Effect of Inclination Angle on the Heat Transfer Performance of a Two-Phase Closed Thermosyphon under Low-Temperature Conditions
Publication: Journal of Cold Regions Engineering
Volume 28, Issue 4
Abstract
In this study, a series of laboratory investigations were performed to examine the heat transfer performance of a two-phase closed thermosyphon (TPCT) with different inclination angles under low-temperature conditions. A stainless steel TPCT with ammonia as the working fluid was tested with inclination angles ranging from 0 to 90° from the horizontal. In order to simulate low-temperature conditions, the temperature in the jacket of evaporator section was controlled at , and the temperature in the jacket of the condenser section was changed from to . The experimental results show that inclination angle has a significant impact on the heat transfer performance of a TPCT under the experimental conditions, but the inclination angle does not control the startup temperature difference for the TPCT when the inclination angle is more than 0°. A horizontal TPCT has a good heat transfer performance and a small startup temperature difference; however, the thermal semiconduction effect disappears, because gravity has a limited effect on the circulation of the working fluid in a horizontal TCPT. These research results can help to guide decisions about the placement angle of TPCTs in cold regions engineering.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The paper benefited from the constructive comments of two anonymous reviewers. The research was supported by the CAS Action-Plan for West Development (Grant No. KZCX2-XB3-19), the 100-Talent Program of the Chinese Academy of Sciences (Granted to Dr. Mingyi Zhang), the Knowledge Innovation Program of the Chinese Academy of Sciences (Grant No. KZCX2-EW-QN301), the National key Basic Research Program of China (973 Program Grant No. 2012CB026102), the National Natural Science Foundation of China (Grant Nos. 41230630, 41101068), and Youth Innovation Promotion Association, CAS.
References
Cheng, G. D., Jiang, H., Wang, K. L., and Wu, Q. B. (2003). “Thawing index and freezing index on the embankment surfacein permafrost regions.” J. Glaciol. Geocryol., 25(6), 603–607.
Cheng, G. D., Sun, Z. Z., and Niu, F. J. (2008). “Application of the roadbed cooling approach in Qinghai–Tibet railway engineering.” Cold Reg. Sci. Technol., 53(3), 241–258.
Forsstrom, A., Long, E. L., Zarling, J. P., and Knutsson, S. (2002). “Thermosyphon cooling of Chena Hot Springs Road.” Proc., 11th Int. Conf. on Cold Regions Engineering, Anchorage, AK, 645–655.
Haynes, F. D., and Zarling, J. P. (1988). “Thermosyphons and foundation design in cold regions.” Cold Reg. Sci. Technol., 15(3), 251–259.
Heuer, C. E. (1979). The application of heat pipes on the Trans-Alaska pipeline, Directorate of Military Programs Office, Chief of Engineers. United States Army Corps of Engineers, Cold Regions Research and Engineering Laboratory, Hanover, NH.
Hussein, H. M. S., Mohamad, M. A., and El-Asfouri, A. S. (2001). “Theoretical analysis of laminar-film condensation heat transfer inside inclined wickless heat pipes flat-plate solar collector.” Renew. Energy, 23(3–4), 525–535.
Lai, Y. M., Zhang, M. Y., and Li, S. Y. (2009). Theory and application of cold regions engineering, Science Press, Beijing, China.
Liu, F. X., Liu, J. K., Guo, D. H., and Zhang, L. X. (2004). “Numerical analysis of thermosyphon in protecting the roadbed in permafrost.” China Civ. Eng. J., 37(9), 41–47.
Ma, T. Z., Hou, Z. Q., and Wu, W. X. (1983). Heat pipe, Science Press, Beijing, China.
Negishi, K., and Sawada, T. (1983). “Heat transfer performance of an inclined two-phase closed thermosyphon.” Int. J. Heat Mass Transfer, 26(8), 1207–1213.
Noie, S. H. (2005). “Heat transfer characteristics of a two-phase closed thermosyphon.” Appl. Therm. Eng., 25(4), 495–506.
Noie, S. H., SarmastiEmami, M. R., and Khoshnoodi, M. (2007). “Effect of inclination angle and filling ratio on thermal performance of a two-phase closed thermosyphon under normal operating conditions.” Heat Transfer Eng., 28(4), 365–371.
Pan, W. D., Zhao, S. C., Xu, W. Z., Yu, S. S., and Ma, W. D. (2003). “Application of thermal probe to enhance thermal stability of roadbed in plateau permafrost areas.” J. Glaciol. Geocryology, 25(4), 433–438.
Parametthanuwat, T., Rittidech, S., and Pattiya, A. (2010). “A correlation to predict heat-transfer rates of a two-phase closed thermosyphon (TPCT) using silver nanofluid at normal operating conditions.” Int. J. Heat Mass Transfer, 53(21–22), 4960–4965.
Payakaruk, T., Terdtoon, P., and Ritthidech, S. (2000). “Correlations to predict heat transfer characteristics of an inclined closed two-phase thermosyphon at normal operating conditions.” Appl. Therm. Eng., 20(9), 781–790.
Shiraishi, M., Kikuchi, K., and Yamanishi, T. (1981). “Investigation of heat transfer characteristics of a two-phase closed thermosyphon.” J. Heat Recovery Syst., 1(4), 287–297.
Tao, W. Q. (2006). Heat transfer, Northwestern Polytechnical Univ. Press, Xi’an, China.
Wang, S. J., Huang, X. M., Chen, J. B., and Zhang, J. Z. (2005). “Research on frozen soil subgrade cooling by non-power heat pipe.” J. Highway Transp. Res. Dev., 22(3), 1–4.
Wen, Z., Sheng, Y., Ma, W., Qi, J. L., and Wu, J. C. (2005). “Analysis on effect of permafrost protection by two-phase closed thermosyphon and insulation jointly in permafrost regions.” Cold Reg. Sci. Technol., 43(3), 150–163.
Wu, J. J., Ma, W., Sun, Z. Z., and Wen, Z. (2010). “In-situ study on cooling effect of the two-phase closed thermosyphon and insulation combinational embankment of the Qinghai–Tibet Railway.” Cold Reg. Sci. Technol., 60(3), 234–244.
Xu, J., and Goering, D. J. (2008). “Experimental validation of passive permafrost cooling systems.” Cold Reg. Sci. Technol., 53(3), 283–297.
Yang, Y. P., Wei, Q. C., Zhou, S. H., and Zhang, L. X. (2005). “Thermosyphon technology and its application in permafrost.” Chin. J. Geotech. Eng., 27(6), 698–706.
Yang, Y. P., Zhou, S. H., and Wei, Q. C. (2006). “Numerical analysis of proper thermosyphon inclination angle used in permafrost embankment.” China Railway Sci., 27(3), 1–7.
Zarling, J. P., and Brayley, W. A. (1986). Thaw stabilization of roadway embankments constructed over permafrost, Alaska Dept. of Transportation and Public Facilities, Engineering Research Center, Institute of Northern Engineering, Univ. of Alaska-Fairbanks, Fairbanks, AK.
Zhang, M. Y., Lai, Y. M., Dong, Y. H., Jin, L., Pei, W. S., and Harbor, J. (2013). “Laboratory investigation of the heat transfer characteristics of a two-phase closed thermosyphon.” Cold Reg. Sci. Technol., 95, 67–73.
Zhang, M. Y., Lai, Y. M., Zhang, J. M., and Sun, Z. Z. (2011). “Numerical study on cooling characteristics of two-phase closed thermosyphon embankment in permafrost regions.” Cold Reg. Sci. Technol., 65(2), 203–210.
Zhuang, J., and Zhang, H. (2000). Heat pipe technology and engineering application, Chemical Industry Press, Beijing, China.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Dec 2, 2013
Accepted: May 19, 2014
Published online: Jul 8, 2014
Published in print: Dec 1, 2014
Discussion open until: Dec 8, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.