Performance of Precast Concrete Substructures with Dry Connections to Resist Progressive Collapse
Publication: Journal of Performance of Constructed Facilities
Volume 32, Issue 2
Abstract
In the current study, three one-third scaled beam-slab substructures comprising a cast-in-place reinforced concrete specimen and two precast concrete (PC) specimens were tested under a pushdown loading regime to investigate the effects of connection types on the behavior of PC structures to mitigate progressive collapse. A special link was designed to enhance the connection between PC slabs and PC beams. The test results, including load-displacement curves, ultimate load capacity, ultimate deformation capacity, and local strains, are presented. The failure mode and mechanisms of load redistribution are further discussed. It is demonstrated that the PC specimen with welded connections achieved brittle failure with the lowest ultimate load capacity and deformation capacity. Although the lowest initial stiffness and first peak load capacity were achieved in the PC specimen with pinned connections, its large rotational ability ensured that the specimen failed in a ductile manner, which allowed the development of considerable tensile membrane actions. The main source of the membrane action was from the reinforcement mesh in the topping layer. Despite severe separations occurring between the PC slabs and beams, no PC slab collapsed even though the maximum displacement was larger than double the beam span.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by a research grant provided by the Natural Science Foundation of China (Nos. 51778153, 51568004, 51478118, and 51678164). Any opinions, findings, and conclusions expressed in this paper do not necessarily reflect the view of the Natural Science Foundation of China.
References
ACI (American Concrete Institute). (2014). “Building code requirements for structural concrete (ACI 318-14) and commentary (318R-14).” Farmington Hills, MI.
ASCE/SEI. (2010). “Minimum design loads for buildings and other structures.” ASCE/SEI 7-10, Reston, VA, 424.
DoD (Department of Defense). (2009). “Design of building to resist progressive collapse.” UFC 4-023-03, Washington, DC.
Ersoy, U., and Tankut, T. (1993). “Precast concrete members with welded plate connections under reversed cyclic loading.” Eng. Struct., 38(4), 94–100.
GSA (General Services Administration). (2003). Progressive collapse analysis and design guidelines for new federal office buildings and major modernization projects, Washington, DC.
Li, B., Anand, N., and Qian, K. (2012). “Blast damaged residual axial capacity of reinforced concrete columns.” J. Perform. Constr. Facil., 289–299.
Li, Y., Lu, X. Z., Guan, H., and Ye, L. P. (2011). “An improved tie force method for progressive collapse resistance design of reinforced concrete frame structures.” Eng. Struct., 33(10), 2931–2942.
Li, Y., Lu, X. Z., Guan, H., and Ye, L. P. (2014). “Progressive collapse resistance demand of RC frames under catenary mechanism.” ACI Struct. J., 111(5), 1225–1234.
Main, J. A., Bao, Y. H., Lew, H. S., and Sadek, F. (2014). “Robustness of precast concrete frames: Experimental and computational studies.” Structures Congress, ASCE, Reston, VA, 2210–2220.
Marjanishvili, S. (2004). “Progressive analysis procedure for progressive collapse.” J. Perform. Constr. Facil., 79–85.
Marjanishvili, S., and Agnew, E. (2006). “Comparison of various procedures for progressive collapse analysis.” J. Perform. Constr. Facil., 365–374.
PCI (Precast and Prestressed Concrete Institute). (2010). PCI design handbook, 7th Ed., Chicago.
Psycharis, I. N., and Mouzakis, H. P. (2012). “Shear resistance of pinned connections of precast members to monotonic and cyclic loading.” Eng. Struct., 41, 413–427.
Qian, K., and Li, B. (2012a). “Dynamic performance of RC beam-column substructures under the scenario of the loss of a corner column-experimental results.” Eng. Struct., 42, 154–167.
Qian, K., and Li, B. (2012b). “Slab effects on the response of reinforced concrete substructures after loss of corner column.” ACI Struct. J., 109(6), 45–855.
Qian, K., and Li, B. (2013). “Performance of three-dimensional reinforced concrete beam-column substructures under loss of a corner column scenario.” J. Struct. Eng., 584–594.
Qian, K., and Li, B. (2014). “Quantification of slab influences on the dynamic performance of RC frames against progressive collapse.” J. Perform. Constr. Facil., 04014029.
Qian, K., Li, B., and Ma, J. X. (2015). “Load-carrying mechanism to resist progressive collapse of RC buildings.” J. Struct. Eng., 04014107.
Ren, P. Q., Li, Y., Lu, X. Z., Gua, H., and Zhou, Y. L. (2016). “Experimental investigation of progressive collapse resistance of one-way reinforced concrete beam-slab substructures under a middle-column-removal scenario.” Eng. Struct., 118, 28–40.
Sadek, F., Main, J. A., Lew, H. S., and Bao, Y. H. (2011). “Testing and analysis of steel and concrete beam-column assemblies under a column removal scenario.” J. Struct. Eng., 881–892.
Sasani, M. (2008). “Response of a reinforced concrete infilled-frame structure to removal of two adjacent columns.” Eng. Struct., 30(9), 2478–2491.
Sasani, M., and Kropelnicki, J. (2008). “Progressive collapse analysis of an RC structure.” Struct. Des. Tall Special Build., 17(4), 757–771.
Sasani, M., and Sagiroglu, S. (2008). “Progressive collapse resistance of Hotel San Diego.” J. Struct. Eng., 478–488.
Singapore Standard. (1999). “Structural use of concrete. 1: Code of practice for design and construction.” CP 65, Singapore.
Su, Y. P., Tian, Y., and Song, X. S. (2009). “Progressive collapse resistance of axially-restrained frame beams.” ACI Struct. J., 106(5), 600–607.
Sudhakar, A. K., Li, B., and Yip, W. K. (2008). “Finite element analysis of precast hybrid-steel concrete connections under cyclic loading.” J. Constr. Steel Res., 64(2), 190–201.
Tian, Y., and Su, Y. P. (2011). “Dynamic response of reinforced concrete beams following instantaneous removal of a bearing column.” J. Concr. Struct. Mater., 5(1), 19–28.
Wu, K. C., Li, B., and Tsia, K. C. (2011a). “Residual axial compression capacity of localised blast damaged RC columns.” Int. J. Impact Eng., 38(1), 29–40.
Wu, K. C., Li, B., and Tsia, K. C. (2011b). “The effects of explosive mass ratio on residual compressive capacity of contact blast damaged composite columns” J. Constr. Steel Res., 67(4), 602–612.
Yi, W. J., He, Q. F., Xiao, Y., and Kunnath, S. K. (2008). “Experimental study on progressive collapse-resistant behavior of reinforced concrete frame structures.” ACI Struct. J., 105(4), 433–439.
Yu, J., and Tan, K. (2013). “Structural behavior of RC beam-column subassemblages under a middle column removal scenario.” J. Struct. Eng., 233–250.
Information & Authors
Information
Published In
Copyright
©2018 American Society of Civil Engineers.
History
Received: May 5, 2017
Accepted: Oct 6, 2017
Published online: Jan 18, 2018
Published in print: Apr 1, 2018
Discussion open until: Jun 18, 2018
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.