Flexural Behavior of Stone Slabs Reinforced with Prestressed NSM CFRP Bars
Publication: Journal of Composites for Construction
Volume 18, Issue 4
Abstract
A technique for reinforcing stone slabs with prestressed near-surface mounted (NSM) carbon fiber–reinforced polymer (CFRP) bars is proposed and investigated in this research. Six stone slabs were tested under monotonic loading. Among these slabs, one served as a control slab and was not reinforced, and two were reinforced with one or two NSM CFRP bars, and each bar was prestressed to 30% of the bar’s ultimate strength. The remaining three were reinforced with three NSM CFRP bars that had been prestressed to 0, 15, or 30% of the bar’s ultimate strength. The test results indicate that reinforcement with either prestressed or nonprestressed NSM CFRP bars shifted the failure mode of the stone slabs from abrupt fracture to a more ductile flexural failure. A remarkable improvement in the flexural response was obtained when the stone slabs were reinforced with prestressed NSM CFRP bars. In addition to exhibiting a higher cracking load, the stone slabs that had been reinforced with prestressed NSM CFRP bars exhibited cracks with a smaller width, and the strength utilization of the CFRP reinforcement was much higher compared to that of the nonprestressed reinforced slabs. An analytical model was developed based on a sectional analysis method to predict the flexural response of stone slabs reinforced with prestressed NSM CFRP bars. The predicted values show good agreement with the experimental results.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was funded as a major project for university–industry cooperation by Fujian Province, China (grant No. 2011Y4008). The authors would like to thank all of the technicians at the structural laboratory at Huaqiao University.
References
American Concrete Institute (ACI). (1989). “Deflections of reinforced concrete flexural members.”, Detroit.
American Concrete Institute (ACI). (2002). “Guide for the design and construction of externally bonded FRP systems for strengthening concrete structures.”, Farmington Hills, MI.
American Concrete Institute (ACI). (2004). “Guide test methods for fiber-reinforced polymers (FRPs) for reinforcing or strengthening concrete structures.”, Farmington Hills, MI.
ASTM. (2008a). “Standard test method for compressive strength of hydraulic cement mortars (Using 2-in. or [50-mm] cube specimens).” C109/C109M-08, West Conshohocken, PA.
ASTM. (2008b). “Standard test method for splitting tensile strength of intact rock core specimens.” D3967-08, West Conshohocken, PA.
ASTM. (2009). “Standard test method for compressive strength of dimension stone.” C170/C170M-09, West Conshohocken, PA.
ASTM. (2010). “Standard test method for compressive strength and elastic moduli of intact rock core specimens under varying states of stress and temperatures.” D7012-10, West Conshohocken, PA.
Badawi, M., and Soudki, K. (2009). “Flexural strengthening of RC beams with prestressed NSM CFRP rods-experimental and analytical analysis.” Constr. Build. Mater., 23(10), 3292–3300.
Barros, J. A. O., Ferreira, D. R. S. M., Fortes, A. S., and Dias, S. J. E. (2006). “Assessing the effectiveness of embedding CFRP laminates in the near surface for structural strengthening.” Construct. Build. Mater., 20(7), 478–491.
Barros, J. A. O., and Fortes, A. S. (2005). “Flexural strengthening of concrete beams with CFRP laminate bonded into slits.” Cem. Concr. Compos., 27(4), 471–480.
De Lorenzis, L., and Nanni, A. (2001). “Shear strengthening of reinforced concrete beams with near-surface mounted fiber-reinforced polymer rods.” ACI Struct. J., 98(1), 60–68.
De Lorenzis, L., and Teng, J. G. (2007). “Near surface FRP reinforcement: an emerging technique for strengthening structures.” Compos. B Eng., 38(2), 119–143.
El-Hacha, R., and Gaafar, M. (2011). “Flexural strengthening of reinforced concrete beams using prestressed, near-surface-mounted CFRP bars.” PCI J. Fall, 56(4), 134–151.
El-Hacha, R., and Rizkalla, S. H. (2004). “Near-surface- mounted fiber-reinforced polymer reinforcements for flexural strengthening of concrete structures.” ACI Struct. J., 101(5), 717–726.
Foret, G., and Limam, O. (2008). “Experimental and numerical analysis of RC two-way slabs strengthened with NSM CFRP rods.” Constr. Build. Mater., 22(10), 2025–2030.
Guo, Z. X., Liu, B. C., and Liu, Y. (2011a). “Experimental study on bond behavior between NSM CFRP rods and stone for composite stone beams.” Eng. Mech., 28(7), 59–64 (in Chinese).
Guo, Z. X., Ye, Y., Liu, B. C., and Liu, Y. (2011b). “Flexural behavior of NSM CFRP-stone composite beams: experimental investigation.” Proc., 13th Int. Conf. on Nonconventional Mater. Technol., Changsha, China.
Hajihashemi, A., Mostofinejad, D., and Azhari, M. (2011). “Investigation of RC beams strengthened with prestressed NSM CFRP laminates.” J. Compos. Construct., 887–895.
Nordin, H., and Taljsten, B. (2006). “Concrete beams strengthened with prestressed near surface mounted CFRP.” J. Comp. Construct., 60–68.
Orozco, A. L., and Maji, A. K. (2004). “Energy release in fiber-reinforced plastic reinforced concrete beams.” J. Comp. Construct., 52–58.
Tang, W. C., Balendran, R. V., Nadeem, A., and Leung, H. Y. (2006). “Flexural strengthening of reinforced light weight polystyrene aggregate concrete beams with near surface mounted GFRP bars.” Build. Environ., 41(10), 1381–1393.
Ye, Y., and Guo, Z. X. (2011). “Experimental investigation on the anchorage performance of clamping anchors for carbon fiber reinforced polymer rods.” Adv. Sci. Lett., 4(3), 922–926.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Aug 12, 2013
Accepted: Nov 19, 2013
Published online: Jan 24, 2014
Discussion open until: Jun 24, 2014
Published in print: Aug 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.