Fatigue Performance of Butt-Welded Tensile Plate Cable-Girder Anchorages of Long-Span Cable-Stayed Steel Box Girder Railway Bridges
Publication: Journal of Bridge Engineering
Volume 26, Issue 1
Abstract
The fatigue performance of a new type of butt-welded tensile-plate cable-girder anchorage that requires higher load-bearing capacity and lower stress concentration compared with normal tensile-plate anchorages for a long-span cable-stayed railway bridge was evaluated using a finite-element analysis and full-scale laboratory model. The test results show that the stresses remained constant over the first 2 million fatigue cycles, stress redistribution occurred at the end of the butt weld after 2.75 million cycles, and no surface cracks were observed after 3 million cycles. Anatomical milling tests found a fatigue crack originating from a microscopic welding defect in the end of the butt weld. The fatigue properties of butt welds of the anchor plate combined effect of tensile and shear forces are lower than the common butt welds. The fatigue details at two ends of the butt weld are crack vulnerable for the relative weak weldability of 40-mm-thick anchor plate. However, the measured minimum fatigue life of 2.75 million cycles (or 137.5 years) for the butt weld is larger than the bridge design requirement of 2 million cycles (or 100 years), indicating satisfied fatigue performance of the anchorage. The addition of leading and blowout plates is suggested to reduce butt weld residual stresses and defects, improving the fatigue performance of the anchorage.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This study was supported by the Major Subject of China Railway's Scientific and Technological Research and Development Program (Grant No. 2017G006-A).
References
Bujňák, J., J. Mečár, and F. Bahleda. 2019. “Tensile resistance of an anchor plate with supplementary reinforcement.” Struct. Concr. 20 (1): 164–170. https://doi.org/10.1002/suco.201800004.
CEN (European Committee for Standardization). 2005. Design of steel structures—Part 1–9: Fatigue. Eurocode 3 EN1993-1-9. Brussels, Belgium: CEN.
Chen, Y. J., R. H. Xie, W. M. Yan, Y. Li, and W. B. Xu. 2012. “Nonlinear analysis on the anchor board of the cable-girder anchorage zone of a cable-stayed bridge.” Appl. Mech. Mater. 204–208: 2080–2084. https://doi.org/10.4028/www.scientific.net/AMM.204-208.2080.
Endo, T., T. Matsumoto, and H. Tsukahara. 1995. “Fatigue of cable anchorage of large cable stayed bridge.” [In Japanese.] Proc. Jpn. Soc. Civ. Eng. 525 (1–33): 319–330. https://doi.org/10.2208/jscej.1995.525_319.
Jo, B. W., Y. J. Byun, and G. H. Tae. 2002. “Structural behavior of cable anchorage zones in prestressed concrete cable-stayed bridge.” Can. J. Civ. Eng. 29 (1): 171–180. https://doi.org/10.1139/l01-087.
Li, C., W. Ren, X. Wei, and S. Qiang. 2009. “Full scale model test on tensile anchor plates in cable-girder anchorage of Guangzhou Dongsha Bridge.” In Proc., 2nd Int. Conf. on Transportation Engineering, edited by Q. Peng, K. C. P. Wang, Y. Qiu, Y. Pu, X. Luo, and B. Shuai, 2261–2266. Reston, VA: ASCE.
Li, X., J. Cai, and S. Qiang. 2004. “Studies on models of cable-girder anchorage for long-span cable-stayed bridges with steel box girder.” [In Chinese.] China Civ. Eng. J. 37 (3): 73–79.
Lin, C. H., K. C. Lin, K. C. Tsai, S. J. Jhuang, M. L. Lin, J. C. Chen, P. C. Chen, K. J. Wang, and S. L. Lin. 2012. “Full-scale fatigue tests of a cable-to-orthotropic bridge deck connection.” J. Constr. Steel Res. 70 (1): 264–272. https://doi.org/10.1016/j.jcsr.2011.08.017.
Liu, Y., H. Xin, and Y. Liu. 2018. “Load transfer mechanism and fatigue performance evaluation of suspender-girder composite anchorage joints at serviceability stage.” J. Constr. Steel Res. 145 (6): 82–96. https://doi.org/10.1016/j.jcsr.2018.02.010.
Man, H., and X. Yang. 2011. “Experiment and theoretical research on cable-girder anchorage structure of long span steel cable-stayed bridges.” In Condition, Reliability, and Resilience Assessment of Tunnels and Bridges, Geotechnical Special Publication 214, edited by S. E. Chen, W. F. Lee, H. Fu, and K. Dai, 34–39. Reston, VA: ASCE.
MRPRC (Ministry of Railways of the People’s Republic of China). 2017. Code for design of steel structure of railway bridge. TB 10091–2017. Beijing: China Railway Press.
Nie, J. G., M. Zhou, Y. H. Wang, J. S. Fan, and M. X. Tao. 2014. “Cable anchorage system modeling methods for self-anchored suspension bridges with steel box girders.” J. Bridge Eng. 19 (2): 172–185. https://doi.org/10.1061/(ASCE)BE.1943-5592.0000529.
Pedersen, M. M. 2019. “Thickness effect in fatigue of welded butt joints: A review of experimental works.” Int. J. Steel Struct. 19 (6): 1930–1938. https://doi.org/10.1007/s13296-019-00254-y.
Wang, Y., Z. Wang, X. Wei, and S. Qiang. 2013. “Test and FE analysis of gusset plate anchorage for cable-stayed bridges.” Stahlbau 82 (4): 313–321. https://doi.org/10.1002/stab.201320038.
Wei, X., and J. Li. 2011. “Theoretical and experimental study on cable-to-girder anchorages in long-span cable-stayed bridges with steel box girder.” Adv. Mater. Res. 255–260: 1315–1318. https://doi.org/10.4028/www.scientific.net/AMR.255-260.1315.
Wei, X., L. Xiao, and Z. Wang. 2018. “Full-scale specimen testing and parametric studies on tensile-plate cable-girder anchorages in cable-stayed bridges with steel girders.” J. Bridge Eng. 23 (4): 04018006. https://doi.org/10.1061/(ASCE)BE.1943-5592.0001193.
Zhang, D., Q. Gao, B. Liu, X. Li, and L. Xiao. 2012. “Experiment study of fatigue loading on cable-girder anchorage of cable-stayed bridge.” Int. J. Eng. Technol. 4 (6): 493–494. https://doi.org/10.7763/IJET.2012.V4.464.
Zhao, M., and J. Di. 2014. “Fatigue load for cable-girder anchorage structure of highway and light-railway cable stayed bridge.” Adv. Mater. Res. 838–841: 1028–1033. https://doi.org/10.4028/www.scientific.net/AMR.838-841.1028.
Zhong, N., W. Zhuang, and Y. Wang. 2013. “The Jiangjin Guanyinyan Yangtze River Bridge, China.” Struct. Eng. Int. 23 (1): 80–84. https://doi.org/10.2749/101686613X13439149157326.
Information & Authors
Information
Published In
Copyright
© 2020 American Society of Civil Engineers.
History
Received: Dec 19, 2019
Accepted: Jul 17, 2020
Published online: Oct 23, 2020
Published in print: Jan 1, 2021
Discussion open until: Mar 23, 2021
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.