Joint Response of Existing Pipe Culverts under Surface Live Loads
Publication: Journal of Performance of Constructed Facilities
Volume 29, Issue 1
Abstract
This study investigates the field performance of culvert joints in five existing pipe culverts. Test culverts consisted of two corrugated metal culverts, two reinforced concrete culverts, and one high-density polyethylene culvert. Culverts were selected for backfill depths less than 1.5 m and inner diameters ranging from 0.9 to 2.1 m. Static loading was applied to the culverts by parking a heavily loaded truck at different positions above the culvert joint. Dynamic loading was applied by driving the truck over the culvert at speeds ranging from 8 to . Culvert deflections and strains were measured near one of the culvert’s joints. Separation at the joint was also measured. The results indicate that separation at the joint was quite significant at times. In the worst case, the measured separation at the joint was equal to 50% of the measured deflection. Strains measured near the joint in steel culverts were significantly smaller than the yield strain. The dynamic deflections were typically 10–40% less than the static deflections.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research work was conducted as a part of NCHRP Project No. 15–38. Any opinions, findings, conclusions, or recommendations expressed in this paper are those of the writers and do not necessarily reflect the views of the sponsors.
References
AASHTO. (2006). AASHTO LRFD bridge design specifications, 3rd Ed., Washington, DC.
Arockiasamy, M. (2006). “Full-scale field tests on flexible pipes under live load application.” J. Perform. Constr. Facil., 21–27.
Bakht, B. (1981). “Soil-steel structure response to live loads.” J. Geotech. Eng. Div., 107(6), 779–798.
Bayoglu Flener, E. (2009). “Response of long-span box type soil-steel composite structures during ultimate loading tests.” J. Bridge Eng., 496–506.
Beben, D. (2013b). “Dynamic amplification factors of corrugated steel plate culverts.” Eng. Struct., 46, 193–204.
Beben, D. (2013a). “Field performance of corrugated steel plate rad culvert under normal live load conditions.” J. Perform. Constr. Facil., 807–817.
Bian, X. C., Tang, X. V., Shen, W. M., Ling, D. S., and Chen, Y. M. (2012). “An experimental study on a culvert buried in granular soil subjected to vehicle loads.” Adv. Struct. Eng., 15(6), 1031–1040.
Brachman, R. B., Mak, A. C., and Moore, I. D. (2010). “Ultimate limit state of a deep-corrugated large-span box culvert.”, Transportation Research Board, Washington, DC, 55–61.
McVay, M. C., and Selig, E. T. (1982). “Performance and analysis of a long-span culvert.”, Transportation Research Board, Washington, DC, 23–29.
Mohammed, H., and Kennedy, J. (2009). “Fatigue resistance of corrugated steel sheets bolted lap joints under flexure.” Pract. Period. Struct. Des. Constr., 242–245.
Moore, I. D., Becerril Garcia, D., Sezen, H., and Sheldon, T. (2012). “Structural design requirements for culvert joints.”, Transportation Research Board, Washington, DC.
Munro, S. M., Moore, I. D., and Brachman, R. W. I. (2009). “Laboratory testing to examine deformations and moments in fiber-reinforced cement pipe.” J. Geotech. Geoenviron. Eng., 1722–1731.
Romer, A. E., and Kienow, K. K. (2004). “Rubber gasket concrete pipe joints…: Eliminating the smoke and mirror.” Pipelines, 146, 1–13.
Sezen, H., Yeau, K. Y., and Fox, P. J. (2008). “In-situ load testing of corrugated steel pipe-arch culverts.” J. Perform. Constr. Facil., 245–252.
Sheldon, T. (2011). “Beam-on-springs modeling of jointed culvert systems.” M.S. thesis, Ohio State Univ., Columbus, OH.
Webb, M. C., Selig, E. T., Sussmann, J. A., and McGrath, T. J. (1999). “Field tests of a large-span metal culvert.”, Transportation Research Board, Washington, DC, 14–24.
Yeau, K. Y., and Sezen, H. (2012). “Load-rating procedures and performance evaluation of metal culverts.” J. Bridge Eng., 71–80.
Yeau, K. Y., Sezen, H., and Fox, P. J. (2009). “Load performance of in-situ corrugated steel highway culverts.” J. Perform. Constr. Facil., 32–39.
Yeau, K. Y., Sezen, H., and Fox, P. J. (2014). “Simulation of behavior of in-service metal culverts.” J. Pipeline Syst. Eng. Pract., 04013016.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Jan 22, 2013
Accepted: Jun 27, 2013
Published online: Jul 1, 2013
Discussion open until: Dec 3, 2014
Published in print: Feb 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.