Experimental Study of the Seismic Behavior of Predamaged Reinforced-Concrete Columns Retrofitted with Basalt Fiber–Reinforced Polymer
Publication: Journal of Composites for Construction
Volume 19, Issue 6
Abstract
Reinforced concrete (RC) frame structures are widely used in earthquake regions, and damage to these structures has been reported after many earthquakes. Small parts of seriously damaged RC frames should be demolished and reconstructed, and a large number of earthquake-damaged RC frames can be retrofitted and used again. In this paper, the seismic behavior of predamaged reinforced concrete columns repaired using early-strength cement mortar and basalt fiber–reinforced polymer (BFRP) has been investigated through lateral reversed cyclic tests on seven large-sized RC columns. Two predamage levels [(1) moderate damage, and (2) severe damage] were assigned to the RC columns through cyclic loading. The axial load and residual displacement were kept constant during the retrofitting process, and the retrofitted columns were retested after 6 days of mortar and epoxy curing at room temperature. The ductility and energy dissipation capacities of the fiber-reinforced polymer (FRP)-retrofitted predamaged RC columns were greatly improved after early-strength cement mortar perfusion and BFRP wrapping compared with the original intact columns. The flexural capacity could be fully restored for the moderately predamaged RC column and partially restored for the severely predamaged column, whereas the initial elastic stiffness of the BFRP-retrofitted predamaged RC columns was lower than that of the original intact columns and deceased with increased predamage level. The influences of axial load, residual displacement, and predamage level on the repair effect of FRP-retrofitted predamaged RC columns were analyzed, and the predamage level was the main influencing factor.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The research reported in this paper was financially supported by the National Natural Science Foundation of China (Grant No. 51408211), the Fundamental Research Funds for the Central Universities through the Project of Young Teacher Growth of Hunan University (Grant No. 531107040799), and the Ministry of Science and Technology, China (Grant Nos. 2011BAK02B02 and 2012CB026203). Gratitude is expressed to Prof. Guijun Xian for providing fast-curing epoxy in the FRP retrofitting.
References
Bakis, C. E., et al. (2002). “Fiber-reinforced polymer composites for construction—State-of-the-art review.” J. Compos. Constr., 73–87.
Bournas, D. A., Lontou, P. V., Papanicolaou, C. G., and Triantafillou, T. C. (2007). “Textile-reinforced mortar versus fiber-reinforced polymer confinement in reinforced concrete columns.” ACI Struct. J., 104(6), 740–748.
Bournas, D. A., Pavese, A., and Tizani, W. (2015). “Tensile capacity of FRP anchors in connecting FRP and TRM sheets to concrete.” Eng. Struct., 82(1), 72–81.
Bournas, D. A., and Triantafillou, T. C. (2009). “Flexural strengthening of RC columns with near-surface-mounted FRP or stainless steel.” ACI Struct. J., 106(4), 495–505.
Bournas, D. A., Triantafillou, T. C., Zygouris, K., and Stavropoulos, F. (2009). “Textile-reinforced mortar versus FRP jacketing in seismic retrofitting of RC columns with continuous or lap-spliced deformed bars.” J. Compos. Constr., 360–371.
Code of China. (1996). “Specification of testing methods for earthquake resistant building.”, Publishing House of Building Industry in China, Beijing (in Chinese).
Code of China. (2010). “Code for seismic design of buildings.” GB 50011, Publishing House of Building Industry in China, Beijing (in Chinese).
Di Ludovico, M., Prota, A., and Manfredi, G. (2010). “Structural upgrade using basalt fibers for concrete confinement.” J. Compos. Constr., 541–552.
Ghobarah, A., and Said, A. (2002). “Shear strengthening of beam-column joints.” Eng. Struct., 24(7), 881–888.
Ghosh, K. K., and Sheikh, S. A. (2007). “Seismic upgrade with carbon fiber-reinforced polymer of columns containing lap-spliced reinforcing bars.” ACI Struct. J., 104(2), 227–236.
Iacobucci, R. D., Sheikh, S. A., and Bayrak, O. (2003). “Retrofit of square concrete columns with carbon fiber-reinforced polymer for seismic resistance.” ACI Struct. J., 100(6), 785–794.
Ilki, A., Bedirhanoglu, I., and Kumbasar, N. (2011). “Behavior of FRP retrofitted joints built with plain bars and low-strength concrete.” J. Compos. Constr., 312–326.
Lam, L., and Teng, J. G. (2003a). “Design-oriented stress-strain models for FRP-confined concrete.” Constr. Build. Mater., 17(6–7), 471–489.
Lam, L., and Teng, J. G. (2003b). “Design-oriented stress-strain model for FRP-confined concrete in rectangular columns.” J. Reinf. Plast. Comp., 22(13), 1149–1186.
Ma, G., Li, H., and Duan, Z. D. (2012). “Repair effects and acoustic emission technique-based fracture evaluation for pre-damaged concrete columns confined with fiber-reinforced polymers.” J. Compos. Constr., 626–639.
Ma, G., Li, H., and Wang, J. (2013). “Experimental study of the seismic behavior of an earthquake-damaged reinforced concrete frame structure retrofitted with basalt fiber-reinforced polymer.” J. Compos. Constr., 04013002.
Ma, R., and Xiao, Y. (1999). “Seismic retrofit and repair of circular bridge columns with advanced composite materials.” Earthquake Spectra, 15(4), 747–764.
Memon, M. S., and Sheikh, S. A. (2005). “Seismic resistance of square concrete columns retrofitted with glass fiber-reinforced polymer.” ACI Struct. J., 102(5), 774–783.
Pendhari, S. S., Kant, T., and Desai, Y. M. (2008). “Application of polymer composites in civil construction: A general review.” Compos. Struct., 84(2), 114–124.
Saadatmanesh, H., Ehsani, M. R., and Jin, L. (1997). “Repair of earthquake-damaged RC columns with FRP wraps.” ACI Struct. J., 94(2), 206–215.
Seible, F., Priestley, M. J., Hegemier, G. A., and Innamorato, D. (1997). “Seismic retrofit of RC columns with continuous carbon fiber jackets.” J. Compos. Constr., 52–62.
Sezen, H. (2012). “Repair and strengthening of reinforced concrete beam-column joints with fiber-reinforced polymer composites.” J. Compos. Constr., 499–506.
Sim, J., Park, C., and Moon, D. Y. (2005). “Characteristics of basalt fiber as a strengthening material for concrete structures.” Compos. Part B Eng., 36(6–7), 504–512.
Teng, J. G., Chen, J. F., Smith, S. T., and Lam, L. (2002). FRP strengthened RC structures, Wiley, London.
Triantafillou, T. C., Papanicolaou, C. G., Zissimopoulos, P., and Laourdekis, T. (2006). “Concrete confinement with textile-reinforced mortar jackets.” ACI Struct. J., 103(1), 28–37.
Vrettos, I., Kefala, E., and Triantafillou, T. C. (2013). “Innovative flexural strengthening of RC columns using carbon spike anchors.” ACI Struct. J., 110(1), 63–70.
Xiao, Y., Wu, H., and Martin, G. R. (1999). “Prefabricated composite jacketing of RC columns for enhanced shear strength.” J. Struct. Eng., 255–264.
Ye, L. P., Zhang, K., Zhao, S. H., and Feng, P. (2003). “Experimental study on seismic strengthening of RC columns with wrapped CFRP sheets.” Constr. Build. Mater., 17(6–7), 499–506.
Information & Authors
Information
Published In
Copyright
© 2015 American Society of Civil Engineers.
History
Received: Oct 29, 2014
Accepted: Feb 17, 2015
Published online: Apr 1, 2015
Discussion open until: Sep 1, 2015
Published in print: Dec 1, 2015
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.