Bench-Scale Evaluation of Chemically Bonded Phosphate Ceramic Technology to Stabilize Mercury Waste Mixtures
Publication: Journal of Environmental Engineering
Volume 136, Issue 3
Abstract
This bench-scale study was conducted to evaluate the stabilization of mercury (Hg) and mercuric chloride-containing surrogate test materials by the chemically bonded phosphate ceramics technology. This study was performed as part of a U.S. EPA program to evaluate treatment and disposal alternatives to the current land disposal restriction (LDR) treatment standards for mercury. The stabilized materials were subjected to a suite of leaching tests: one test characterized the solubility and release behavior of mercury as a function of pH between the pH values of 2 and 12; the second test used the toxicity characteristic leaching procedure (TCLP); and the third leaching test used the TCLP “cage” modification. TCLP results showed that leachability of Hg decreased by approximately two orders of magnitude and a maximum of five orders of magnitude. The three leachability test methods produced similar amounts of leached mercury, but the test that studied mercury solubility as a function of pH released slightly higher levels (at pH 2) compared to the TCLP methods. On comparing the results obtained with the standard TCLP and the TCLP cage modification, we learned that the leachates from stabilized wastes containing 50 wt % loading of elemental Hg and were within the LDR requirements. However, wastes containing higher loadings (i.e., 70 wt % loading of Hg and ) had leachate concentrations exceeding the 0.2 mg/L treatment standard and therefore would not meet the Resource Conservation and Recovery Act disposal requirements.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by the U.S. EPA through the Office of Research and Development in Cincinnati. The writers thank Dr. Arun Wagh and Dr. S. Jeong for their assistance in this research. This paper has not been subjected to the agency’s review and therefore does not necessarily reflect the views of the agency, and no official endorsement should be inferred. Mention of trade names or commercial products does not constitute endorsement or recommendation for use.
References
Banerjee, S. (2005). “Analysis of a chemically bonded phosphate ceramic as an alternative oilfield cementing system for arctic regions.” MS thesis, Univ. of Alaska, Fairbanks, Alaska.
Barth, E. (1990). Stabilization and solidification of hazardous wastes, Noyes Data Corporation, Park Ridge, N.J.
Brookhaven National laboratory (BNL). (2002). “Brookhaven lab licenses its mercury-waste treatment technology to Newmont Mining Corporation 2002.” ⟨http://www.bnl.gov/bnlweb/pubaf/pr/2001/bnlpr053101.htm⟩ (Jan. 23, 2008).
Chan, Y. M., Agamuthu, P., and Mahalingam, R. (2000). “Solidification and stabilization of asbestos waste from an automobile brake manufacturing facility using cement.” J. Hazard. Mater., 77(1–3), 209–226.
Code of Federal Regulations (CFR). (2008). “Land disposal restrictions.” Title 40, Part 268.
Conner, J. R. (1990). Chemical fixation and solidification of hazardous wastes, Van Nostrand Reinhold, New York.
Fuhrmann, M., Melamed, D., Kalb, P. D., Adams, J. W., and Milian, L. W. (2002). “Sulfur polymer solidification/stabilization of elemental mercury waste.” Waste Manage., 22, 327–333.
Huggins, F. E., Huffman, G. P., Dunham, G. E., and Senior, C. L. (1999). “XAFS examination of mercury capture on three activated carbons.” Energy Fuels, 13(1), 114–121.
Jeong, S. (1997). “Development of chemically bonded phosphate ceramics for stabilizing low-level mixed wastes.” Ph.D. thesis, Illinois Institute of Technology, Chicago.
Kalb, P. D., Adams, J. W., and Milian, L. W. (2001). “Sulfur polymer stabilization/solidification (SPSS) of treatment of mixed-waste mercury recovered from environmental restoration activities at BNL.” Rep. No. BNL-52614, U.S. DOE.
Karatza, D., Lancia, A., Musmarra, D., and Zucchini, C. (2000). “Study of mercury adsorption and desorption on sulfur impregnated carbon.” Exp. Therm. Fluid Sci., 21, 150–155.
Kim, J., Kim, H., Park, H., and Suh, I. (1992). “ Cementation of Borate waste by adding slaked lime.” Solidification/stabilization of hazardous, radioactive and mixed waste, T. Gilliam and C. Wiles, eds., American Society for Testing and Materials, Philadelphia, 338–347.
Kosson, D. S., Van der Sloot, H. A., Sanchez, F., and Garrabrants, A. C. (2002). “An integrated framework for evaluating leaching in waste management and utilization of secondary materials.” Environ. Eng. Sci., 19(3), 159–204.
Liu, Z., Qian, G., Zhou, J., Li, C., Xu, Y., and Qin, Z. (2008). “Improvement of ground granulated blast furnace slag on stabilization/solidification of simulated mercury-doped wastes in chemically-bonded phosphate ceramics.” J. Hazard. Mater., 157(1), 146–153.
Mayberry, J., Harry, T. L., and DeWitt, L. M. (1992). “Technical area status report for low-level mixed waste final waste forms.” Rep. No. DOE/MWIP-3, U.S. DOE.
Means, J. L., et al. (1995). The application of solidification/stabilization to waste materials, Lewis, Boca Raton, Fla.
Morgan, I. L., and Bostick, W. D. (1992). “Performance testing of grout-based waste forms for the solidification of anion exchange resins.” STP 1123, West Conshohocken, Pa.
Morris, M. I., Osborne-Lee, I. W., and Hulet, G. A. (2002). “Demonstration of new technologies required for the treatment of mixed waste contaminated with mercury.” Rep. No. ORNL/TM-20000/147, U.S. DOE Office of Science and Technology TRU and Mixed Waste Focus Area, Washington, D.C.
Randall, P., and Chattopadhyay, S. (2004). “Advances in encapsulation technologies for the management of mercury-contaminated hazardous wastes.” J. Hazard. Mater., 114, 211–223.
Rogers, T., and Goldblatt, S. D. (2000). “The DETOXSM demonstration project—A revised approach to demonstrate and deployment.” Proc., Waste Management Conf., Waste Management Symposia, Tucson, Ariz.
Sanchez, F., Mattus, C. H., Morris, M. I., and Kosson, D. S. (2002). “Use of a new leaching test framework for evaluating alternative treatment processes for mercury-contaminated soils.” Environ. Eng. Sci., 19(4), 251–269.
Singh, D., Wagh, A. S., Tlustochowicz, M., and Jeong, S. Y. (1998). “Phosphate ceramic process for macroencapsulation and stabilization of low-level debris wastes.” Waste Manage., 18, 135–143.
Stumm, W. (1992). Chemistry of the solid-water interface, Wiley, New York.
Thornber, M. R. (1992). “The chemical mobility and transport of elements in the weathering environment.” Handbook of exploration geochemistry, C. R. M. Butt and H. Zeegers, eds., Elsevier Science, New York, 79–96.
U.S. DOE. (1999). “Stabilization using phosphate bonded ceramics.” Rep. No. DOE/EM-0486, Office of Science and Technology, Washington, D.C.
U.S. DOE. (2000). DOE research and development portfolio: Environmental quality, Vol. 2, Office of Science and Technology, Washington, D.C.
U.S. EPA. (1991). “Leachability phenomena.” Rep. No. EPA/SAB/EEC-92/003, Science Advisory Board, Washington, D.C.
U.S. EPA. (1999). “Waste leachability: The need for review of current agency procedures.” Rep. No. EPA/SAB/EEC-99/002, Science Advisory Board, Washington, D.C.
U.S. EPA. (2001). “Workshop on mercury in products, processes, waste and the environment: Eliminating, reducing and managing risks from non-combustion sources.” Rep. No. EPA/625/R-00/014.
U.S. EPA. (2003). “Evaluation of chemically bonded phosphate ceramics for mercury stabilization of a mixed synthetic waste.” Rep. No. EPA/600/R-03/113.
Wagh, A. S. (2004). Chemically bonded phosphate ceramics: Twenty-first century materials with diverse applications, Elsevier Science, New York.
Wagh, A. S., Singh, D., and Jeong, S. -Y. (2001). “Chemically bonded phosphate ceramics for stabilization and solidification of mixed waste.” Hazardous and radioactive waste treatment technologies handbook, C. H. Oh, ed., CRC, Boca Raton, Fla.
Wagh, A. S., Singh, D., Jeong, S. -Y., and Strain, R. (1997). “Ceramicrete stabilization of low-level mixed wastes—A complete story.” 18th U.S. DOE Low-Level Radioactive Waste Management Conf., U.S. DOE.
Wollast, R., Billen, G., and Mackenzie, F. F. (1975). “Behavior of mercury in natural systems and its global cycle.” Ecological toxicology research, A. R. McIntyre and C. F. Mills, eds., Plenum, New York, 145–166.
Zhang, J., and Bishop, P. L. (2002). “Stabilization/solidification (S/S) of mercury-containing wastes using reactivated carbon and portland cement.” J. Hazard. Mater., 92, 199–212.
Information & Authors
Information
Published In
Copyright
© 2010 ASCE.
History
Received: Jan 23, 2008
Accepted: Aug 19, 2009
Published online: Aug 24, 2009
Published in print: Mar 2010
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.