Experimental Investigations on Impact Behavior of CFRP Cables under Pretension
Publication: Journal of Composites for Construction
Volume 21, Issue 2
Abstract
Carbon fiber–reinforced polymer/plastic (CFRP) used in bridge cables may be subjected to lateral impacts caused by vehicle collisions when in service. However, to date, few studies have been conducted on the impact behavior of CFRP cables and their anchor systems. In this paper, the impact behavior of CFRP cables was investigated through drop-weight tests of eight CFRP cable specimens. A seven-wire CFRP strand was used as the tendon, and reactive powder concrete (RPC) was used as the filling grout for anchors at both ends of each specimen. The results show that a bond length of no less than 36 times the diameter of the wire of the CFRP strand in 128 MPa RPC grout can provide a CFRP strand with reliable anchorage under impact. The average transverse impact resistance of the specimens was approximately 16 kN and was not significantly influenced by pretension. The specimens fractured at a cable tension of 30% of the static tensile breaking load under transverse impact. In addition, the energy dissipation capacities for specimens with pretension to static tensile breaking load ratios of approximately 10, 21, and 26% were 632, 727, and 902 J, respectively. Finally, a normalized energy profile diagram (EPD) was established for the design and damage evaluation of a CFRP cable in the case of an impact event.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research is a part of the work carried out by grants from the National Natural Science Foundation of China (No. 51478177) and the Graduate Student Research Innovation Project in Hunan Province (No. CX2011B152).
References
Atas, C., and Sayman, O. (2008). “An overall view on impact response of woven fabric composite plates.” Compos. Struct., 82(3), 336–345.
Butcher, B. R. (1979). “The impact resistance of unidirectional CFRP under tensile stress.” Fibre Sci. Technol., 12(4), 295–326.
Cantwell, W. J., and Morton, J. (1989a). “Comparison of the low and high velocity impact response of CFRP.” Composites, 20(6), 545–551.
Cantwell, W. J., and Morton, J. (1989b). “Geometrical effects in the low velocity impact response of CFRP.” Compos. Struct., 12(1), 39–59.
Cantwell, W. J., and Morton, J. (1989c). “The influence of varying projectile mass on the impact response of CFRP.” Compos. Struct., 13(2), 101–114.
Caprino, G., Lopresto, V., Scarponi, C., and Briotti, G. (1999). “Influence of material thickness on the response of carbon-fabric/epoxy panels to low velocity impact.” Compos. Sci. Technol., 59(15), 2279–2286.
CECS (China Association for Engineering Construction Standardization). (2015). “Reactive powder concrete.”, Beijing.
Chiu, S. T., Liou, Y. Y., Chang, Y. C., and Ong, C. L. (1997). “Low velocity impact behavior of pre-stressed composite laminates.” Mater. Chem. Phys., 47(2–3), 268–272.
Delfosse, D., and Poursartip, A. (1997). “Energy-based approach to impact damage in CFRP laminates.” Composites Part A, 28(7), 647–655.
Feraboli, P., and Kedward, K. T. (2006). “A new composite structure impact performance assessment program.” Compos. Sci. Technol., 66(10), 1336–1347.
Feylessoufi, A., Villiéras, F., Michot, L. J., Donato, P. D., Cases, J. M., and Richard, P. (1996). “Water environment and nanostructural network in a reactive powder concrete.” Cem. Concr. Compos., 18(1), 23–29.
Ghelli, D., and Minak, G. (2011). “Low velocity impact and compression after impact tests on thin carbon/epoxy laminates.” Composites Part B, 42(7), 2067–2079.
Heimbs, S., Heller, S., Middendorf, P., Hähnel, F., and Weiße, J. (2009). “Low velocity impact on CFRP plates with compressive preload: Test and modelling.” Int. J. Impact Eng., 36(10–11), 1182–1193.
Khalili, S., Mittal, R. K., and Panah, N. M. (2007). “Analysis of fiber reinforced composite plates subjected to transverse impact in the presence of initial stresses.” Compos. Struct., 77(2), 263–268.
Meier, U. (2012). “Carbon fiber reinforced polymer cables: Why? Why Not? What If?” Arab. J. Sci. Eng., 37(2), 399–411.
Mines, R. A. W., and Li, Q. M. (2000). “Static behaviour of transversely loaded CFRP laminate panels subject to in-plane tension.” Strain, 36(2), 71–80.
Mitrevski, T., Marshall, I. H., and Thomson, R. (2006). “The influence of impactor shape on the damage to composite laminates.” Compos. Struct., 76(1), 116–122.
Nettles, A. T. (1998). “The effects of tensile preloads on the impact response of carbon/epoxy laminates.” Composite materials: Fatigue and fracture, R. B. Bucinell, ed., Vol. 7, ASTM, West Conshohoken, PA, 249–262.
Quaresimin, M., Ricotta, M., Martello, L., and Mian, S. (2013). “Energy absorption in composite laminates under impact loading.” Composites Part B, 44(1), 133–140.
Saghafi, H., Minak, G., and Zucchelli, A. (2014). “Effect of preload on the impact response of curved composite panels.” Composites Part B, 60(1), 74–81.
Schoeppner, G. A., and Abrate, S. (2000). “Delamination threshold loads for low velocity impact on composite laminates.” Composites Part A, 31(9), 903–915.
Sun, C. T., and Chen, J. K. (1985). “On the impact of initially stressed composite laminates.” J. Compos. Mater., 19(6), 490–504.
Wang, X., and Wu, Z. S. (2010). “Evaluation of FRP and hybrid FRP cables for super long-span cable-stayed bridges.” Compos. Struct., 92(10), 2582–2590.
Whittingham, B., Marshall, I. H., Mitrevski, T., and Jones, R. (2004). “The response of composite structures with pre-stress subject to low velocity impact damage.” Compos. Struct., 66(1–4), 685–698.
Zhang, K., Fang, Z., Nanni, A., Hu, J., and Chen, G. (2015). “Experimental study of a large-scale ground anchor system with FRP tendon and RPC grout medium.” J. Compos. Constr., .
Information & Authors
Information
Published In
Copyright
©2016 American Society of Civil Engineers.
History
Received: Feb 29, 2016
Accepted: Jul 5, 2016
Published online: Aug 16, 2016
Discussion open until: Jan 16, 2017
Published in print: Apr 1, 2017
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.