Influence of Unreinforced Masonry Infill Panels on the Robustness of Multistory Buildings
Publication: Journal of Performance of Constructed Facilities
Volume 27, Issue 6
Abstract
This paper investigates the contribution of unreinforced masonry infill panels to the robustness of composite steel framed buildings subject to sudden column loss. A previously developed multilevel robustness assessment approach is extended and used to establish the system pseudostatic capacity, which determines the level of gravity loading that could be sustained under sudden column loss without exceeding the system ductility limit. The infill panels are modeled according to the ultimate failure mode and confinement caused by the frame, where a simplified approach is proposed based on extracting the infill panel contribution in isolation of the surrounding frame. The developed modeling approach is applied to a 7-story building, where it is shown that accounting for infill panels can increase the structural resistance to sudden column loss significantly, thus avoiding disproportionate collapse in most cases.
Get full access to this article
View all available purchase options and get full access to this article.
References
British Construction Steelwork Association/Steel Construction Institute (BCSA/SCI). (1998). Joints in steel construction: Composite connections, BCSA/SCI, London.
Comité Euro-International du Béton. (1996). “RC frames under earthquake loading.” State of the Art Rep., Vol. 231, Thomas Telford Services, London.
Cormie, D., Mays, G., and Smith, P. (2009). Blast effects on buildings, Thomas Telford, London.
El-Dakhakhni W. W., Elagy, M., and Hamid, A. A. (2003). “Three-strut model for concrete masonry-infilled steel frames.” J. Struct. Eng., 129(2), 177–185.
European Committee for Standardization. (2004). “Design of composite steel and concrete structures—Part 1-1: General rules and rules for buildings.” EN 1994-1-1:2004, Eurocode 4, Brussels, Belgium.
Gudmundsson, G. V., and Izzuddin, B. A. (2010). “The sudden column loss idealization for disproportionate collapse assessment.” The Structural Engineer, 88(6), 22–26.
Izzuddin, B. A. (1991). “Nonlinear dynamic analysis of framed structures.” Ph.D. thesis, Dept. of Civil Engineering, Imperial College London, Univ. of London, London.
Izzuddin, B. A. (2010). “Robustness by design—Simplified progressive collapse assessment of building structures.” Stahlbau, 79(8), 556–564.
Izzuddin, B. A., Vlassis, A. G., Elghaz1ouli, A. Y., and Nethercot, D. A. (2008). “Progressive collapse of multi-storey buildings due to sudden column loss—Part I: Simplified assessment framework.” Eng. Struct., 30(5), 1308–1318.
Liaum, T. C., and Kwan, K. H. (1982). “Non-linear analysis of multistorey infilled frames.” Proc. Inst. Civil Eng. Lond., 73(2), 441–454.
Mondal, G., and Jain, S. (2008). “Lateral stiffness of masonry infilled RC frames with openings.” Earthq. Spectra, 24(3), 701–723.
Office of the Deputy Prime Minister. (2004). “2237 structure: A3–Disproportionate collapse.” The building regulations 2000, approved document A, 2004 Ed., NBS, London.
Paulay, T., and Priestley, M. J. N. (1992). Seismic design of reinforced concrete and masonry buildings, Wiley, New York.
Saneinejad, A., and Hobbs, B. (1995). “Inelastic design of infilled frames.” J. Struct. Eng., 121(4), 634–650.
Seah, C. K. (1998). “Universal approach for the analysis and design of masonry-infilled frame structures.” Ph.D. thesis, Univ. of New Brunswick, Saint John, NB, Canada.
Smith, B. S. (1966). “Behaviour of square infilled frames.” J. Struct. Div., 92(ST1), 381–403.
Vlassis, A. G., Izzuddin, B. A., Elghazouli, A. Y., and Nethercot, D. A. (2008). “Progressive collapse of multi-storey buildings due to sudden column loss—Part II: Application.” Eng. Struct., 30(5), 1424–1438.
Zolghadr Jahromi, H. (2009). “Progressive collapse of building structures—Influence of membrane action in floor slabs.” M.Sc. thesis, Dept. of Civil and Environmental Engineering, Imperial College London, London.
Information & Authors
Information
Published In
Copyright
© 2013 American Society of Civil Engineers.
History
Received: Feb 22, 2012
Accepted: Sep 10, 2012
Published online: Sep 12, 2012
Published in print: Dec 1, 2013
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.