Infrasound-Based Noncontact Sensing for Bridge Structural Health Monitoring
Publication: Journal of Bridge Engineering
Volume 24, Issue 5
Abstract
This study demonstrates the use of infrasound measurements from microphones as a means of noncontact sensing to capture the dynamic properties of structures for structural health monitoring (SHM). A pilot study using an in-service highway bridge in Connecticut is conducted to compare infrasound and accelerometer-based SHM using a frequency domain peak-picking method. A three-dimensional finite-element (FE) model is developed to validate the results. Potential benefits and limitations of infrasound-based SHM are discussed. An attention model from machine learning is further proposed to increase the signal-to-noise ratio of the microphone measurements and provide an unbiased rapid means of identifying the modal frequencies of the bridge.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
The authors would like to acknowledge the support of the Connecticut DOT (SPR-2265, SPR-2271, and SPR-2290); the College of Science and Engineering and the School of Engineering of San Francisco State University; and the efforts of numerous employees at the Connecticut DOT, in particular Anne-Marie McDonnell and Paul Dattilio. The opinions, findings, and conclusions expressed in the publication are those of the authors and not necessarily those of the Connecticut DOT or the Federal Highway Administration.
References
Andersen, P., R. Brincker, B. Peeters, G. De Roeck, L. Hermans, and C. Krämer. 1999. “Comparison of system identification methods using ambient bridge test data.” In Proc., 17th Int. Modal Analysis Conf., 1035–1041. Aalborg, Denmark: Society for Experimental Mechanics.
Balageas, D. 2006. Introduction to structural health monitoring, 13–43. London: ISTE.
Behnia, A., H. K. Chai, and T. Shiotani. 2014. “Advanced structural health monitoring of concrete structures with the aid of acoustic emission.” Constr. Build. Mater. 65 (Aug): 282–302. https://doi.org/10.1016/j.conbuildmat.2014.04.103.
Bendat, J. S., and A. G. Piersol. 2011. Random data: Analysis and measurement procedures. Hoboken, NJ: John Wiley & Sons.
Cha, Y. J., W. Choi, and O. Büyüköztürk. 2017. “Deep learning-based crack damage detection using convolutional neural networks.” Computer-Aided Civ. Infrastruct. Eng. 32 (5): 361–378. https://doi.org/10.1111/mice.12263.
Chanpheng, T., H. Yamada, T. Miyata, and H. Katsuchi. 2004. “Application of radiation modes to the problem of low-frequency noise from a highway bridge.” Appl. Acoust. 65 (2): 109–123. https://doi.org/10.1016/j.apacoust.2003.08.002.
Christenson, R. E., and S. Motaref. 2016. Dual purpose bridge health monitoring and weight-in-motion (BWIM)–Phase I. Research Rep. No. CT-2265-F-15-7. Newington, CT: Connecticut DOT.
Elliott, S. J., and M. E. Johnson. 1993. “Radiation modes and the active control of sound power.” J. Acoust. Soc. Am. 94 (4): 2194–2204. https://doi.org/10.1121/1.407490.
Farrar, C. R., and G. H. James, III. 1997. “System identification from ambient vibration measurements on a bridge.” J. Sound Vib. 205 (1): 1–18. https://doi.org/10.1006/jsvi.1997.0977.
Farshidi, R., D. Trieu, S. S. Park, and T. Freiheit. 2010. “Non-contact experimental modal analysis using air excitation and a microphone array.” Measurement 43 (6): 755–765. https://doi.org/10.1016/j.measurement.2010.02.004.
Fukada, S., H. Hama, and K. Usui. 2012. “Relation of the infrasound characteristics and the continuous steel bridge vibration modes generated by the vibration of moving heavy trucks.” J. Mod. Transp. 20 (3): 185–196. https://doi.org/10.1007/BF03325797.
Gentile, C., and G. Bernardini. 2010. “An interferometric radar for non-contact measurement of deflections on civil engineering structures: Laboratory and full-scale tests.” Struct. Infrastruct. Eng. 6 (5): 521–534. https://doi.org/10.1080/15732470903068557.
Goroumaru, H., K. Shiraishi, H. Hara, and T. Komori. 1987. “Prediction of low frequency noise radiated from vibrating highway bridges.” J. Low Freq. Noise Vibr. Act. Control 6 (4): 155–166. https://doi.org/10.1177/026309238700600403.
Hama, H., S. Fukada, K. Usui, Y. Kajikawa, and T. Matsuda. 2010. “Infrasound and ground vibration transmitted from highway bridge using moving trucks.” In Proc., 20th Int. Congress on Acoustics. Sydney, Australia: ICA.
Han, Q., J. Xu, A. Carpinteri, and G. Lacidogna. 2015. “Localization of acoustic emission sources in structural health monitoring of masonry bridge.” Struct. Control Health Monit. 22 (2): 314–329. https://doi.org/10.1002/stc.1675.
Imaichi, K., Y. Tsujimoto, and S. Takabatake. 1982. “Theoretical analysis of infrasound radiation from an oscillating bridge.” J. Sound Vib. 81 (4): 453–468. https://doi.org/10.1016/0022-460X(82)90289-9.
Kohut, P., K. Holak, T. Uhl, Ł. Ortyl, T. Owerko, P. Kuras, and R. Kocierz. 2013. “Monitoring of a civil structure’s state based on noncontact measurements.” Struct. Health Monit. 12 (5–6): 411–429. https://doi.org/10.1177/1475921713487397.
Kolev, V., R. E. Christenson, S. Motaref, and S. Jang. 2016. Development and evaluation of a dual purpose bridge health monitoring and weigh-in-motion system for a steel girder bridge–Phase II. Research Rep. No. CT-2271-F-15-10. Newington, CT: Connecticut DOT.
Kong, X., and J. Li. 2018. “Vision‐based fatigue crack detection of steel structures using video feature tracking.” Computer-Aided Civ. Infrastruct. Eng. 13 (9): 783–799.
Li, J. 2014. “Structural health monitoring of an in-service highway bridge with uncertainties.” Doctoral dissertation, Univ. of Connecticut.
Li, Q., Y. L. Xu, and D. J. Wu. 2012. “Concrete bridge-borne low-frequency noise simulation based on train–track–bridge dynamic interaction.” J. Sound Vib. 331 (10): 2457–2470. https://doi.org/10.1016/j.jsv.2011.12.031.
Lobo-Aguilar, S., R. Christenson, S. Jang, J. Li, and S. Park. 2017. Infrasound-based structural health monitoring of an in-service highway bridge. No. 17-06115. Washington, DC: Transportation Research Board.
Lu, Z. L. 2008. “Mechanisms of attention: Psychophysics, cognitive psychology, and cognitive neuroscience (Mechanisms of attention-Psychophysics, cognitive psychology, and cognitive neuroscience. Invited Lecture at the 26th Annual Meeting).” Jpn. J. Psychonom. Sci. 27 (1): 38–45.
Luong, M. T., H. Pham, and C. D. Manning. 2015. “Effective approaches to attention-based neural machine translation.” Preprint submitted on August 17, 2015. https://arxiv.org/abs/1508.04025.
MathWorks. 2018. “Welch’s method.” Accessed May 1, 2018. https://www.mathworks.com/examples/signal/mw/signal-ex45136368-welch-s-method.
Mufti, A. A., B. Bakht, G. Tadros, A. T. Horosko, and G. Sparks. 2005. “Are civil structural engineers ‘risk averse’? Can civionics help?” In Sensing issues in civil structural health monitoring, 3–12. Dordrecht, Netherlands: Springer.
Nassif, H. H., M. Gindy, and J. Davis. 2005. “Comparison of laser Doppler vibrometer with contact sensors for monitoring bridge deflection and vibration.” NDT & E Int. 38 (3): 213–218. https://doi.org/10.1016/j.ndteint.2004.06.012.
Plude, S., S. Prusaczyk, A. Scianna, Z. Jiang, R. E. Christenson, J. H. Kim, and J. T. DeWolf. 2014. Connecticut permanent long-term bridge monitoring network Vol. 3: Monitoring of a multi-steel girder composite bridge–I-91 SB over the Mattabesset River in Cromwell (Bridge# 3078). No. CT-2256-4-13-5. Newington, CT: Connecticut DOT.
Poozesh, P., K. Aizawa, C. Niezrecki, J. Baqersad, M. Inalpolat, and G. Heilmann. 2017. “Structural health monitoring of wind turbine blades using acoustic microphone array. Structural.” Struct. Health Monit. 16 (4): 471–485. https://doi.org/10.1177/1475921716676871.
Raichel, D. R. 2006. The science and applications of acoustics. New York: Springer Science & Business Media.
Rice, J. A., and B. F. Spencer, Jr. 2009. Flexible smart sensor framework for autonomous full-scale structural health monitoring. Urbana, IL: Univ. of Illinois at Urbana-Champaign.
Rothberg, S. J., et al. 2017. “An international review of laser Doppler vibrometry: Making light work of vibration measurement.” Opt. Lasers Eng. 99 (Dec): 11–22. https://doi.org/10.1016/j.optlaseng.2016.10.023.
Scianna, A., S. Prusaczyk, Z. Jiang, R. E. Christenson, and J. T. DeWolf. 2014a. Connecticut permanent long-term bridge monitoring network Vol. 1: Monitoring of post-tensioned segmental concrete box-girder bridge–I-95 over the Connecticut River in Old Saybrook (Bridge# 6200). CT-2256-2-13-2. Newington, CT: Connecticut DOT.
Scianna, A., S. Prusaczyk, Z. Jiang, R. E. Christenson, and J. T. DeWolf. 2014b. Connecticut permanent long-term bridge monitoring network Vol. 4: Monitoring of curved steel box-girder composite bridge–I-84 EB flyover to I-91 NB in Hartford (Bridge# 5868). CT-2256-5-13-6. Newington, CT: Connecticut DOT.
Scianna, A., S. Prusaczyk, Z. Jiang, R. E. Christenson, J. T. DeWolf, and J. H. Kim. 2014c. Connecticut permanent long-term bridge monitoring network Vol. 2: Monitoring of curved post-tensioned concrete box-girder bridge–I-384 WB over I-84 in East Hartford (Bridge# 5686). CT-2256-3-13-4. Newington, CT: Connecticut DOT.
Sohn, H. 2004. A review of structural health monitoring literature: 1996–2001. Los Alamos National Laboratory Rep. Los Alamos, NM: Los Alamos National Laboratory.
Stollenga, M. F., J. Masci, F. Gomez, and J. Schmidhuber. 2014. “Deep networks with internal selective attention through feedback connections.” In Advances in neural information processing systems, 3545–3553. Red Hook, NY: Curran Associates, Inc.
Xu, K., J. Ba, R. Kiros, K. Cho, A. Courville, R. Salakhudinov, R. Zemel, and Y. Bengio. 2015. “Show, attend and tell: Neural image caption generation with visual attention.” In Vol. 37 of Proc., Int. Conf. on Machine Learning, 2048–2057. Lille, France: International Conference on Machine Learning.
Yang, Y., C. Dorn, T. Mancini, Z. Talken, G. Kenyon, C. Farrar, and D. Mascareñas. 2017. “Blind identification of full-field vibration modes from video measurements with phase-based video motion magnification.” Mech. Syst. Signal Process. 85 (Feb): 567–590. https://doi.org/10.1016/j.ymssp.2016.08.041.
Yeum, C. M., and S. J. Dyke. 2015. “Vision‐based automated crack detection for bridge inspection.” Computer-Aided Civ. Infrastruct. Eng. 30 (10): 759–770. https://doi.org/10.1111/mice.12141.
Yoon, H., H. Elanwar, H. Choi, M. Golparvar-Fard, and B. F. Spencer. 2016. “Target‐free approach for vision‐based structural system identification using consumer‐grade cameras.” Struct. Control Health Monit. 23 (12): 1405–1416. https://doi.org/10.1002/stc.1850.
Zaki, A., H. K. Chai, D. G. Aggelis, and N. Alver. 2015. “Non-destructive evaluation for corrosion monitoring in concrete: A review and capability of acoustic emission technique.” Sensors 15 (8): 19069–19101. https://doi.org/10.3390/s150819069.
Information & Authors
Information
Published In
Copyright
© 2019 American Society of Civil Engineers.
History
Received: May 3, 2018
Accepted: Oct 25, 2018
Published online: Mar 8, 2019
Published in print: May 1, 2019
Discussion open until: Aug 8, 2019
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.