Measurement of Local Deformations in Steel Monostrands Using Digital Image Correlation
Publication: Journal of Bridge Engineering
Volume 19, Issue 10
Abstract
The local deformation mechanisms in steel monostrands have a significant influence on their fatigue life and failure mode. However, the observation and quantification of deformations in monostrands experiencing axial and transverse deformations is challenging because of their complex geometry, difficulties with the placement of strain gauges in the vicinity of the anchorage, and, most importantly, the relatively small magnitude of deformation occurring in the monostrand. This paper focuses on the measurement of localized deformations in high-strength steel monostrands using the digital image correlation (DIC) technique. The presented technique enables the measurement of individual wire strains along the length of the monostrand and also provides quantitative information on the relative movement between individual wires, leading to a more in-depth understanding of the underlying fatigue mechanisms. To validate the proposed image-based measurement method, two different tests were performed, with the one correlation method showing good agreement. Data collected from the DIC technique creates a basis for the analysis of the fretting and localized bending behavior of the monostrand and provides relevant information on the internal state of displacement of the monostrand under bending load.
Get full access to this article
View all available purchase options and get full access to this article.
References
ARAMIS 6.1 [Computer software]. Braunschweig, Germany, Mittelweg.
Bales, F. B. (1985). “Close-range photogrammetry for bridge measurement.” Transp. Res. Rec., 950(1), 39–44.
Busca, G., Cigada, A., Mazzoleni, P., Zappa, E., and Franzi, M. (2012). “Cameras as displacement sensors to get the dynamic motion of a bridge: Performance evaluation against traditional approaches.” Proc., 6th Int. Conf. on Bridge Maintenance, Safety and Management, Taylor & Francis, London.
Camera Control Pro 2.11.0 [Computer software]. Tokyo, Nikon.
Chiang, C., Shih, M., Chen, W., and Yu, C. (2011) “Displacement measurements of highway bridges using digital image correlation methods.” Proc. SPIE, 8321(1), 83211G.
De Roover, C., Vantomme, J., Wastiels, J., and Taerwe, L. (2002). “Deformation analysis of a modular connection system by digital image correlation.” Exp. Tech., 26(6), 37–40.
DxO Optics Pro 8.1.3 [Computer software]. Boulogne-Billancourt, France, DxO Labs.
Gimsing, N. J., and Georgakis, C. T. (2012). Cable supported bridges: Concept and design, 3rd Ed., Wiley, Hoboken, NJ, 544–547.
Gourmelon, J. P. (2002). “Fatigue of staying cables, organisation and results of the research programme.” Bulletin 84, International Organisation for the Study of the Endurance of Ropes, Reading, U.K., 21–39.
Hikami, Y., and Shiraishi, N. (1988). “Rain–wind induced vibrations of cables in cable stayed bridges.” J. Wind Eng. Ind. Aerodyn., 29(1–3), 409–418.
Hobbs, R. E., and Raoof, M. (1994). “Mechanism of fretting fatigue in steel cables.” Int. J. Fatigue, 16(4), 273–280.
Hobbs, R. E., and Raoof, M. (1996). “Behaviour of cables under dynamic or repeated loading.” J. Constr. Steel Res., 39(1), 31–50.
Jauregui, D. V., White, K. R., Woodward, P. E., and Leitch, K. R. (2003). “Noncontact photogrammetric measurement of vertical bridge deflection.” J. Bridge Eng., 212–222.
Johnson, G. W. (2001). “Digital close-range photogrammetry: A portable measurement tool for public works.” Proc., 2001 Coordinate Measurement Systems Committee Conf., Coordinate Measurement Systems Committee, Benbrook, TX.
Kim, S., and Kim, N. (2013). “Dynamic characteristics of suspension bridge hanger cables using digital image processing.” NDT Int., 59, 25–33.
Küntz, M., Jolin, M., Bastien, J., Perez, F., and Hild, F. (2006). “Digital image correlation analysis of crack behavior in a reinforced concrete beam during a load test.” Can. J. Civ. Eng., 33(11), 1418–1425.
Lee, J. J., and Shinozuka, M. (2006a). “A vision-based system for remote sensing of bridge displacement.” NDT Int., 39(5), 425–431.
Lee, J. J., and Shinozuka, M. (2006b). “Real-time displacement measurement of a flexible bridge using digital image processing techniques.” Exp. Mech., 46(1), 105–114.
Li, J. C., and Yuan, B. Z. (1988). “Using vision technique for bridge deformation detection.” Proc., Int. Conf. on Acoustic, Speech and Signal Processing, Vol. 2, IEEE, New York, 912–915.
Malesa, M., Szczepanek, D., Kujawińska, M., Świercz, A., and Kołakowski, P. (2010). “Monitoring of civil engineering structures using digital image correlation technique.” Proc., 14th Int. Conf. on Experimental Mechanics, Vol. 6, EDP Sciences, Les Ulis Cedex A, France.
Miki, C., Endo, T., and Okukawa, A. (1992). “Full-size fatigue test of bridge cables: Length effect on fatigue of wires and strands.” Int. Association for Bridge and Structural Engineering Rep., International Association for Bridge and Structural Engineering, Zurich, 66, 167–178.
Nonis, C., Niezrecki, C., Yu, T., Ahmed, S., Su, C., and Schmidt, T. (2013). “Structural health monitoring of bridges using digital image correlation.” Proc. SPIE, 8695, 869507.
Papailiou, K. O. (1997). “On the bending stiffness of transmission line conductors.” IEEE Trans. Power Deliv., 12(4), 1576–1588.
Prato, C. A., and Ceballos, M. A. (2003). “Dynamic bending stresses near the ends of parallel-bundle stay cables.” Struct. Eng. Int., 13(1), 64–68.
Raoof, M. (1991). “Methods for analysing large spiral strands.” J. Strain Anal. Eng. Des., 26(3), 165–174.
Raoof, M., and Huang, Y. P. (1992). “Free bending characteristics of axially preloaded spiral strands.” Proc. ICE Struct. Build., 94(4), 469–484.
Rodríguez, G., and Olabarrieta, C. J. (2010). “Fatigue testing with transverse displacements in stay cable systems.” Proc., 3rd Fédération Internationale du Béton/International Federation for Structural Concrete (FIB) Int. Congress, Precast/Prestressed Concrete Institute, Chicago, 138.
Santini-Bell, E., Brogan, P., Lefebvre, P., Peddle, J., Brenner, B., and Sanayei, M. (2011). “Digital imaging for bridge deflection measurement of a steel girder composite bridge.” Proc., Transportation Research Board 90th Annual Meeting, Transportation Research Board, Washington, DC.
Sas, G., Blanksvärd, T., Enochsson, O., Täljsten, B., and Elfgren, L. (2012). “Photographic strain monitoring during full-scale failure testing of Örnsköldsvik bridge.” Struct. Health Monit., 11(4), 489–498.
Savor, Z., Radic, J., and Hrelja, G. (2006). “Cable vibrations at Dubrovnik bridge.” Bridge Struct., 2(2), 97–106.
Siegert, D., and Brevet, P. (2005). “Fatigue of stay cables inside end fittings: High frequencies of wind induced vibrations.” Bulletin 89, International Organisation for the Study of the Endurance of Ropes, Reading, U.K., 43–51.
Wang, D., Zhang, D., and Ge, S. (2011). “Fretting–fatigue behavior of steel wires in low cycle fatigue.” Mater. Des., 32(10), 4986–4993.
Waterfall, P. M., Macdonald, J. H. G., and McCormick, N. J. (2012). “Targetless precision monitoring of road and rail bridges using video cameras.” Proc., 6th Int. Conf. on Bridge Maintenance, Safety, Management, Resilience and Sustainability, F. Biondini and D. M. Frangopo, eds., Taylor & Francis, London, 3976–3983.
Winkler, J., Fischer, G., Georgakis, C. T., and Kotas, A. (2011). “A preliminary bending fatigue spectrum for steel monostrand cables.” J. Int. Assoc. Space Struct., 52(4), 249–255.
Wood, S., and Frank, K. H. (2010). “Experimental investigation of bending fatigue response of grouted stay cables.” J. Bridge Eng., 123–130.
Woodham, R. J. (1981). “Analysing images of curved surfaces.” Artif. Intell., 17(1–3), 117–140.
Wyatt, T. A. (1960). “Secondary stress in parallel wire suspension cables.” J. Struct. Div., 86(7), 37–59.
Yoneyama, S., Kitagawa, A., Iwata, S., Tani, K., and Kikuta, H. (2007). “Bridge deflection measurement using digital image correlation.” Exp. Tech., 31(1), 34–40.
Yoneyama, S., and Ueda, H. (2012). “Bridge deflection measurement using digital image correlation with camera movement correction.” Mater. Trans., 53(2), 285–290.
Information & Authors
Information
Published In
Copyright
© 2014 American Society of Civil Engineers.
History
Received: Feb 7, 2013
Accepted: Feb 24, 2014
Published online: Mar 26, 2014
Discussion open until: Aug 26, 2014
Published in print: Oct 1, 2014
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.