Impregnated Carbon Fabric–Reinforced Cementitious Matrix Composite for Rehabilitation of the Finale Emilia Hospital Roofs: Case Study
Publication: Journal of Composites for Construction
Volume 21, Issue 4
Abstract
In this paper, the mechanical performance of concrete beams strengthened by an impregnated carbon fabric–reinforced cementitious matrix (CFRCM) composite is investigated. The study is aimed at the rehabilitation of the Finale Emilia hospital roofs, which were severely damaged by the 2012 northern Italy earthquake. An 8-m-long concrete beam was taken from the building for reinforcement and testing in a beam test setup. The composite is designed to be externally applied to the existing thin clay tile layer bonded to the concrete beam intrados. Two lamination cycles, which differ by the way in which the partially organic adhesion promoter is applied to the fabric, are considered. It was found that impregnation through fabric immersion provides a 1.5-fold increase in the ultimate strength of the strengthened beam compared to expedited impregnation with a brush and that clay tiles make a very good supporting substrate, to the extent that cohesive fracture at the tile–concrete interface takes place on the verge of concrete failure near the hinge zone. Conversely, expedited impregnation of the carbon fabric with the adhesion promoter was unable to provide adequate fabric–matrix adhesion and led to delamination failure. Estimates of the adhesion strength, optimal bonded length, and of the composite, as well as of the concrete strain at failure, are provided.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was conducted in collaboration with Ardea Progetti e Sistemi Srl, Bologna, Italy, and with Studio Melegari, Parma, Italy. Financial support from the Fondazione Cassa di Risparmio di Modena, Pratica Sime nr. 2013.0662, is gratefully acknowledged.
References
Al-Salloum, Y. A., Elsanadedy, H. M., Alsayed, S. H., and Iqbal, R. A. (2012). “Experimental and numerical study for the shear strengthening of reinforced concrete beams using textile-reinforced mortar.” J. Compos. Constr., 74–90.
Arboleda, D. (2014). “Fabric reinforced cementitious matrix (FRCM) composites for infrastructure strengthening and rehabilitation: Characterization methods.” Ph.D. thesis, Univ. of Miami, Coral Gables, FL.
Babaeidarabad, S., Loreto, G., and Nanni, A. (2014). “Flexural strengthening of RC beams with an externally bonded fabric-reinforced cementitious matrix.” J. Compos. Constr., .
Becker, T., Splitthof, K., Siebert, T., and Kletting, P. (2016). “Digital 3D-correlation system Q-400.” ⟨http://www.dantecdynamics.com⟩.
Benjamin, J., and Cornell, C. (1970). Probability, statistics, and decision for civil engineers, McGraw-Hill, New York.
Bentur, A., and Mindess, S. (2006). Fibre reinforced cementitious composites, CRC Press, Boca Raton, FL.
Blanksvärd, T., and Täljsten, B. (2008). “Strengthening of concrete structures with cement based bonded composites.” J. Nordic Concr. Res., 38, 133–153.
Brückner, A., Ortlepp, R., and Curbach, M. (2006). “Textile reinforced concrete for strengthening in bending and shear.” Mater. Struct., 39(8), 741–748.
CNR (Consiglio Nazionale delle Ricerche). (2004). “Guide for the design and construction of an externally bonded FRP system for strengthening existing structures.”, Rome.
D’Ambrisi, A., Feo, L., and Focacci, F. (2013). “Experimental and analytical investigation on bond between carbon-frcm materials and masonry.” Compos. Part B. Eng., 46, 15–20.
ICC-ES (ICC Evaluation Service). (2013). “Acceptance criteria for masonry and concrete strengthening using fiber-reinforced cementitious matrix (FRCM) composite systems.”, Birmingham, AL.
Italian Building Code. (2008). “Norme tecniche per le costruzioni.”, Italian Ministry of Infrastructures and Transportation, Rome.
Kim, J. K., and Eo, S. (1990). “Size effect in concrete specimens with dissimilar initial cracks.” Mag. Concr. Res., 42(153), 233–238.
Lanzoni, L., Nobili, A., and Tarantino, A. (2012). “Performance evaluation of a polypropylene-based draw-wired fibre for concrete structures.” Constr. Build. Mater., 28(1), 798–806.
Loreto, G., Leardini, L., Arboleda, D., and Nanni, A. (2013). “Performance of RC slab-type elements strengthened with fabric-reinforced cementitious-matrix composites.” J. Compos. Constr., .
Mouring, S. E., Barton, O., and Simmons, D. (2001). “Reinforced concrete beams externally retrofitted with advanced composites.” Adv. Compos. Mater., 10(2–3), 139–146.
Neville, A. M., and Brooks, J. J. (1987). Concrete technology, Prentice Hall, Harlow, U.K.
Nobili, A. (2016). “Durability assessment of impregnated glass fabric reinforced cementitious matrix (GFRCM) composites in the alkaline and saline environments.” Constr. Build. Mater., 105, 465–471.
Nobili, A., Lanzoni, L., and Tarantino, A. (2013). “Experimental investigation and monitoring of a polypropylene-based fiber reinforced concrete road pavement.” Constr. Build. Mater., 47, 888–895.
Norris, T., Saadatmanesh, H., and Ehsani, M. R. (1997). “Shear and flexural strengthening of RC beams with carbon fiber sheets.” J. Struct. Eng., 903–911.
Ombres, L. (2011a). “Flexural analysis of reinforced concrete beams strengthened with a cement based high strength composite material.” Compos. Struct., 94(1), 143–155.
Ombres, L. (2011b). “Structural performances of PBO FRCM-strengthened RC beams.” Proc., ICE Struct. Build., 164(4), 265–272.
Rahimi, H., and Hutchinson, A. (2001). “Concrete beams strengthened with externally bonded FRP plates.” J. Compos. Constr., 44–56.
RILEM. (1994). “RC 5 bond test for reinforcement steel: 1. Beam test, 1982.” RILEM technical recommendations for the testing and use of construction materials, Spon, London.
Saadatmanesh, H., and Ehsani, M. R. (1991). “RC beams strengthened with GFRP plates. I: Experimental study.” J. Struct. Eng., 3417–3433.
Tertulliani, A., et al. (2012). “The Emilia 2012 sequence: A macroseismic survey.” Ann. Geophys., 55(4), 679–687.
Toutanji, H., and Deng, Y. (2007). “Comparison between organic and inorganic matrices for RC beams strengthened with carbon fiber sheets.” J. Compos. Constr., 507–513.
Triantafillou, T. C., and Papanicolaou, C. G. (2005). “Textile reinforced mortars (TRM) versus fiber reinforced polymers (FRP) as strengthening materials of concrete structures.” Proc., 7th ACI Int. Symp. on Fiber-Reinforced (FRP) Polymer Reinforcement for Concrete Structures, American Concrete Institute, Farmington Hills, MI.
Information & Authors
Information
Published In
Copyright
©2017 American Society of Civil Engineers.
History
Received: May 6, 2016
Accepted: Oct 5, 2016
Published online: Feb 6, 2017
Discussion open until: Jul 6, 2017
Published in print: Aug 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.