Centrifuge Modeling of a Constructed Reservoir Embankment: Antiliquefaction Performance Improvement Using Nanoparticles
Publication: Journal of Performance of Constructed Facilities
Volume 32, Issue 6
Abstract
Antiliquefaction performance improvement for developed sites beneath existing structures has drawn increasing public attention to meet stricter requirements of seismic protection. Liquefaction mitigation using nanoparticles is a novel countermeasure because of its low environmental disturbance and greater environmental friendliness. This paper reports a centrifuge test to evaluate the effectiveness of laponite (the representative nanoparticle) for liquefaction mitigation. A constructed reservoir embankment foundation was selected as the prototype and the laponite-treated model was carried out with a centrifugal acceleration of . Additionally, the viscosity of laponite suspensions was measured to determine the appropriate concentration range and curing time. A similar test with an untreated model was conducted beforehand as a comparison. The subsequent research results showed that the generation of excess porewater pressure was suppressed and both lateral displacements and settlement were reduced in the laponite-treated model versus the untreated model. This paper provides experimental data beyond the elemental scale to support the beneficial effects of laponite on the antiliquefaction performance improvement of the developed sites.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This work was supported by the National Natural Science Foundation of China (Grant Nos. 41625011 and 41372355).
References
Conlee, C. T., P. M. Gallagher, R. W. Boulanger, and R. Kamai. 2012. “Centrifuge modeling for liquefaction mitigation using colloidal silica stabilizer.” J. Geotech. Geoenviron. Eng. 138 (11): 1334–1345. https://doi.org/10.1061/(ASCE)GT.1943-5606.0000703.
El Howayek, A. 2011. “Characterization, rheology and microstructure of laponite suspensions.” Master’s thesis, School of Civil Engineering, Purdue Univ.
El Mohtar, C. S., J. Clarke, A. Bobet, M. Santagata, V. Drnevich, and C. Johnston. 2008. “Cyclic response of a sand with thixotropic pore fluid.” In Proc., Geotechnical Earthquake Engineering and Soil Dynamics Congress IV, 1–10. Reston, VA: ASCE.
Gallagher, P. M. 2000. “Passive site remediation for mitigation of liquefaction risk.” Ph.D. thesis, Dept. of Civil and Environmental Engineering, Virginia Polytechnic Institute and State Univ.
Gallagher, P. M., C. T. Conlee, and K. M. Rollins. 2007a. “Full-scale field testing of colloidal silica grouting for mitigation of liquefaction risk.” J. Geotech. Geoenviron. Eng. 133 (2): 186–196. https://doi.org/10.1061/(ASCE)1090-0241(2007)133:2(186).
Gallagher, P. M., and J. K. Mitchell. 2002. “Influence of colloidal silica grout on liquefaction potential and cyclic undrained behavior of loose sand.” Soil Dyn. Earthquake Eng. 22 (9–12): 1017–1026. https://doi.org/10.1016/S0267-7261(02)00126-4.
Gallagher, P. M., A. Pamuk, and T. Abdoun. 2007b. “Stabilization of liquefiable soils using colloidal silica grout.” J. Mater. Civ. Eng. 19 (1): 33–40. https://doi.org/10.1061/(ASCE)0899-1561(2007)19:1(33).
Hamderi, M., and P. M. Gallagher. 2015. “Pilot-scale modeling of colloidal silica delivery to liquefiable sands.” Soils Found. 55 (1): 143–153. https://doi.org/10.1016/j.sandf.2014.12.011.
Huang, Y., and L. Wang. 2016a. “Experimental studies on nanomaterials for soil improvement: A review.” Environ. Earth Sci. 75 (6): 1–10. https://doi.org/10.1007/s12665-015-5118-8.
Huang, Y., and L. Wang. 2016b. “Laboratory investigation of liquefaction mitigation in silty sand using nanoparticles.” Eng. Geol. 204: 23–32. https://doi.org/10.1016/j.enggeo.2016.01.015.
Huang, Y., and Z. Q. Wen. 2015. “Recent developments of soil improvement methods for seismic liquefaction mitigation.” Nat. Hazards 76 (3): 1927–1938. https://doi.org/10.1007/s11069-014-1558-9.
Huang, Y., and C. Q. Zhu. 2017. “Safety assessment of antiliquefaction performance of a constructed reservoir embankment. I: Experimental assessment.” J. Perform. Constr. Facil. 31 (2): 04016101. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000965.
Ochoa-Cornejo, F., A. Bobet, C. T. Johnston, M. Santagata, and J. Sinfield. 2016. “Cyclic behavior and pore pressure generation in sands with laponite, a super-plastic nanoparticle.” Soil Dyn. Earthquake Eng. 88: 265–279. https://doi.org/10.1016/j.soildyn.2016.06.008.
Rockwood Additives Ltd. 2011. Laponite performance additives. Widnes, UK: Rockwood Additives Ltd.
Santagata, M., A. Bobet, A. El Howayek, F. Ochoa-Cornejo, J. V. Sinfield, and C. T. Johnston. 2015. Building a nanostructure in the pore fluid of granular soils. Geomechanics from micro to macro. London: Taylor & Francis.
Tarhini, Z., S. Jarny, and A. Texier. 2017. “Viscoplastic properties of laponite-CMC mixes.” Data Brief 11: 581–587. https://doi.org/10.1016/j.dib.2017.02.002.
Zhu, C. Q., and Y. Huang. 2017. “Safety assessment of antiliquefaction performance of a constructed reservoir embankment. II: Numerical assessment.” J. Perform. Constr. Facil. 31 (2): 04016102. https://doi.org/10.1061/(ASCE)CF.1943-5509.0000968.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: Feb 6, 2018
Accepted: May 23, 2018
Published online: Aug 20, 2018
Published in print: Dec 1, 2018
Discussion open until: Jan 20, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.