Fatigue Performance of a Lightweight Composite Bridge Deck with Open Ribs
Publication: Journal of Bridge Engineering
Volume 21, Issue 7
Abstract
An innovative lightweight composite deck (LWCD) is proposed for steel bridges to avoid premature fatigue cracking. The composite deck is composed of an open-ribbed orthotropic steel deck (OSD) and a thin ultrahigh-performance concrete (UHPC) layer. This study is based on a suspension steel bridge in China, namely, the Second Dongting Lake Bridge. The following investigations were performed: (1) preliminary finite-element analysis (FEA) was carried out to evaluate the vehicle-induced stress ranges (i.e., Δσ = σmax − σmin) of six typical fatigue-prone details; (2) parameter analyses were performed to investigate the effects of the shape of cutouts and the thickness of the floor beams; and (3) two fatigue tests, one that used a full-scale LWCD panel and another that used a LWCD beam specimen, were conducted to reveal fatigue performance of the OSD and the stud shear connectors, respectively. Results of the preliminary FEA show that, with the contribution of the UHPC layer, the vehicle-induced stress ranges at some fatigue details of the LWCD, such as the rib–deck plate welded joints and the splice welds of the longitudinal ribs, were reduced to be less than their constant-amplitude fatigue limits, which indicates theoretically infinite fatigue lives of these details. The parameter analyses reveal that the apple-shaped cutout had relative good fatigue properties among the four cutout schemes and that the thickness of the floor beams is recommended to be 14–18 mm. According to the fatigue tests on the composite panel specimen and on the composite beam specimen, both the open-ribbed OSD and the stud shear connectors exhibited satisfactory fatigue endurances, which were much greater than 2 million cycles. The current theoretical and experimental investigations reveal that the proposed open-ribbed LWCD has favorable fatigue performances.
Get full access to this article
View all available purchase options and get full access to this article.
Acknowledgments
This research was supported by the National Natural Science Foundation of China (51178177) and the Transportation Science and Technology Major Project sponsored by the Ministry of Transport of China (2011318494160). These programs are gratefully acknowledged.
References
Abaqus 6.14 [Computer software]. Dassault Systèmes, Waltham, MA.
ANSYS 14.0 [Computer software]. ANSYS, Canonsburg, PA.
Aygül, M., Al-Emrani, M., and Urushadze, S. (2012). “Modelling and fatigue life assessment of orthotropic bridge deck details using FEM.” Int. J. Fatigue, 40, 129–142.
Behloul, M., and Chanvillard, G. (2005). “Fatigue flexural behavior of pre-cracked specimens of special UHPFRC.” Proc., Seventh Int. Symp. on the Utilization of High Strength/High-Performance Concrete, American Concrete Institute, Farmington Hills, MI.
Cao, J. H., Shao, X. D., Zhang, Z., and Zhao, H. (2015). “Retrofit of an orthotropic steel deck with compact reinforced reactive powder concrete.” Struct. Infrastruct. Eng., 12(3), 411–429.
Chen, B., Zhong, Z., Xie, X.,Wang, J. W., and Lu, P. Z. (2014). “Site-specific fatigue load spectrum for urban bridges.” 14th COTA Int. Conf. of Transportation Professionals, ASCE, New York, 1051–1060.
Connor, R. J. (2004). “Influence of cutout geometry on stresses at welded rib-to-diaphragm connections in steel orthotropic bridge decks.” Transportation Research Board, 1892, 78–87.
Connor, R. J., and Fisher J. W. (2006). “Consistent approach to calculating stresses for fatigue design of welded rib-to-web connections in steel orthotropic bridge decks.” J. Bridge Eng., 517–525.
Ding, N., and Shao, X. D. (2015). “Study on fatigue performance of light-weighted composite bridge deck.” China Civ. Eng. J., 48(1), 74–81 (in Chinese).
ECS (European Committee for Standardization). (2003). “Eurocode 1: Actions on structure—Part 2: Traffic loads on bridges.” EN 1991-2, Brussels, Belgium.
ECS (European Committee for Standardization). (2004). “Eurocode 4: Design of composite steel and concrete structures—Part 1-1: General rules and rules for buildings.” EN 1993-1-1, Brussels, Belgium.
ECS (European Committee for Standardization). (2005). “Eurocode 3: Design of steel structures—Part 1-9: Fatigue.” EN1993-1-9, Brussels, Belgium.
Erzurumlu, H., and Toprac, A. A. (1972). “Fatigue of orthotropic bridge deck.” J. Struct. Div., 98(4), 813–830.
Farhat, F. A., Nicolaides, D., Kanellopoulos, A., and Karihaloo, B. L. (2007). “High performance fibre-reinforced cementitious composite (CARDIFRC)—Performance and application to retrofitting.” Eng. Fract. Mech., 74(1–2), 151–167.
Fricke, W. (2003). “Fatigue analysis of welded joints: State of development.” Mar. Struct., 16(3), 185–200.
Frýba, L., and Gajdos, L. (1999). “Fatigue properties of orthotropic decks on railway bridges.” Eng. Struct., 21(7), 639–652.
Hobbacher, A. (2008). Recommendations for fatigue design of welded joints and component (XIII-2151r4-07/XV-1254r4-07). Springer International, Cham, Switzerland.
Jong, F. B. P. (2004). “Overview fatigue phenomenon in orthotropic bridge decks in the Netherlands.” Proc., 1st Int. Orthotropic Bridge Conf., ASCE, New York, 489–512.
Lappa, E. S. (2007). “High strength fibre reinforced concrete: Static and fatigue behavior in bending.” Ph.D. dissertation, Delft Univ. of Technology, Delft, Netherlands.
Li, J., Yang, B., Shao, X. D., and Li, J. (2015). “Shear fatigue performance of studs of composite deck system composed of steel and super toughness concrete layers.” China Civ. Eng. J. (in Chinese), in press.
Liu, R., Liu, Y. Q., Ji, B. H., Wang, M., and Tian, Y. (2014). “Hot spot stress analysis on rib-deck welded joint in orthotropic steel decks.” J. Constr. Steel Res., 97, 1–9.
Makita, T., and Brühwiler, E. (2014). “Tensile fatigue behaviour of ultra-high performance fibre reinforced concrete combined with steel rebars (R-UHPFRC).” Int. J. Fatigue, 59(3), 145–152.
Ouyang, Z. H., Zhang, S. H., Shao, X. D., Cao, J. H., Li, Z. H., and Peng B. (2014). “Static and fatigue tests on light-weighted composite bridge deck with open and closed ribs in Dongting Lake Bridge.” Dept. of Bridge Engineering, Hunan Univ., Changsha, China, 1–127 (in Chinese).
Parant, E., Rossi, P., and Boulay, C. (2007). “Fatigue behavior of a multi-scale cement composite.” Cem. Concr. Res., 37(2), 264–269.
Shao, X. D., Yi, D. T., Huang, Z. Y., Zhao, H., and Chen, B. (2013). “Basic performance of the composite deck system composed of orthotropic steel deck and ultrathin RPC Layer.” J. Bridge Eng., 417–428.
Song, Y. P. (2006). Fatigue behavior and design principle of concrete structures. China Machine Press, Beijing (in Chinese).
Tang, L., Huang, L. J., Wang, X. W., and Liu, G. (2014). “Analysis of stress in U-rib-diaphragm joints of steel deck.” J. Highway Transp. Res. Dev., 31(5), 93–101 (in Chinese).
Wolchuk, R. (1999). “Steel orthotropic decks: Developments in the 1990s.” Transportation Research Board, 30–37.
Wolchuk, R., and Ostapenko, A. (1992). “Secondary stresses in closed orthotropic deck ribs at floor beams.” J. Struct. Eng., 582–595.
Xiao, Z. G., Yamada, K., Ya, S., and Zhao, X. L. (2008). “Stress analyses and fatigue evaluation of rib-to-deck joints in steel orthotropic decks.” Int. J. Fatigue, 30(8), 1387–1397.
Yang, J. (2007). “Flexural behavior of ultra-high performance concrete beams prestressed with CFRP tendons.” Ph.D. dissertation, Hunan Univ., Changsha, China (in Chinese).
Zhang, B. (2011). “Research on structural behavior of orthotropic deck with open-shaped ribs of steel truss bridge.” Master dissertation, Tianjin Univ., Tianjin, China (in Chinese).
Information & Authors
Information
Published In
Copyright
© 2016 American Society of Civil Engineers.
History
Received: Jun 4, 2015
Accepted: Dec 10, 2015
Published online: Feb 19, 2016
Published in print: Jul 1, 2016
Discussion open until: Jul 19, 2016
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.