Arsenic Species Transformation and Transportation in Arsenic Removal by Fe-Mn Binary Oxide–Coated Diatomite: Pilot-Scale Field Study
Publication: Journal of Environmental Engineering
Volume 137, Issue 12
Abstract
The removal of arsenic (As) by iron (Fe)-manganese (Mn) binary oxide–coated diatomite (FMBO-diatomite) and the transformation and transportation of As, Fe, and Mn in a fixed-bed reactor were investigated in this pilot-scale field study (arsenite , arsenate ). Before regeneration, the effluent As(tot) was reduced to less than with no residual As(III). FMBO-diatomite exhibited elevated adsorptive capability of As after in situ regenerations with breakthrough bed volumes increasing from 550 to 760 bed volumes after three cycles of operation. The residual concentrations of As(III) and As(V) at different layers along the adsorption column indicated the oxidation of As(III) and the As transportation during the filter layer. Additionally, FMBO-diatomite could efficiently remove the turbidity, Fe and Mn in influents, without causing secondary pollution. Acid dilution analysis showed more Fe content and less Mn content after three cycles through the FMBO-diatomite upper layer. This was attributable to the oxidation of As(III) and Fe(II) by manganese dioxide () within FMBO and the transportation of Mn(II) thereafter. The backwashing procedure led to a size classification of adsorbents. However, the FMBO-diatomite also showed increased size diameter after three cycles of operation because of the in situ regeneration.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the Funds for the Creative Research Groups of China (UNSPECIFIED50921064), the key project of National “863” High-Tech Research and Development Program of China (UNSPECIFIED2009AA062905), and the crucial project of the National Water Pollution Control and Management Science (UNSPECIFIED2009ZX07424-002-004).
References
Chang, F. F., Qu, J. H., Liu, H. J., Liu, R. P., and Zhao, X. (2009). “Fe-Mn binary oxide incorporated into diatomite as an adsorbent for arsenite removal: Preparation and evaluation.” J. Colloid Interface Sci., 338(2), 353–357.
Chang, F. F., Qu, J. H., Liu, R. P., Zhao, X., and Lei, P. J. (2010). “Practical performance and its efficiency of arsenic removal from groundwater using Fe-Mn binary oxide.” J. Environ. Sci. (China), 22(1), 1–6.
Chen, W., Parette, R., Zou, J., Cannon, F. S., and Dempsey, B. A. (2007). “Arsenic removal by iron-modified activated carbon.” Water Res., 41(9), 1851–1858.
Goyal, M., Bhagat, M., and Dhawan, R. (2009). “Removal of mercury from water by fixed bed activated carbon columns.” J. Hazard. Mater., 171(1–3), 1009–1015.
Guo, X., and Chen, F. (2005). “Removal of arsenic by bead cellulose loaded with iron oxyhydroxide from groundwater.” Environ. Sci. Technol., 39(17), 6808–6818.
Hughes, M. F. (2002). “Arsenic toxicity and potential mechanisms of action.” Toxicol. Lett., 133(1), 1–16.
Katsoyiannis, I., Zouboulis, A., Althoff, H., and Bartel, H. (2002). “As(III) removal from groundwater using fixed-bed upflow bioreactors.” Chemosphere, 47(3), 325–332.
Lee, S. M., Tiwari, D., Choi, K. M., Yang, J. K., Chang, Y. Y., and Lee, H. D. (2009). “Removal of Mn(II) from aqueous solutions using manganese-coated sand samples.” J. Chem. Eng. Data, 54(6), 1823–1828.
Mandal, B. K., and Suzuki, K. T. (2002). “Arsenic round the world: A review.” Talanta, 58(1), 201–235.
Medvidovic, N. V., Peric, J., and Trgo, M. (2006). “Column performance in lead removal from aqueous solutions by fixed bed of natural zeolite-clinoptilolite.” Sep. Purif. Technol., 49(3), 237–244.
Mohan, D., Charles, U., and Pittman, J. (2007). “Arsenic removal from water/wastewater using adsorbents—A critical review.” J. Hazard. Mater., 142(1–2), 1–53.
Nikolaidis, N. P., Dobbs, G. M., and Lackovic, J. A. (2003). “Arsenic removal by zero-valent iron: Field, laboratory and modeling studies.” Water Res., 37(6), 1417–1425.
Sasaki, K., Nakano, H., Wilopo, W., Miura, Y., and Hirajima, T. (2009). “Sorption and speciation of arsenic by zero-valent iron.” Colloids Surf., A, 347(1–3), 8–17.
Smedley, P. L., and Kinniburgh, D. G. (2002). “A review of source, behaviors and distribution of arsenic in natural waters.” Appl. Geochem., 17(5), 517–568.
Sperlich, A., Werner, A., Genz, A., Amy, G., Worch, E., and Jekel, M. (2005). “Breakthrough behaviour of granular ferric hydroxide (GFH) fixed-bed adsorption filters: modeling and experimental approaches.” Water Res., 39(6), 1190–1198.
Stahl, R. S., and James, B. R. (1991). “Zinc sorption by iron-coated sand as a function of pH.” Soil Sci. Soc. Am. J., 55(5), 1287–1290.
Zhang, G. S., Qu, J. H., Liu, H. J., Liu, R. P., and Li, G. T. (2007a). “Removal mechanism of As(III) by a novel Fe-Mn binary oxide adsorbent: Oxidation and sorption.” Environ. Sci. Technol., 41(13), 4613–4619.
Zhang, G. S., Qu, J. H., Liu, H. J., Liu, R. P., and Wu, R. C. (2007b). “Preparation and evaluation of a novel Fe-Mn binary oxide adsorbent for effective arsenite removal.” Water Res., 41(9), 1921–1927.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Oct 16, 2010
Accepted: May 24, 2011
Published online: May 26, 2011
Published in print: Dec 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.