Combined Effects of Saltwater and Water Flow on Deterioration of Concrete under Freeze–Thaw Cycles
Publication: Journal of Cold Regions Engineering
Volume 25, Issue 4
Abstract
This article outlines the combined effects of saltwater and water flow on deterioration of concrete under freezing and thawing cycles. In order to simulate the real freezing situation that concrete usually undergoes, four sets of experimental exposure conditions were designed. These exposure conditions include plain flowing water, flowing saltwater, still plain water, and still saltwater. Two types of concrete samples with different water–cement ratios were prepared. Weight and compressive strength of the samples were measured before and after the freeze–thaw cycles, and the results were analyzed. Based on the results, quantitative damage models were developed to predict mass loss and compressive strength loss. The results showed that water flow accelerates the deterioration of concrete and that the combined effects of saltwater and water flow are more severe and cause rapid deterioration.
Get full access to this article
View all available purchase options and get full access to this article.
References
Achintya, and Prasad, M. (2003). “Behaviour of concrete in freeze–thaw environment of sea water.” J. Inst. Eng. India Civil Eng. Div., 84, 96–101.
American Concrete Institute (ACI). (2002). “Guide for selecting proportions for no-slump concrete.” ACI 211.3R, ACI, Detroit.
Basheer, L., and Cleland, D. J. (2006). “Freeze–thaw resistance of concrete treated with pore liners.” J. Constr. Build. Mat., 20(10), 990–998.
Cho, T. (2007). “Prediction of cyclic freeze–thaw damage in concrete structures based on response surface method.” J. Constr. Build. Mater., 21(12), 2031–2040.
Copuroglu, O. (2006). “The characterisation, improvement and modelling aspects of frost salt scaling of cement-based materials with a high slag content.” Ph.D. dissertation, Technical Univ. of Delft, Netherlands.
Du, L., and Folliard, K. (2005). “Mechanisms of air entrainment in concrete.” J. Cem. Concr. Res., 35(8), 1463–1471.
Fagerlund, G. (1997). “Internal frost attack—State of the art in frost resistance of concrete.” Proc., RILEM Workshop on Frost Resistance of Concrete, M. Setzer and R. Auberg, eds., E. & F. N. Spon, Essen, Germany, 319–338.
Hale, M., Freyne, S., and Russell, B. (2009). “Examining the frost resistance of high performance concrete.” J. Constr. Build. Mater., 23(2), 878–888.
Harnick, A. B., Meier, V., and Rosli, A. (1980). “Combined influence of freezing and deicing salt on concrete: physical aspects.” Durability of building materials and components: ASTM STP 691, P. J. Sereda and G. G. Litvan, eds., ASTM, Philadelphia, 474–484.
Kaufmann, J. (1999). “Experimental identification of damage mechanisms in cementitious porous materials on phase transition of pore solution under frost deicing salt attack.” Thesis, École Polytechnique Fédérale de Lausanne, Lausanne, Switzerland.
Kaufmann, J. (2004). “Experimental identification of ice formation in small concrete pores.” J. Cem. Concr. Res., 34(8), 1421–1427.
Litvan, G. G. (1976). “Frost action in cement in the presence of deicers.” J. Cem. Concr. Res., 6(3), 351–356.
Nixon, P. J., Page, C. L., Canham, I., and Bollinghaus, R. (1988). “Influence of sodium chloride on the ASR.” Adv. Cem. Res., 1(2), 99–105.
Panesar, D. K., and Chidiac, S. E. (2008). “Evolution of mechanical properties of concrete containing ground granulated blast furnace slag and effects on the scaling resistance test at 28 days.” Cem. Concr. Compos., 30(2), 63–71.
Panesar, D. K., and Chidiac, S. E. (2009). “Capillary suction model for characterizing salt scaling resistance of concrete containing GGBFS.” J. Cem. Concr. Compos., 31(8), 570–576.
Penttala, V. (2006). “Surface and internal deterioration of concrete due to saline and non-saline freeze–thaw loads.” J. Cem. Concr. Res., 36(5), 921–928.
Powers, T. C., and Helmuth, R. A. (1953). “Theory of volume changes in hardened cement paste during freezing.” Proc., Highway Research Board Annual Meeting, 32, Highway Research Board, Washington, DC, 285.
Scherer, G. (1999). “Crystallisation in pores.” Cem. Concr. Res., 29(8), 1347–1358.
Setzer, M. J. (1976). “Action of frost and deicing chemicals: Basic phenomena and testing.” Freeze—thaw durability of concrete, J. Marchand, M. Pigeon, and M. Zetzer, eds., E. & F. N. Spon, London, 3–21.
Shang, H. S., and Song, Y. P. (2006). “Experimental study of strength and deformation of plain concrete under biaxial compression after freezing and thawing cycles.” J. Cem. Concr. Res., 36(10), 1857–1864.
Valenza, J. J., and Scherer, G. W. (2006). “Mechanism for salt scaling.” J. Am. Cera. Soc., 89(4), 1161–1179.
Wang, K., Nelsen, D., and Nixon, W. (2006). “Damaging effects of deicing chemicals on concrete materials.” J. Cem. Concr. Compos., 28(2), 173–188.
Information & Authors
Information
Published In
Copyright
© 2011 American Society of Civil Engineers.
History
Received: Jan 6, 2010
Accepted: May 2, 2011
Published online: May 5, 2011
Published in print: Dec 1, 2011
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.