Experimental Study on Repair Methods of Corroded Bridge Cables
Publication: Journal of Bridge Engineering
Volume 17, Issue 4
Abstract
The cables and hangers of old suspension bridges and the stays of cable-stayed bridges often suffer from steel corrosion. It is important to repair them by proper methods to prevent the further progression of corrosion. In this paper six repair methods were proposed and applied to cable specimens. Then, the specimens were exposed to severe corrosion environments and the effectiveness of the proposed repair methods was compared. Two different types of test cables were used in this study: parallel wire strands and spiral strands. The first test group used parallel wire strand cables consisting of 19 nongalvanized steel wires. This test was aimed at the main cables of the suspension bridges. Six repair methods were applied to these cable specimens: coating with zinc-rich paint, coating with epoxy resin paint, coating with zinc powder paste, filling with epoxy resin, filling with oil, and a dehumidification method. Then, the specimens were accelerated to corrode in a laboratory for 15 months. By investigating the mass loss owing to corrosion and appearance during this period, the effectiveness of the six repair methods was compared. For the surface wires, the dehumidification method was the most effective followed by the epoxy resin paint and filling, the zinc powder paste, and the zinc and epoxy resin paint on the surface. The oil filling was not very effective compared with other repair methods. The corrosion of the inside wires was much less than for the surface wires. The second group test used spiral strand cables consisting of seven galvanized steel wires. This test was aimed at the hangers of suspension bridges and the stays of cable-stayed bridges. The same repair methods and corrosion acceleration methods were used. By investigating the mass loss owing to corrosion and the appearance of both inside and surface wires during the 16-month period, most of the proposed repair methods were very effective compared with those of unrepaired strands. This study proves that even if cables are corroded proper repair work is effective in preventing further corrosion.
Get full access to this article
View all available purchase options and get full access to this article.
References
Betti, R., West, A. C., Vermaas, G., and Cao, Y. (2005). “Corrosion and embrittlement in high-strength wires of suspension bridge cables.” J. Bridge Eng., 10(2), 151–162.JBENF2
Betti, R., and Yanev, B. (1999). “Conditions of suspension bridge cables: The New York City case study.” Transportation Research Record 1654, Transportation Research Board, Washington, DC, 105–112.
Furuya, K., Kitagawa, M., Nakamura, S., and Suzumura, K. (2000). “Corrosion mechanism and protection methods for suspension bridge cables.” Struct. Eng. Int. (IABSE, Zurich, Switzerland), 10(3), 189–193.
Mayrbaurl, R. (2000). “Corrosion in suspension bridge cables.” Proc., Congress, Int. Association of Bridge and Structural Engineers, Lucerne, Switzerland, Paper No. 199.
Mayrbaurl, R., and Camo, S. (2001). “Cracking and fracture of suspension bridge wires.” J. Bridge Eng., 6(6), 645–650.JBENF2
Nakamura, S., and Suzumura, K. (2006). “Fatigue and Fracture of Corroded Bridge Wires.” Proc., 1st Int. Conf. on Fatigue and Fracture in the Infrastructure, Philadelphia, Lehigh Univ., Bethlehem, PA.
Nakamura, S., and Suzumura, K. (2009). “Hydrogen embrittlement and corrosion fatigue of bridge wires.” J. Constr. Steel Res., 65(2), 269–277.JCSRDL
Nakamura, S., Suzumura, K., and Tarui, T. (2004). “Mechanical properties and remaining strength of corroded bridge wires.” Struct. Eng. Int. (IABSE, Zurich, Switzerland), 14(1), 50–54.
Stahl, F. L., and Gagnon, C. P. (1996). Cable corrosion, ASCE, New York.
Suzumura, K., and Nakamura, S. (2004). “Environmental factors affecting corrosion of galvanized steel wires.” J. Mater. Civ. Eng., 16(1), 1–7.JMCEE7
Information & Authors
Information
Published In
Journal of Bridge Engineering
Volume 17 • Issue 4 • July 2012
Pages: 720 - 727
Copyright
© 2012. American Society of Civil Engineers.
History
Received: May 3, 2011
Accepted: Aug 18, 2011
Published online: Aug 20, 2011
Published in print: Jul 1, 2012
Authors
Metrics & Citations
Metrics
Citations
Download citation
If you have the appropriate software installed, you can download article citation data to the citation manager of your choice. Simply select your manager software from the list below and click Download.