Vulnerability of Three-Dimensional Semirigid Composite Frame Subjected to Progressive Collapse
Publication: Journal of Performance of Constructed Facilities
Volume 33, Issue 3
Abstract
Limited studies have investigated the progressive collapse of three-dimensional (3D) semirigid steel–concrete frames due to the complexity of modeling techniques, intensive computational time involved in the analysis, and lack of experimental work. A simplified numerical model was developed using nonlinear dynamic analysis procedures. Single column removal cases were considered in different story levels and at various locations. Results of three different types of connections—double web angle (DWA), top and seat angle with double web angle (TSD), and double-tee angle (T-stub) were compared with those having a rigid joint to highlight the effect of connection rigidity. The analysis results showed that the vulnerability of progressive collapse in the corner column removal scenario on the ground floor for DWA connections is higher than that of other removal situations. Three-dimensional skeleton frames and two-dimensional (2D) frames cannot capture the realistic behavior of the structure under progressive collapse. In consecutive column removal cases, the vulnerability of progressive collapse drastically increases. Finally, the paper presented new retrofitting schemes to improve collapse resistance, which will be useful for researchers and structural designers.
Get full access to this article
View all available purchase options and get full access to this article.
References
Alashker, Y., S. El-Tawil, and F. Sadek. 2010. “Progressive collapse resistance of steel-concrete composite floors.” J. Struct. Eng. 136 (10): 1187–1196. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000230.
Alashker, Y., H. Li, and S. El-Tawil. 2011. “Approximations in progressive collapse modeling.” J. Struct. Eng. 137 (9): 914–924. https://doi.org/10.1061/(ASCE)ST.1943-541X.0000452.
ASCE. 2010. Minimum design loads for buildings and other structures. ASCE/SEI 7. Reston, VA: ASCE.
Bandyopadhyay, M., A. K. Banik, and K. D. Tushar. 2016. “Progressive collapse of three-dimensional semi-rigid jointed steel frames.” J. Perform. Constr. Facil. 30 (3): 04015051. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000796.
Bao, Y., S. Kunnath, and S. El-Tawil. 2009. “Development of reduced structural models for assessment of progressive collapse.” In Proc., Structures. Reston, VA: ASCE.
Department of the Army. 1986. Fundamentals of protective design for conventional weapons. TM 5-855-1. Washington, DC: Dept. of the Army.
Ettouney, M., R. Smilowitz, M. Tang, and A. Hapij. 2006. “Global system considerations for progressive collapse with extensions to other natural and man-made hazards.” J. Perform. Constr. Facil. 20 (4): 403–417. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(403).
Frye, M. J., and G. A. Morris. 1975. “Analysis of flexibly connected steel frames.” Can. J. Civ. Eng. 2 (3): 280–291. https://doi.org/10.1139/l75-026.
Fu, F. 2009. “Progressive collapse analysis of high-rise building with 3-D finite element-modeling method.” J. Constr. Steel Res. 65 (6): 1269–1278. https://doi.org/10.1016/j.jcsr.2009.02.001.
Fu, F. 2010. “3-D nonlinear dynamic progressive collapse analysis of multistory steel composite frame buildings—Parametric study.” Eng. Struct. 32 (12): 3974–3980. https://doi.org/10.1016/j.engstruct.2010.09.008.
Gerasimidis, S. 2014. “Analytical assessment of steel frames progressive collapse vulnerability to corner column loss.” J. Constr. Steel Res. 95 (Apr): 1–9. https://doi.org/10.1016/j.jcsr.2013.11.012.
Gerasimidis, S., and J. Sideri. 2016. “A new partial-distributed damage method for progressive collapse analysis of steel frames.” J. Constr. Steel Res. 119 (Mar): 233–245. https://doi.org/10.1016/j.jcsr.2015.12.012.
Grierson, D. E., L. Xu, and Y. Liu. 2005. “Progressive-failure analysis of buildings subjected to abnormal loading.” Comput. -Aided Civ. Infrastruct. Eng. 20 (3): 155–171. https://doi.org/10.1111/j.1467-8667.2005.00384.x.
GSA (General Services Administration). 2003. GSA guidelines for progressive collapse analysis. Washington, DC: Office of the Chief Architect.
Izzuddin, B. A., A. G. Vlassis, A. Y. Elghazouli, and D. A. Nethercot. 2008. “Progressive collapse of multistory buildings due to sudden column loss—Part I: Simplified assessment framework.” Eng. Struct. 30 (5): 1308–1318. https://doi.org/10.1016/j.engstruct.2007.07.011.
Junling, C., H. Xin, M. Renle, and H. Minjuan. 2012. “Experimental study on the progressive collapse resistance of a two-story steel moment frame.” J. Perform. Constr. Facil. 26 (5): 567–575. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000287.
Khandelwal, K., S. El-Tawil, S. K. Kunnath, and H. S. Lew. 2008. “Macro-model-based simulation of progressive collapse: Steel frame structures.” J. Struct. Eng. 134 (7): 1070–1078. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:7(1070).
Kim, J., and T. Kim. 2009. “Assessment of progressive collapse resisting capacity of steel moment frames.” J. Constr. Steel Res. 65 (1): 169–179. https://doi.org/10.1016/j.jcsr.2008.03.020.
Kodur, V. R. 2008. “World Trade Center disaster-Innovations for improved fire safety in buildings.” J. Disaster Adv. 1 (3): 43–50.
Kwasniewski, L. 2010. “Nonlinear dynamic simulations of progressive collapse for a multi-story building.” Eng. Struct. 32 (5): 1223–1235. https://doi.org/10.1016/j.engstruct.2009.12.048.
Liu, J. L. 2010. “Preventing progressive collapse through strengthening beam-to-column connection. Part I: Theoretical analysis.” J. Perform. Constr. Facil. 66 (2): 229–237. https://doi.org/10.1016/j.jcsr.2009.09.006.
Liu, Y., L. Xu, and D. Grierson. 2008. “Compound-element modeling accounting for semi-rigid connections and member plasticity.” Eng. Struct. 30 (5): 1292–1307. https://doi.org/10.1016/j.engstruct.2007.07.026.
Marjanishvili, S., and E. Agnew. 2006. “Comparison of various procedures for progressive collapse analysis.” J. Perform. Constr. Facil. 20 (4): 365–374. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(365).
McKay, A., K. Marchand, and M. Diaz. 2012. “Alternate path method in progressive collapse analysis: Variation of dynamic and nonlinear load increase factors.” Pract. Period. Struct. Des. Constr. 17 (4): 152–160. https://doi.org/10.1061/(ASCE)SC.1943-5576.0000126.
Pantidis, P., and S. Gerasimidis. 2017. “New Euler-type progressive collapse curves for steel moment-resisting frames: Analytical method.” J. Struct. Eng. 143 (9): 04017113. https://doi.org/10.1061/(ASCE)ST.1943-541X.0001834.
Pearson, C., and N. Delatte. 2005. “Ronan point apartment tower collapse and its effect on building codes.” J. Perform. Constr. Facil. 19 (2): 172–177. https://doi.org/10.1061/(ASCE)0887-3828(2005)19:2(172).
Ruth, P., K. A. Marchand, and E. B. Williamson. 2006. “Static equivalency in progressive collapse alternate path analysis: Reducing conservatism while retaining structural integrity.” J. Perform. Constr. Facil. 20 (4): 349–364. https://doi.org/10.1061/(ASCE)0887-3828(2006)20:4(349).
Sadek, F., S. EI-Tawil, and H. S. Lew. 2008. “Robustness of composite floor systems with shear connections.” J. Struct. Eng. 134 (11): 1717–1725. https://doi.org/10.1061/(ASCE)0733-9445(2008)134:11(1717).
Sekulovic, M., and M. Nefovska. 2004. “Static inelastic analysis of steel frames with flexible connections.” Theor. Appl. Mech. 31 (2): 101–134. https://doi.org/10.2298/TAM0402101N.
Setareh, A., S. Hamed, and M. Javad. 2018. “Assessment of dynamic increase factor for progressive collapse analysis of RC structures.” Eng. Failure Anal. 84 (Nov): 300–310. https://doi.org/10.1016/j.engfailanal.2017.11.011.
Sideri, J., L. M. Chris, S. Gerasimidis, and G. Deodatis. 2017. “Distributed column damage effect on progressive collapse vulnerability in steel buildings exposed to an external blast event.” J. Perform. Constr. Facil. 31 (5): 04017077. https://doi.org/10.1061/(ASCE)CF.1943-5509.0001065.
UFC (Unified Facilities Criteria). 2009. Design of buildings to resist progressive collapse. Washington, DC: US Dept. of Defense.
Valipour, H. R., and M. Bradford. 2012. “An efficient compound-element for potential progressive collapse analysis of steel frames with semi-rigid connections.” J. Finite Elem. Anal. Des. 60 (Nov): 35–48. https://doi.org/10.1016/j.finel.2012.05.009.
Wang, J. F., and G. Q. Li. 2007. “Testing of semi-rigid steel-concrete composite frames subjected to vertical loads.” Eng. Struct. 29 (8): 1903–1916. https://doi.org/10.1016/j.engstruct.2006.10.014.
Xu, G., and B. R. Ellingwood. 2011. “An energy-based partial pushdown analysis procedure for assessment of disproportionate collapse potential.” J. Constr. Steel Res. 67 (3): 547–555. https://doi.org/10.1016/j.jcsr.2010.09.001.
Yau, C. Y., and S. L. Chan. 1994. “Inelastic and stability analysis of flexibly connected steel frames by springs-in-series model.” J. Struct. Eng. 120 (10): 2803–2819. https://doi.org/10.1061/(ASCE)0733-9445(1994)120:10(2803).
Information & Authors
Information
Published In
Copyright
©2019 American Society of Civil Engineers.
History
Received: May 7, 2018
Accepted: Nov 8, 2018
Published online: Mar 12, 2019
Published in print: Jun 1, 2019
Discussion open until: Aug 12, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.