroalkyl compounds at a wastewater treatment plant.” Environ. Chem., 8, 363–371.
Wan Ngah, W. S., and Hanafiaha, M. A. K. M. (2008). “Removal of heavy metal ions from wastewater by chemically modified plant wastes as adsorbents: A review.” Bioresour. Technol., 99(10), 3935–3948.
Xu, Y., et al. (2004). “The synthesis of novel porous functional materials for use as nitrosamine traps.” Adv. Funct. Mater., 14(11), 1113–1123.
Yavuz, Y., Koparal, A. S., and Ögütveren, Ü. B. (2007). “Phenol removal through chemical oxidation using fenton reagent.” Chem. Eng. Technol., 30(5), 583–586.
Zhou, L., Hu, J., Zhong, H., and Li, X. (2012). “Study of phenol removal using fluidized-bed Fenton process.” Chem. Eng. Res. Des., 90(3), 377–382.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: May 8, 2012
Accepted: Mar 5, 2013
Published online: Mar 7, 2013
Published in print: Aug 1, 2013
Discussion open until: Aug 7, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.