Rock Deformation under Various Degrees of Karst Development
Publication: Journal of Performance of Constructed Facilities
Volume 33, Issue 5
Abstract
Karst development and the deformation response of erosive rocks significantly influence the stability of cutting slopes. In this research, cutting slopes for high-speed railways was investigated in karst areas, and four representative points with various degrees of karst development were chosen to examine the rock response by applying rectangular rigid bearing plate tests. The displacement distribution of the rock under the plate was analyzed using elastic half space model theory. Results corroborate that, although the erosive rock experienced loading–unloading cyclic loading, the envelope diagram was upward convex. When a relatively lower load was applied, the slope of the curve was steep, and the rock deformation was smaller. As the load increased, the slope of the curve became moderate; under the same load condition, rocks with a high degree of karst development had high deformation and deformation modulus values. However, rocks that were less influenced or unaffected by karst development had minimal deformation. At the same point under the bearing plate, increasing the load enhanced the displacement of the point, and the deformation value became high as the degree of karst development strengthened.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work is supported by the National Natural Science Foundation of China (Nos. 41672339 and 41072256). The authors would like to express their gratitude to the editors and reviewers for their constructive and helpful review comments. They declare no conflicts of interest.
References
Alber, M., R. Fritschen, M. Bischoff, and T. Meier. 2009. “Rock mechanical investigations of seismic events in a deep longwall coal mine.” Int. J. Rock Mech. Min. Sci. 46 (2): 408–420. https://doi.org/10.1016/j.ijrmms.2008.07.014.
Alija, S., F. J. Torrijo, and M. Q. Ferreira. 2013. “Geological engineering problems associated with tunnel construction in karst rock masses: The case of Gavarres tunnel (Spain).” Eng. Geol. 157 (May): 103–111. https://doi.org/10.1016/j.enggeo.2013.02.010.
Bai, M. Z., J. Lei, Z. Y. Xu, H. Shiet al. 2018. Prevention of karst disasters in traffic construction, 10–30. [In Chinese.] Beijing: Beijing Jiaotong University Press.
Cai, M., and P. K. Kaiser. 2004. “Numerical simulation of the Brazilian test and the tensile strength of anisotropic rocks and rocks with pre-existing cracks.” Supplement, Int. J. Rock Mech. Min. Sci. 41 (S1): 478–483. https://doi.org/10.1016/j.ijrmms.2004.03.086.
Celal, A. 2014. “Determination of the deformation modulus of dispersible-intercalated-jointed cherts using the Menard pressuremeter test.” Int. J. Rock Mech. Min. Sci. 65 (Jan): 20–28. https://doi.org/10.1016/j.ijrmms.2013.11.004.
Codeglia, D., N. Dixon, G. J. Fowmes, and G. Marcato. 2017. “Analysis of acoustic emission patterns for monitoring of rock slope deformation mechanisms.” Eng. Geol. 219 (Mar): 21–31. https://doi.org/10.1016/j.enggeo.2016.11.021.
Fengier, J., A. Pożarycki, and T. Garbowski. 2013. “Stiff-plate bearing test simulation based on FWD results.” Procedia Eng. 57: 270–277. https://doi.org/10.1016/j.proeng.2013.04.037.
Karaman, K., F. Cihangir, and A. Kesimal. 2015. “A comparative assessment of rock mass deformation modulus.” Int. J. Min. Sci. Technol. 25 (5): 735–740. https://doi.org/10.1016/j.ijmst.2015.07.006.
Kavur, B., N. Cvitanović, and P. Hrženjak. 2015. “Comparison between plate jacking and large flat jack test results of rock mass deformation modulus.” Int. J. Rock Mech. Min. Sci. 73 (Jan): 102–114. https://doi.org/10.1016/j.ijrmms.2014.09.022.
NRAC (National Railway Administration of China). 2013. Railway engineering rock experiment tutorial. [In Chinese.] Beijing: NRAC.
Ouyang, X. Z. 2013. Karst geology, 1–7. [In Chinese.] Beijing: China Water and Power Press.
Palmström, A., and R. Singh. 2001. “The deformation modulus of rock masses-comparisons between in situ tests and indirect estimates.” Tunnelling Underground Space Technol. 16 (2): 115–131. https://doi.org/10.1016/S0886-7798(01)00038-4.
Reninger, P. A., G. Martelet, E. Lasseur, L. Beccaletto, J. Deparis, J. Perrin, and Y. Chen. 2014. “Geological environment of karst within chalk using airborne time domain electromagnetic data cross-interpreted with boreholes.” J. Appl. Geophys. 106 (Jul): 173–186. https://doi.org/10.1016/j.jappgeo.2014.04.020.
Sainoki, A., S. Tabata, H. S. Mitri, D. Fukuda, and J. I. Kodama. 2017. “Time-dependent tunnel deformations in homogeneous and heterogeneous weak rock formations.” Comput. Geotech. 92 (Dec): 186–200. https://doi.org/10.1016/j.compgeo.2017.08.008.
Selvadurai, A. S. 2009. “Boussinesq indentation of an isotropic elastic halfspace reinforced with an inextensible membrane.” Int. J. Eng. Sci. 47 (11–12): 1339–1345. https://doi.org/10.1016/j.ijengsci.2008.08.004.
Shahri, A. A., S. Larsson, and F. Johansson. 2016. “Updated relations for the uniaxial compressive strength of marlstones based on P-wave velocity and point load index test.” Innovative Infrastruct. Solutions 1 (1): 17. https://doi.org/10.1007/s41062-016-0016-9.
Song, K., G. C. Cho, and S. B. Chang. 2012. “Identification, remediation, and analysis of karst sinkholes in the longest railroad tunnel in South Korea.” Eng. Geol. 135–136 (May): 92–105. https://doi.org/10.1016/j.enggeo.2012.02.018.
Szczygieł, J., M. Golicz, H. Hercman, and E. Lynch. 2018. “Geological constraints on cave development in the plateau-gorge karst of South China (Wulong, Chongqing).” Geomorphology 304 (Mar): 50–63. https://doi.org/10.1016/j.geomorph.2017.12.033.
Tang, A. S., S. H. Xiong, H. M. Zhou, Z. W. Zhong, and Z. J. Pang. 2008. “Adaptation research of bearing plate method in deformation test.” [In Chinese.] J. Yangtze River Sci. Res. Inst. 28 (5): 7–15. https://doi.org/10.3969/j.issn.1001-5485.2008.05.002.
Yang, W. D., Y. Q. Zhang, F. Chen, W. G. Li, J. H. Wang, R. P. He, and J. Q. Zeng. 2012. “Unified analytical formula method for inversion of creep parameters of rock based on bearing plate test.” [In Chinese.] Rock Soil Mech. 33 (2): 367–373. https://doi.org/10.5956/jriet.41.319.
Zhang, Y. Q., S. C. Li, W. D. Yang, W. G. Li, W. Xiang, J. H. Wang, and R. P. He. 2014. The high slope rock mass rheological test and the rheological theory and engineering application, 1–20. [In Chinese.] Beijing: Science Press.
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: Jul 2, 2018
Accepted: Jan 10, 2019
Published online: Jul 15, 2019
Published in print: Oct 1, 2019
Discussion open until: Dec 15, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.