Effects of Backfill Soil on Excessive Movement of MSE Wall
Publication: Journal of Performance of Constructed Facilities
Volume 26, Issue 6
Abstract
The use of mechanically stabilized earth (MSE) retaining walls has gained popularity as an alternative to conventional cast-in-place concrete walls. The construction of MSE walls is cost effective, requires less site preparation, and is technically more feasible compared with conventional concrete retaining walls. However, use of backfill with high fine content and poor drainage behavior can cause excessive wall movement or even failure. The current paper presents the case study of a MSE wall located at State Highway 342 in Lancaster, Texas. The top of the MSE wall has moved as much as 300–450 mm only 5 years after construction. An extensive site and laboratory investigation testing program was conducted to determine the possible causes of the MSE wall movement. The site investigation included soil test boring and resistivity imaging (RI). Perched water zones were identified at a few locations in the backfill area using RI. The bulging of the MSE wall facings was observed where the perched water zones were located. Laboratory testing of the collected soil samples was conducted to determine the characteristics of the backfill soil. The test results indicated the backfill soil was clayey sand according to the Unified Soil Classification System. Based on the test results and analyses, it was determined that the presence of high fine content may have caused the excessive movement of the MSE wall. The movement of the MSE wall was also modeled using the finite-element program PLAXIS, and is presented in this paper. The actual movement of the MSE wall and the obtained movement from the model were in good agreement.
Get full access to this article
View all available purchase options and get full access to this article.
References
Brinkgreve, R. B. J., Broere, W., and Waterman, D. (2003a). PLAXIS version 8 material models manual, Balkema, Rotterdam, Netherlands.
Brinkgreve, R. B. J., Broere, W., and Waterman, D. (2003b). PLAXIS version 8 reference manual, Balkema, Rotterdam, Netherlands.
Chen, D. H., Nazarian, S., and Bilyeu, J. (2007). “Failure analysis of a bridge embankment with cracked approach slabs and leaking sand.” J. Perform. Constr. Facil., 21(5), 375–381.
Elias, V., Christopher, B. R., and Berg, R. R. (2001). “Mechanically stabilized earth walls and reinforced soil slopes—Design & construction guidelines.” FHWA-NHI-00-043, Federal Highway Administration, Washington, DC.
Giao, P. H., Chung, S. G., Kim, D. Y., and Tanaka, H. (2003). “Electric imaging and laboratory resistivity testing for geotechnical investigation of Pusan clay deposits.” J. Appl. Geophys., 52(4), 157–175.
Leshchinsky, D. (2005). “MSE drainage issues & design.” Proc., Geosynthetics Research and Development in Progress, GRI 18, Geo-Frontiers 2005, ASCE, Reston, VA.
Leshchinsky, D., and Han, J. (2004). “Geosynthetic reinforced multitiered walls.” J. Geotech. Geoenviron. Eng., 130(12), 1225–1235.
Narejo, D., and Ramsey, B. (2001). “MSE wall drainage alternatives: Careful drainage design can prevent costly retaining wall failures.” Geotech. Fabr. Rep., 19(5), 26–29.
Scarborough, J. A. (2005). “A tale of two walls: Case histories of failed MSE walls.” Proc., Slopes and Retaining Structures under Seismic and Static Conditions, GSP 140, Geo-Frontiers 2005, ASCE, Reston, VA.
Stuedlein, A. W., Bailey, M., Lindquist, D., Sankey, J., and Neely, W. J. (2010). “Design and performance of a 46-m-high MSE wall.” J. Geotech. Geoenviron. Eng., 136(6), 786–796.
Stulgis, R. P. (2005). “Selecting reinforced fill materials for MSE walls.” Proc., Geosynthetics Research and Development in Progress, GRI 18, Geo-Frontiers 2005, ASCE, Reston, VA.
Information & Authors
Information
Published In
Copyright
© 2012 American Society of Civil Engineers.
History
Received: Feb 17, 2011
Accepted: Aug 16, 2011
Published online: Aug 18, 2011
Published in print: Dec 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.