Sagging and Hogging Strengthening of Continuous Unbonded Posttensioned HSC Beams by NSM and EBR
Publication: Journal of Composites for Construction
Volume 20, Issue 2
Abstract
Continuous unbonded posttensioned concrete beams might require strengthening to cope with higher demands. Strengthening with carbon-fiber-reinforced plastics (CFRP) is a viable option; however, because of the limited number of studies in this area and lack of experimental data, the guidelines covered only bonded prestressed concrete members, in particular when these are made from high-strength concrete (HSC). This paper reports on the results of an experimental investigation on the flexural behavior of continuous unbonded posttensioned HSC beams strengthened using CFRP. In this application, the CFRP is either externally bonded reinforcement (EBR) or internally near-surface mounted (NSM) in both hogging and sagging regions. The results show that both service and ultimate states of continuous unbonded posttensioned concrete beams were considerably improved by CFRP strengthening, and also that the efficiency of the NSM method is greater than that of the EBR method, especially in crack propagation and ultimate load.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to acknowledge Khansar metal industries for providing the prestressing strand, Radyab Company for providing CFRP laminate, and also Amin R. Dortajnejad and Mohamad Maghsoudi for assisting in the construction of the specimens. Thanks are also due to the faculty of Civil Engineering at the Shahid Bahonar University of Kerman for providing the laboratory test facilities.
References
ACI (American Concrete Institute). (2008). “Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures.” ACI 440.2R-08, Detroit.
ACI (American Concrete Institute). (2011). “Building code requirements for structural concrete and commentary.” ACI 318R-11, Farmington Hills, MI.
Akbarzadeh, H., and Maghsoudi, A. A. (2010a). “Experimental and analytical investigation of reinforced high strength concrete continuous beams strengthened with fibre reinforced polymer.” Mater. Des., 31(3), 1130–1147.
Akbarzadeh, H., and Maghsoudi, A. A. (2010b). “Experimental investigations and verification of debonding strain of RHSC continuous beams strengthened in flexure with externally bonded FRPs.” Mater. Struct., 43(6), 815–837.
Bank, L. C., and Arora, D. (2006). “Analysis of RC beams strengthened with mechanically fastened FRP (MF-FRP) strips.” Compos. Struct., 79(2), 180–191.
Barros, J. A. O., Ferreira, D. R. S. M., Fortes, A. S., and Dias, S. J. E. (2006). “Assessing the effectiveness of embedding CFRP laminates in the near surface for structural strengthening.” Constr. Build. Mater., 20(7), 478–491.
BS (British Standard). (1997). “Structural use of concrete, Part 1: Code of practice for design and construction.” BS 8110-1:1997, London.
Chahrour, A., and Soudki, K. (2005). “Flexural response of reinforced concrete beams strengthened with end-anchored partially bonded carbon fiber-reinforced polymer strips.” J. Compos. Constr., 170–177.
Chakrabarti, P. R. (2005). “Behavior of un-bonded post-tensioned beams repaired and retrofitted with composite materials.” Proc., Structures Congress and Forensic Engineering Symp., Metropolis and Beyond, New York, 1–11.
Choi, H. T., West, J. S., and Soudki, K. A. (2011). “Partially bonded near-surface-mounted CFRP bars for strengthened concrete T-beams.” Constr. Build. Mater., 25(5), 2441–2449.
El Hacha, R., and Rizkalla, S. H. (2004). “Near surface mounted FRP reinforcements for flexural strengthening of concrete structures.” ACI Struct. J., 101(5), 717–726.
El Meski, F., and Harajli, M. (2013). “Flexural behavior of unbonded post-tensioned concrete members strengthened using external FRP composites.” J. Compos. Constr., 197–207.
El Refaie, S. A., Ashour, A. F., and Garrity, S. W. (2003). “Sagging and hogging strengthening of continuous reinforced concrete beams using carbon fiber reinforced polymer sheets.” ACI Struct. J., 100(4), 446–453.
Farahbod, F., and Mostofinejad, D. (2010). “Experimental study of moment redistribution in RC frames strengthened with CFRP sheets.” Compos. Struct., 93(3), 1168–1177.
Foret, G., and Limam, O. (2008). “Experimental and numerical analysis of RC two-way slabs strengthened with NSM CFRP rods.” Constr. Build. Mater., 22(10), 2025–2030.
Garden, H. N., and Hollaway, L. C. (1998). “An experimental study of the influence of plate end anchorage of carbon fibre composite plates used to strengthen reinforced concrete beams.” Compos. Struct., 42(2), 175–188.
Ghasemi, S. (2012). “Behavior of continuous un-bonded post-tensioned concrete members strengthened with CFRP laminates (experimental investigation).” M.Sc. dissertation, Shahid Bahonar Univ., Kerman, Iran.
Hassan, T. K., and Rizkalla, S. H. (2004). “Bond mechanism of near-surface-mounted fiber-reinforced polymer bars for flexural strengthening of concrete structures.” ACI Struct. J., 101(6), 830–839.
Lamanna, A. J., Bank, L. C., and Scott, D. W. (2001). “Flexural strengthening of reinforced concrete beams using fasteners and fiber-reinforced polymer strips.” ACI Struct. J., 98(3), 368–376.
Lignola, G. P., Prota, A., Manfredi, G., and Cosenza, E. (2007). “Experimental performance of RC hollow columns confined with CFRP.” J. Compos. Constr., 42–49.
Lorenzis, L. D., and Teng, J. G. (2007). “Near-surface mounted FRP reinforcement: An emerging technique for strengthening structures.” Composites, Part B, 38(2), 119–143.
Mirmiran, A., Shahawy, M., Nanni, A., and Karbhari, V. (2004). “Bonded repair and retrofit of concrete structures using FRP composites.”, National Cooperative Highway Research Program (NCHRP), Transportation Research Board, Washington, DC.
Oehlers, D. J., Rashid, R., and Seracino, R. (2008). “IC debonding resistance of groups of FRP NSM strips in reinforced concrete beams.” Constr. Build. Mater., 22(7), 1574–1582.
Pellegrino, C., and Modena, C. (2009). “Flexural strengthening of real-scale RC beams with end-anchored pretensioned FRP laminates.” ACI Struct. J., 106(3), 319–328.
Pham, H., and Al Mahaidi, R. (2006). “Prediction models for debonding failure loads of carbon fiber reinforced polymer retrofitted reinforced concrete beams.” J. Compos. Constr., 48–59.
Rosenboom, O., Hassan, T. K., and Rizkalla, S. (2007). “Flexural behavior of aged prestressed concrete girders strengthened with various FRP systems.” Constr. Build. Mater., 21(4), 764–776.
Rosenboom, O., Walter, C., and Rizkalla, S. (2009). “Strengthening of prestressed concrete girders with composites: Installation, design and inspection.” Constr. Build. Mater., 23(4), 1495–1507.
Spadea, G., Bencardino, F., and Swamy, R. N. (1998). “Structural behavior of composite RC beams with externally bonded CFRP.” J. Compos. Constr., 132–137.
Teng, J. G., Chen, J. F., Smith, S. T., and Lam, L. (2001). FRP: Strengthened RC structures, Wiley, New York.
Warwaruk, J., Sozen, M. A., and Siess, C. P. (1962). “Investigation of prestressed concrete for highway bridges. Part III: Strength and behavior in flexure of prestressed beams.”, Engineering Experiment Station, Univ. of Illinois, Urbana-Champaign, IL.
Xiong, G. J., Jiang, X., Liu, J. W., and Chen, L. (2007). “A way for preventing tension delamination of concrete cover in mid span of FRP strengthened beams.” Constr. Build. Mater., 21(2), 402–408.
Yang, D. S., Park, S. K., and Neale, K. W. (2009). “Flexural behaviour of reinforced concrete beams strengthened with prestressed carbon composites.” Compos. Struct., 88(4), 497–508.
Yost, J. R., Gross, S. P., Dinehart, D. W., and Mildenberg, J. J. (2007). “Flexural behavior of concrete beams strengthened with near-surface-mounted CFRP strips.” ACI Struct. J., 104(4), 430–437.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Mar 18, 2015
Accepted: Jul 16, 2015
Published online: Sep 11, 2015
Discussion open until: Feb 11, 2016
Published in print: Apr 1, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.