Focal Mechanism Influence with Azimuth Using Near-Field Simulated Ground Motion: Application to a Multispan Continuous Concrete Single-Frame Box-Girder Bridge
Publication: Journal of Bridge Engineering
Volume 27, Issue 6
Abstract
Bridges in earthquake-prone states like California have been studied for near-field and far-field loadings. However, there is a research gap in terms of how an earthquake of a certain strike, dip, and rake is going to influence the bridge response. Here, we focus on multispan continuous concrete single-frame box girder bridges. In this study, we simulate earthquakes of varying focal mechanisms and perform nonlinear dynamic analysis of bridges with the synthesized ground motion. Furthermore, the influence of azimuth orientation with respect to the source is studied by placing the bridge model a few kilometers from the source at certain azimuths motivated by the radiation pattern of seismic waves. Fixing a magnitude, depth, and reference focal mechanism angles determining a focal mechanism is varied to study the effect of strike, dip, and rake on the bridges. In each of these cases, the potential risk is identified, and the study underscores the need to include these focal mechanism parameters into bridge fragility computations in risk assessment platforms such as HAZUS.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors sincerely thank the editor and the three anonymous reviewers for their comments and suggestions, which have improved the quality of this manuscript. This work was partly funded by the Ministry of Earth Sciences, India, through Grant No. MoES/P.O.(Seismo)/1(304)/2016.
References
Aki, K., and P. G. Richards. 2002. Quantitative seismology. Sausalito, CA: Univ Science Books.
Billah, A. M., M. S. Alam, and M. R. Bhuiyan. 2013. “Fragility analysis of retrofitted multicolumn bridge bent subjected to near-fault and far-field ground motion.” J. Bridge Eng. 18 (10): 992–1004. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000452.
Boore, D. M. 2003. “Simulation of ground motion using the stochastic method.” Pure Appl. Geophys. 160 (3): 635–676. https://doi.org/10.1007/PL00012553.
ChaiI, Y. H., M. N. Priestley, and F. Seible. 1991. “Seismic retrofit of circular bridge columns for enhanced flexural performance.” Struct. J. 88 (5): 572–584.
Chang, G. A., and J. B. Mander. 1994. Seismic energy based fatigue damage analysis of bridge columns: Part 1—Evaluation of seismic capacity. NCEER Technical Rep. No. NCEER-94. Buffalo, NY: State Univ. of New York.
Chen, S. Z., G. Wu, D. C. Feng, and L. Zhang. 2018. “Development of a bridge weigh-in-motion system based on long-gauge fiber Bragg grating sensors.” J. Bridge Eng. 23 (9): 04018063. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001283.
Filippou, F. C., V. V. Bertero, and E. P. Popov. 1983. Effects of bond deterioration on hysteretic behavior of reinforced concrete joints. Berkeley, CA: Earthquake Engineering Research Center, Univ. of California.
Galvez, P., J. P. Ampuero, L. A. Dalguer, S. N. Somala, and T. Nissen-Meyer. 2014. “Dynamic earthquake rupture modelled with an unstructured 3-D spectral element method applied to the 2011 M9 Tohoku earthquake.” Geophys. J. Int. 198 (2): 1222–1240. https://doi.org/10.1093/gji/ggu203.
HAZUS. 2010. Multi-hazard loss estimation methodology. Earthquake model, Hazus-MH MR5: Technical manual. Homeland Security Digital Library. Washington, DC: Federal Emergency Management Agency.
Hose, Y. D., M. J. N. Priestley, and F. Seible. 1997. Strategic relocation of plastic hinges in bridge columns. San Diego: Division of Structural Engineering, Univ. of California.
Hwang, H., J. B. Jernigan, and Y.-W. Lin. 2000. “Evaluation of seismic damage to Memphis bridges and highway systems.” J. Bridge Eng. 5 (4): 322–330. https://doi.org/10.1061/(ASCE)1084-0702(2000)5:4(322).
Jaradat, O. A., D. I. McLean, and M. L. Marsh. 1998. “Performance of existing bridge columns under cyclic loading—Part 1: Experimental results and observed behavior.” Struct. J. 95 (6): 695–704.
Jónsson, M. H., B. Bessason, and E. Haflidason. 2010. “Earthquake response of a base-isolated bridge subjected to strong near-fault ground motion.” Soil Dyn. Earthquake Eng. 30 (6): 447–455. https://doi.org/10.1016/j.soildyn.2010.01.001.
Kaviani, P., F. Zareian, and E. Taciroglu. 2012. “Seismic behavior of reinforced concrete bridges with skew-angled seat-type abutments.” Eng. Struct. 45: 137–150. https://doi.org/10.1016/j.engstruct.2012.06.013.
Komatitsch, D., and J. Tromp. 2002. “Spectral-element simulations of global seismic wave propagation—I. Validation.” Geophys. J. Int. 149 (2): 390–412. https://doi.org/10.1046/j.1365-246X.2002.01653.x.
Liao, W.-I., C. H. Loh, and B. H. Lee. 2004. “Comparison of dynamic response of isolated and non-isolated continuous girder bridges subjected to near-fault ground motions.” Eng. Struct. 26 (14): 2173–2183. https://doi.org/10.1016/j.engstruct.2004.07.016.
Mander, J. B., and N. Basöz. 1999. “Seismic fragility curve theory for highway bridges”. In Optimizing post-earthquake lifeline system reliability, 31–40. Reston, VA: ASCE.
Mangalathu, S. 2017. “Performance based grouping and fragility analysis of box-girder bridges in California.” Ph.D. thesis, School of Civil Engineering, Georgia Institute of Technology.
Mangalathu, S., J. S. Jeon, and R. DesRoches. 2018. “Critical uncertainty parameters influencing seismic performance of bridges using Lasso regression.” Earthquake Eng. Struct. Dyn. 47 (3): 784–801. https://doi.org/10.1002/eqe.2991.
Mangalathu, S., J.-S. Jeon, and J. Jiang. 2019. “Skew adjustment factors for fragilities of California box-girder bridges subjected to near-fault and far-field ground motions.” J. Bridge Eng. 24 (1): 04018109. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001338.
Mangalathu, S., F. Soleimani, and J.-S. Jeon. 2017. “Bridge classes for regional seismic risk assessment: Improving HAZUS models.” ”Eng. Struct. 148: 755–766. https://doi.org/10.1016/j.engstruct.2017.07.019.
Mazzoni, S., F. McKenna, M. H. Scott, and G. L. Fenves. 2006. Vol. 264 of OpenSees command language manual. Berkeley, CA: Pacific Earthquake Engineering Research Center.
McKenna, F. 2011. “OpenSees: A framework for earthquake engineering simulation.” Comput. Sci. Eng. 13 (4): 58–66. https://doi.org/10.1109/MCSE.2011.66.
Menegotto, M., and P. E. Pinto. 1973. “Method of analysis for cyclically loaded R.C. plane frames including changes in geometry and non-elastic behaviour of elements under combined normal force and bending.” In Proc., IABSE Symposium on Resistance and Ultimate Deformability of Structures Acted on by Well Defined Repeated Loads, 15–22. Final Rep., Lisbon, 1973. https://doi.org/10.5169/seals-13741.
Nielson, B. G., and R. DesRoches. 2006. “Influence of modeling assumptions on the seismic response of multi-span simply supported steel girder bridges in moderate seismic zones.” Eng. Struct. 28 (8): 1083–1092. https://doi.org/10.1016/j.engstruct.2005.12.014.
O’Reilly, G. J., and R. Monteiro. 2019. “Probabilistic models for structures with bilinear demand-intensity relationships.” Earthquake Eng. Struct. Dyn. 48 (2): 253–268. https://doi.org/10.1002/eqe.3135.
Park, S. W., H. Ghasemi, J. Shen, P. G. Somerville, W. P. Yen, and M. Yashinsky. 2004. “Simulation of the seismic performance of the Bolu Viaduct subjected to near-fault ground motions.” Earthquake Eng. Struct. Dyn. 33 (13): 1249–1270. https://doi.org/10.1002/eqe.395.
Phan, V., M. S. Saiidi, J. Anderson, and H. Ghasemi. 2007. “Near-fault ground motion effects on reinforced concrete bridge columns.” J. Struct. Eng. 133 (7): 982–989. https://doi.org/10.1061/(ASCE)0733-9445(2007)133:7(982).
Priestley, M. N., and G. Benzoni. 1996. “Seismic performance of circular columns with low longitudinal reinforcement ratios.” Struct. J. 93 (4): 474–485. https://doi.org/http://worldcat.org/oclc/13846957.
Ramanathan, K., J. S. Jeon, B. Zakeri, R. DesRoches, and J. E. Padgett. 2015. “Seismic response prediction and modeling considerations for curved and skewed concrete box-girder bridges.” Earthquakes Struct. 9 (6): 1153–1179. https://doi.org/10.12989/eas.2015.9.6.1153.
Ramanathan, K. N. 2012. Next generation seismic fragility curves for California bridges incorporating the evolution in seismic design philosophy. Atlanta: Georgia Institute of Technology.
Ranf, R. T. 2006. “Damage accumulation in lightly confined reinforced concrete bridge columns.” Berkeley, CA: Pacific Earthquake Engineering Research Center.
Rogers, L. P., and J. Seo. 2017. “Vulnerability sensitivity of curved precast-concrete I-girder bridges with various configurations subjected to multiple ground motions.” J. Bridge Eng. 22 (2): 04016118. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000973.
Schoettler, M., J. Restrepo, G. Guerrini, and D. E. Duck. 2012. A full-scale, single-column bridge bent tested by shake-table excitation. Berkeley, CA: Pacific Earthquake Engineering Research Center.
Seo, J., and D. G. Linzell. 2013. “Use of response surface metamodels to generate system level fragilities for existing curved steel bridges.” Eng. Struct. 52: 642–653. https://doi.org/10.1016/j.engstruct.2013.03.023.
Shamsabadi, A., and M. Kapuskar. 2010. “Nonlinear soil–abutment–foundation–structure interaction analysis of skewed bridges subjected to near-field ground motions.” Transp. Res. Rec. 2202 (1): 192–205. https://doi.org/10.3141%2F2202-23.
Shen, J., M. H. Tsai, K. C. Chang, and G. C. Lee. 2004. “Performance of a seismically isolated bridge under near-fault earthquake ground motions.” J. Struct. Eng. 130 (6): 861–868. https://doi.org/10.1061/(ASCE)0733-9445(2004)130:6(861).
Soleimani, F., S. Mangalathu, and R. DesRoches. 2017. “A comparative analytical study on the fragility assessment of box-girder bridges with various column shapes.” Eng. Struct. 153: 460–478. https://doi.org/10.1016/j.engstruct.2017.10.036.
Somala, S. N., S. Chanda, M. C. Raghucharan, and E. Rogozhin. 2021a. “Spectral acceleration prediction for strike, dip, and rake: A multi-layered perceptron approach.” J. Seismolog. 25 (5): 1339–1346. https://doi.org/10.1007/s10950-021-10031-2.
Somala, S. N., K. S. K. Karthik Reddy, and S. Mangalathu. 2021b. “The effect of rupture directivity, distance and skew angle on the collapse fragilities of bridges.” Bull. Earthquake Eng. 19 (14): 5843–5869. https://doi.org/10.1007/s10518-021-01208-8.
Sun, Z., M. J. N. Priestley, and F. Seible. 1993. Diagnostics and retrofit of rectangular bridge columns for seismic loads. San Diego: Dept. of Applied Mechanics and Engineering Sciences, Univ. of California.
Zhao, J., and S. Sritharan. 2007. “Modeling of strain penetration effects in fiber-based analysis of reinforced concrete structures.” ACI Mater. J. 104 (2): 133.
Information & Authors
Information
Published In
Copyright
© 2022 American Society of Civil Engineers.
History
Received: Mar 22, 2021
Accepted: Feb 4, 2022
Published online: Mar 29, 2022
Published in print: Jun 1, 2022
Discussion open until: Aug 29, 2022
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.